2003 ASTON MARTIN DB AR1 Q lock

F - Owner Maintenance
1-F-51
Rear Interior Quarter Lights
1.Insert a small screwdriver into the
lever slot in the light lens and lever
out the lens assembly.
2.Remove the defective bulb from its
clips and replace with a new one.
3.Press the light lens assembly back
into its housing until it clips into
position.
Front Interior Lights
1. Release the quarter turn fastener on the front interior light assembly and
lower the assembly from the roof liner.
2. To replace an interior light festoon bulb, pull the defective bulb from its
clips and insert a new one.
3. To replace a map reading light bulb, swing the bulb contact away from
the bulb. Lift out the defective bulb and fit a replacement. Swing the bulb
contact back to its original position.
4. Refit the light assembly to the roof lining and secure by turning the
quarter turn fastener clockwise.

F - Owner Maintenance
1-F-53 Window Controller Memory Check
With the alarm off and the doors unlocked, open and then close each door
in turn. If the door window drops on opening and rises on closing the door,
the window controller memory is good. If the windows do not drop and rise
correctly, reset the window controllers as follows:
Window Controller Memory Reset Procedure
1. Sit in the drivers seat with the doors closed. Turn on the ignition switch.
2. Press and hold down the window Down button until the window drops
to its maximum down position in one movement.
3. Press and hold the window Up button until the window rises to its
maximum up position in one movement.
4. Switch off the ignition, step out of the car and close the doors. Perform
the Window Controller Memory Check to ensure that the window
maximum up and down positions have been correctly reset.
Headlamp Ventilation
In very humid conditions some condensation may accumulate within the
headlamp pod enclosures whilst the engine is stopped. When the vehicle
is running and the air conditioning is switched on, the headlamp pod
enclosures are automatically vented and any condensation will clear within
a few minutes.
For rapid headlamp ventilation, use the following settings: A/C On, Fan
speed 3, Interior vents all closed. If the condensation does not clear quickly,
consult your Aston Martin dealer.

F - Owner Maintenance
1-F-54
Bodywork and Fittings
Checks and Maintenance
Door hinges should be lubricated and door drain holes cleaned regularly
as follows:
• Door hinges should be lubricated with grease.
• Wipe away any excess lubricant to avoid contaminating clothing.
• Check the drain holes in the bottom face of each door periodically and
clear if necessary with a short length of wire.
Caution: Do not lubricate door or ignition locks. They are greased during manufacture
and should not need regular service.
Caution: Automatic car washes and power-operated mops are not recommended,
since prolonged use will cause fine scratches in the paint surface.
Vehicle Cleaning
Paintwork
Washing
For best results, do not wash the vehicle in strong sunlight. Allow the vehicle
to cool before washing. Do not use household soaps or detergents. Do not
direct hoses at full force around the door or boot seals.
When washing the vehicle use plenty of clean, cold or luke warm water.
Remove dust or mud from the paintwork by brushing in a gentle flow of
water from a hose.

F - Owner Maintenance
1-F-60
Recommissioning After Storage
Provided that the car has been stored in accordance with the recommended
procedure, the following points only should require attention before using
the car on the road.
Check the tyre pressures, inflate if necessary and lower the car to the ground.
Fully charge and refit the battery. Reset the clock and electric windows.
Drain the engine sump and final drive unit, fit a new engine oil filter element,
then refill with the approved oils. Check the coolant level and if necessary
top up with the correct antifreeze/water solution.
Check all fluid levels and top-up as necessary. Fill the fuel tank
Caution: Starting the engine without sufficient lubrication can cause serious engine
damage. Take care to establish engine oil pressure as directed in the following steps
before allowing the engine to start.
Press and hold the accelerator hard to the floor (kickdown switch actuated).
This will temporarily inhibit the fuel injectors during cranking. Turn on the
ignition. Press and hold the starter button to crank the engine until normal
oil pressure is indicated on the oil pressure gauge. Release the starter button
and the accelerator pedal.
Start the engine normally and check that the oil pressure and ignition
warning lights go out as the engine starts indicating correct oil pressure and
battery charging. Raise the bonnet and check for leaks of fuel, oil and
coolant.
Finally, check the operation of all instruments, lights and accessories.

