2003 ASTON MARTIN DB AR1 Q battery location

F - Owner Maintenance
1-F-32
The Battery Disconnect Switch
The battery disconnect switch is located in the R/H side wall trim panel of
the boot. When actuated, power to all control modules is disconnected and
only ‘keep alive memory’ power is maintained. Thus the quiescent power
drain on the battery is greatly reduced.
To maintain the battery charge level, press the battery disconnect switch and
use the battery conditioner to charge the battery whenever the vehicle is to
be out of use for some days.
If the battery disconnect function is used in conjunction with the battery
conditioner, the vehicle may be stored for many months without additional
battery maintenance.
Caution: The vehicle security systems will be totally disabled when the battery
disconnect switch is used. The vehicle will be secured only by the mechanical door
locks. Ensure that the vehicle is stored in a secure location.
Caution: Close and lock the doors before disconnecting the battery. The door window
seals will be damaged if the door is closed or opened when the battery is disconnected.

F - Owner Maintenance
1-F-38
Fuse Boxes
Three fuse/relay boxes are fitted to DB AR1 containing the fuses to protect
electrical and electronic systems of the vehicle. The box locations are
indicated on the diagram above.
The forward left and right fuse boxes are located beneath a plate in the
passenger side footwell. The rear fuse box is located in the boot, close to the
battery.
WARNING: Do not add to or alter the electrical systems of DB AR1 unless fitting
Aston Martin approved options to the manufacturers instructions. Use of
unapproved components, incorrect dismantling, incorrect reassembly or incorrect
replacement of components may create electrical overloads and a fire risk.
WARNING: Do not attempt to repair a blown fuse. This could cause a fire hazard
or serious damage elsewhere in the electrical circuits.
WARNING: Do not install a fuse which exceeds the amperage for each location
listed on the following fuse charts.

F - Owner Maintenance
1-F-52
Door Edge Lights
1. Taking care to protect the paint
work, use a screwdriver to lever the
light assembly from its location in
the lower door edge.
2. Remove the bulb from the light
assembly and fit a replacement bulb.
3. Refit the assembly to the door,
pushing firmly until it clips into place.
Central High Mounted Stop Lamp
The high mounted stop lamp is fitted in the boot lid. It is recommended that
your have your dealer change the high mounted stop lamp if necessary.
Electric Window Reset Procedure
If either the battery or the window controllers are disconnected, the window
controller will lose its memory of the window maximum up and down
positions. The window controller memory may be checked and reset as
follows: