2003 CADILLAC CTS engine

2-114
Ice Possible
This symbol appears with
the Ice Possible message.
This message appears when the outside temperature is
cold enough to create icy road conditions.
Left Rear Door Ajar
This symbol appears
with the Left Rear Door
Ajar message.
When this message appears on the display, it means that
the driver's side rear door was not closed completely.
You should make sure that the door is closed completely.Oil Pressure Low
-- Stop Engine
This symbol appears
with the Oil Pressure
Low
-- Stop Engine
message. A multiple chime
will sound when this
message is displayed.
NOTICE:
If the Oil Pressure Low -- Stop Engine message
appears on the display, stop the vehicle
immediately. Do not drive the vehicle until the
cause of the low oil pressure is corrected. Severe
engine damage can result from driving a vehicle
with low oil pressure. See ªEngine Oilº in the
Index for more information.

2-121
Service Suspension System
This symbol appears with
the Service Suspension
System message.
This message is displayed to indicate that the suspension
system is not operating properly. Have your vehicle
serviced at your dealership.Service Theft SystemThis symbol appears
with the Service Theft
System message.
This message means there is a problem with the
Immobilizer. A fault has been detected in the system
which means that the system is disabled and is not
protecting the vehicle. The vehicle usually restarts,
however, you may want to take your vehicle to your
dealer before turning off the engine.

2-123
Starting Disabled -- Throttle Problem
This symbol appears
with the Starting
Disabled
-- Throttle
Problem message.
This message appears when your vehicle's throttle
system is not functioning properly. Have your vehicle
serviced at your dealership.
Theft Attempted
This symbol appears
with the Theft
Attempted message.
This message is displayed if the content theft
-deterrent
system has detected a break
-in attempt while you were
away from your vehicle.Top Speed
-- Fuel Cut Off
This symbol appears with
the Top Speed
-- Fuel Cut
Off message.
This message will appear when the Engine Control
Module (ECM) detects that the maximum speed for
your vehicle has been reached. Your vehicle's top speed
is based on the top speed rating of the tires. This ensures
that your vehicle stays in a safe operating range for
the tires.

2-125
Trans (Transmission) Hot -- Idle Engine
This symbol appears
with the Trans Hot
--Idle
Engine message.
This message indicates that the transmission fluid in
your vehicle is too hot. Stop the vehicle and allow it to
idle until the transmission cools down or until this
message is removed.
Trunk Open
This symbol appears with
the Trunk Open message.
When this message appears on the display, it means that
the trunk lid of your vehicle was not closed completely.
You should make sure that the trunk lid is closed
completely.Turn Signal On
This symbol appears
with the Turn Signal
On message.
If you drive your vehicle for more than approximately
1 mile (1.6 km) with a turn signal on, this message
will appear as a reminder to turn off the turn signal.
A multiple chime will sound when this message is
displayed.

2-130
Vehicle Programming and
Personalization Features
Your vehicle is equipped with personalization that
allows you to program certain features to a preferred
setting for up to two people. The number of
programmable features varies depending upon which
model of the vehicle is purchased.
On all vehicles, features such as climate control settings,
radio preset settings, exterior lighting at unlock, remote
lock and unlock confirmation, and automatic door locks
have already been programmed for your convenience.
Some vehicles are equipped with additional features that
can be programmed including the seat and outside
rearview mirror position. The optional navigation
system screen preferences will remain at the last set
position.
If your vehicle is equipped with the ability to program
additional personalization features, the driver's
preferences are recalled by pressing the unlock button
on the remote keyless entry transmitter, 1 or 2, or
by pressing the appropriate memory button, 1 or 2,
located on the driver's door. Certain features can be
programmed not to recall until the key is placed in the
ignition. To change feature preferences you must use
one of the following procedures.
Entering the Personalization Menu
To enter the feature programming mode, use one of the
following procedures:
Base Audio System
1. Turn the ignition to ON, but do not start the engine.
Make sure an automatic transmission is in PARK (P)
or a manual transmission has the parking brake set.
2. If your vehicle has memory settings, press the
appropriate memory button, 1 or 2, located on the driver's
door armrest. The DIC display will show either Driver 1
or 2 depending on which button was selected.
3. Press the TUNE/SEL knob once to access the main
menu of the DIC.
4. Turn the TUNE/SEL knob until SETUP is highlighted.
5. Press the TUNE/SEL knob once to access the
SETUP menu.
6. Scroll to the feature you want to change, and press
the TUNE/SEL knob to turn the feature on or off.
If the feature is turned on, a check mark will appear
next to the feature name.
If none of the personalization items are turned on,
turn on the personalization menu by pressing the
TUNE/SEL knob. The list of features will then
appear, and you can repeat Step 6.