G - Specifications
1-G-4
Transmission - Manual
Tremec T 56 six speed transmission
Gear Ratios
1st 2nd 3rd 4th 5th 6th Reverse
2.66:1 1.78:1 1.30:1 1.00:1 0.79:1 0.62:1 2.9:1
Transmission - Automatic
ZF 5HP-30 five speed automatic transmission with manual gearshift control
using the special selector lever or steering wheel mounted gear shift buttons.
Gear Ratios
1st 2nd 3rd 4th 5th Reverse
3.55:1 2.24:1 1.54:1 1.00:1 0.79:1 3.68:1
Final Drive
GKN Powerlock limited slip differential.
Ratios Manual = 4.09:1 Auto = 3.06:1
Steering
Rack and pinion power-assisted steering. 2.76 turns lock to lock.
Column tilt and reach adjustments.
Turning Circle Kerb to Kerb - 11.4 metres
Wall to Wall - 11.8 metres
Toe-In 0° + 5' front, 0° 12' ± 6' rear
(at half laden ride height of 137 mm front, 141 mm rear)

G - Specifications
1-G-5
Suspension
Front - Independent double-wishbone, coil springs, monotube dampers
and anti-roll bar.
Rear - Independent double-wishbone (driveshaft and lower link), longitudinal
control arms, coil springs and mono-tube dampers.
Brakes
Teves Mk 20 anti-lock braking system with traction control.
Front - Geomet coated 355 mm diameter grooved steel discs with four pot
calipers and Pagid RS4-2-1 pads.
Rear - Geomet coated 330 mm diameter grooved steel discs with four pot
calipers and Textar pads and integral drum handbrake.
Towing
The DB AR1 is not engineered to tow any form of caravan or trailer.
No towing devices are approved for fitting to the vehicle, other than the front
towing eye to aid roadside recovery or loading of the car onto a transporter.

G - Specifications
1-G-7
Exterior Features
Laminated front windscreen with heating element
Heated and electrically operated powerfold rear view door mirrors
Electrically operated door windows
Interior Features
Hand-crafted leather trim
Optional interior trim details: Oak, Elm, Walnut, Maple, Carbon Fibre and
body colour painted
Electrically operated front seats
Air-conditioning
Six speaker stereo radio cassette
CD autochanger
Megamos alarm system interacting with the central locking system
PATs security immobiliser system

2-A-5
A - Service Schedules
Pre-delivery Inspection (PDI)
Before you receive your DB AR1, it will undergo a comprehensive pre-
delivery inspection at the Dealer's premises to ensure that it meets Aston
Martin's quality standards. The following checks will be made:
Levels and Leaks
Engine oil
Power steering oil
Brake Fluid
Clutch fluid (manual only)
Engine coolant level
Engine coolant specific gravity
Windscreen washer fluid
Fuel system
Gearbox oil/Auto transmission fluid
Rear axle oil - Differential
Battery
Mechanical Functions
Auto transmission
Selection and P & N functions
Manual gear selection
Clutch operation (manual only)
Throttle pedal operation
Parking brake operation
Steering column adjustment and lock
operation
Seat adjuster rails
Bonnet (Hood) release and catch
Door operation and locks
Storage compartments
Rear view mirror
Wheels and Tyres
Road wheel nuts
Tyre pressures
Front wheel tracking
Electrical Checks
Battery condition
Heated windscreen
Windscreen washers
Windscreen wipers
Air-conditioning controls
Gauges and warning lights
Radio/Cassette/CD player
Navigation (where fitted)
All speakers
Electric aerial
Inertia switch
Window mechanisms
Side and headlights (main and dip)
Front fog lights
Rear fog lights (where fitted)
Hazard warning lights
Instrument illumination and dimmer
Air conditioning panel illumination
Auto Trans. PRNDL illumination
Horns
Interior/map lights
Cigar lighter
Seat adjustment - all functions
Door mirror adjustments
Reset clock (if necessary)
Door / boot courtesy lights
Central locking system
Filler flap lock operation
Seat belt operation
Seat belt warning system
Security system / Remote control
Clutch pedal start inhibit
Interrogate DTC codes (not N.
America)
Record battery open-circuit voltage