When to Inspect
Inspect the air cleaner/filter every 15,000 miles
(25,000 km) and replace every 30,000 miles
(50,000 km). If you are driving in dusty/dirty conditions,
inspect thefilter at each engine oil change.
How to Inspect
To inspect the air cleaner/filter remove it from the
vehicle andlightlyshake thefilter to release loose dust
and dirt. If thefilter remains“caked”with dirt, a new
filter is required.
To check or replace the engine air cleaner/filter, do the
following:
1. Loosen the screw and clamp on the air duct.
2. Lift up on the two clips
located on the top of
thefilter assembly
to unlock the side
cover.3. Disconnect the duct and reposition it while removing
the side cover.
4. Pull out thefilter.
5. Inspect or replace thefilter if needed.
6. Reinstall thefilter.
7. Push down on the two clips located on top of the
filter assembly to lock the side cover.
{CAUTION:
Operating the engine with the air cleaner/ lter
off can cause you or others to be burned. The
air cleaner not only cleans the air, it helps to
stop ame if the engine back res. If it isn’t
there and the engine back res, you could
be burned. Don’t drive with it off, and be
careful working on the engine with the air
cleaner/ lter off.
Notice:If the air cleaner/ lter is off, a back re can
cause a damaging engine re. And, dirt can
easily get into your engine, which will damage it.
Always have the air cleaner/ lter in place when
you’re driving.
5-19
2003 - Regal OM
Automatic Transaxle Fluid
When to Check and Change
A good time to check your automatic transaxlefluid
level is when the engine oil is changed.
Change both thefluid andfilter every 50,000 miles
(83 000 km) if the vehicle is mainly driven under one or
more of these conditions:
•In heavy city traffic where the outside temperature
regularly reaches 90°F (32°C) or higher.
•In hilly or mountainous terrain.
•When doing frequent trailer towing.
•Uses such as found in taxi, police or delivery
service.
If you do not use your vehicle under any of these
conditions, change thefluid andfilter at 100,000 miles
(166 000 km).
SeePart A: Scheduled Maintenance Services on
page 6-4.
How to Check
Because this operation can be a little difficult, you may
choose to have this done at the dealership service
department.
If you do it yourself, be sure to follow all the instructions
here, or you could get a false reading on the dipstick.
Notice:Too much or too little uid can damage
your transaxle. Too much can mean that some of the
uid could come out and fall on hot engine or
exhaust system parts, starting a re. Too little uid
could cause the transaxle to overheat. Be sure
to get an accurate reading if you check your
transaxle uid.
Wait at least 30 minutes before checking the transaxle
fluid level if you have been driving:
•When outside temperatures are above 90°F (32°C).
•At high speed for quite a while.
•In heavy traffic–especially in hot weather.
•While pulling a trailer.
To get the right reading, thefluid should be at normal
operating temperature, which is 180°Fto200°F
(82°Cto93°C).
Get the vehicle warmed up by driving about 15 miles
(24 km) when outside temperatures are above 50°F
(10°C).Ifit’s colder than 50°F (10°C), you may have to
drive longer.
5-20
2003 - Regal OM