2-131
Navigation System
1. Turn the ignition to ON without the engine running.
Make sure an automatic transmission is in PARK (P)
or a manual transmission has the parking brake set.
2. Turn on the Navigation/audio system by pressing the
PWR/VOL knob located to the lower left of the
display once.
3. Access the DIC main menu by pressing the MAIN
button located to the lower left of the display.
4. Press the multi
-function button next to Feat Prog to
access the Feature Programming menu.
5. Press the TUNE/SEL knob to turn on the
Personalization features. An X will appear in the box
to the left when Personalization is turned on.
Personalization Features
The following choices are available for programming
using both the Base audio and Navigation systems
unless otherwise indicated.
Personalization Name
This feature allows you to type in a name that will
appear on the DIC display whenever the corresponding
remote keyless entry transmitter is used or one of the
buttons on the driver's door armrest (1 or 2) is pressed.
If a customized name is not programmed, the system
will show Driver 1 or Driver 2 to correspond with the
numbers on the back of the remote keyless entry
transmitters.
To program a name, use one of the following
procedures:

3-4
(Passenger's Temperature Switch): This switch is
used to increase or decrease the temperature of the air
for the passengers independent of the driver's setting.
To turn the system on, press the PWR button located
on the passenger's side of the climate control panel.
To adjust the temperature, press the up or down arrow
on the PWR button. The temperature will increase or
decrease with each press of an arrow.
If the passenger's temperature switch is off, the driver's
temperature switch controls the temperature for the
entire vehicle.
The passenger's side temperature is only displayed
when the passenger's side temperature switch is on.
Automatic Operation
AUTO (Automatic Climate Control): This button is
used to select the automatic operation of the climate
control system. When the automatic operation is active,
AUTO will appear next to the fan and mode settings on
the display.There are three sensors in the climate control system.
One monitors the sun's solar radiation, another monitors
temperature of the air inside the vehicle, and a third
monitors the temperature outside the vehicle. The
climate control system will vary the fan speed, air
delivery mode and use of the air conditioning
compressor to maintain the set temperature based on the
information received from these sensors. See ªDriver's
Temperature Switchº and ªPassenger's Temperature
Switchº listed previously for more information on
setting a temperature.
To find your comfort zone, start with the 75
F (24
C)
setting and allow approximately 10 to 30 minutes for the
system to regulate. Adjust the temperature if necessary.
If you choose either the lowest temperature setting,
60
F (16
C), or the highest temperature setting,
90
F (32
C), the system will not cool or heat any
faster, but the system will stay at that setting without
regulating fan speed.
To avoid blowing cold air in cold weather, the system
will start at lower fan speeds until warm air is available.
The length of reduction depends on the outside air
temperature, engine coolant temperature or the time
since the engine was last started. As the engine coolant
warms up, the fan speed will gradually increase.

3-9 Climate Control Steering Wheel Controls
There are four controls that can be programmed for use
with the climate control system.
The controls are located
on the left spoke of the
steering wheel.
See ªReconfigurable Steering Wheel Controlsº in
the Index for more information on programming
these controls.
Audio Systems
Your audio system has been designed to operate easily
and to give years of listening pleasure. You will get the
most enjoyment out of it if you acquaint yourself with it
first. Find out what your audio system can do and how
to operate all of its controls to be sure you're getting the
most out of the advanced engineering that went into it.
Your vehicle has a feature called Retained Accessory
Power (RAP). With RAP, you can play your audio
system even after the ignition is turned off. See
ªRetained Accessory Powerº in the Index.