2003.5 Peugeot Boxer Dag trip computer

TELEMATICS Control keypad
"SEL" knob: Rotation:Selection of functions from a menu or a screen. Selection of audio settings - Modification of the value of a setting.
Increase or decrease of the map zoom factor.Adjustment of the display brightness for the video camera.
Press: Displaying of the "MAIN" or "NAV" context menu depending on the active source.Confirmation of the functons selected or of the values changed.
"ESC" button: Cancellation of the current operation.Exit from the page selected and return to the previous page.
Deletion of a character.Pressing for more than 2 seconds: deletion of an entire line.
"MAIN/DARK" button: Displaying of the main menu. Switching on of
the display. Pressing for more than 2 seconds: switches
the display to standby.
"AUDIO/OFF" button: Displaying of the audiosources menu.
Switching on of the radio and CD.
Pressing for more than 2 seconds: switches off the radio and CD. "TEL/OFF" button:
Displaying of the telephonesource menu.
Switching on of the telephone. Pressing for more than 2 seconds: switches
the telephone off.
"NAV/MUTE" button: Displaying of the navigationsource menu.
Pressing for more than 2 seconds: cuts off/restores the voice information.
"TRIP" button Displaying of the trip computersource menu.
YOUR BOXER IN DETAIL 49
For safety reasons, the driver must configure the
multi-function displays while stationary.
17-11-2003

Superimposed display In certain cases, when a function
(radio, telephone, trip computer, ...)changes status while another func-tion is displayed, a window opensto inform you of the change, thendisappears.
MULTI-FUNCTION
DISPLAYS Presentation Monochrome display Colour display These two multi-function displays are an integral part of the audio/tele-
phone/GPS . Therefore, they are
controlled by its control keypad andby its steering wheel stalk. They enable you to obtain the follow-ing information:
Ð displaying of the audio sources
(radio, CD),
Ð displaying of the telematic systems (telephone, services, ...),
Ð displaying of the satellite naviga- tion system (see corresponding section),
Ð displaying of the trip computer (see corresponding section),
Ð the warning messages (e.g. "Warning, maximum speedexceeded") or information mes-sages (e.g. "SIM card absent") dis-
played temporarily.
YOUR BOXER IN DETAIL
50
Main screen Press the
"MAIN/DARK" button to
display the main screen , display
the information relating to the active source (radio, CD, tele-phone or navigation) and gainaccess to the following functions:
Ð Voice memory,
Ð Setup. The "Voice Memory" function per-
mits management of the recorded
voice messages. You can listen tothem again or delete them.
The messages are played in sequence,from the oldest to the most recent.
Deleting deletes all of the messages. The "Setup" function permits
modification of the general system parameters (see ¤ "Parameterconfiguration").
17-11-2003

YOUR BOXER IN DETAIL
52
Setup The "Day brightness" and "Night
brightness" functions enable you to
set day and night brightness values
independently. The "Colours" function controls dis-
playing on the day or night setting or changes the setting automatically inrelation to the light in the passengercompartment or switching on of thelights. The "Voice language" and "Text
language" functions enable you to
choose the language for voice recog- nition and SMS messages (Italian,German, English, Spanish, French,Portuguese, Dutch). The "Distance unit" function
enables you to choose the distance unit for the trip computer calculations(km or miles). Note: to choose the language and
the distance unit, insert the configu- ration CD-Rom. Fleet Management The
"Fleet Management" function
permits locating of the vehicle by means of the automatic transmissionof SMS messages to a control centre.
To have the SMS messages sent, you must:
Ð activate the "Sending mode" function,
Ð select a type of interval in the "Event mode" function,
Ð set the duration of the interval in the "Data frequency send" function,
Ð enter the registration number in the "Vehicle ID" function,
Ð enter the telephone number of the control centre in the "Telephone number" function,
Ð insert the SIM card.
Speed Limit Warning The "Speed Limit Warning" func-
tion enables you to monitor the speed of the vehicle.
To enable the system to detect an excessive speed and warn you ofthis, you must:
Ð activate the "Alarm" function,
Ð set the permitted speed in the "Speed Limit" function,
Ð activate the "Buzzer" function.
17-11-2003

17-11-2003
YOUR BOXER IN DETAIL53
Modem The "Modem" function permits an
exchange of data between the sys- tem and a laptop.
To permit an exchange of data, you must:
Ð connect the computer to the sys- tem using its cable located in the centre of the fascia panel underthe storage compartment,
Ð configure the serial port of the computer to 9 600 bits/s; 8 databits; no parity; 1 stop bit; flux
Xon/Xoff check,
Ð install the modem on the computer,
Ð activate the "modem" function,
Ð insert the SIM card.
TRIP COMPUTER Each time the TRIPbutton on the
audio/telephone control panel is pressed, the following sequence ofdata is displayed:
Ð the average speed calculated
since the last trip computer zero reset (ignition on);
Ð the distance travelled since the
last trip computer zero reset;
Ð the duration of the journey or
time elapsed since the last tripcomputer zero reset, indicated in"hours and minutes";
Ð the distance remaining or distance
to the destination. This is calculatedat any time by the navigation systemif guidance is activated, or entered bythe user minus the distance travelledsince the data was entered; Ð the
time of arrival or the approxi-
mate time of arrival at the destina-
tion. This is obtained by adding
30 % to the remaining duration of
the journey, calculated from theaverage speed and added to thecurrent time.

17-11-2003
YOUR BOXER IN DETAIL53
Modem The "Modem" function permits an
exchange of data between the sys- tem and a laptop.
To permit an exchange of data, you must:
Ð connect the computer to the sys- tem using its cable located in the centre of the fascia panel underthe storage compartment,
Ð configure the serial port of the computer to 9 600 bits/s; 8 databits; no parity; 1 stop bit; flux
Xon/Xoff check,
Ð install the modem on the computer,
Ð activate the "modem" function,
Ð insert the SIM card.
TRIP COMPUTER Each time the TRIPbutton on the
audio/telephone control panel is pressed, the following sequence ofdata is displayed:
Ð the average speed calculated
since the last trip computer zero reset (ignition on);
Ð the distance travelled since the
last trip computer zero reset;
Ð the duration of the journey or
time elapsed since the last tripcomputer zero reset, indicated in"hours and minutes";
Ð the distance remaining or distance
to the destination. This is calculatedat any time by the navigation systemif guidance is activated, or entered bythe user minus the distance travelledsince the data was entered; Ð the
time of arrival or the approxi-
mate time of arrival at the destina-
tion. This is obtained by adding
30 % to the remaining duration of
the journey, calculated from theaverage speed and added to thecurrent time.

YOUR BOXER IN DETAIL55
Button Function
A SRC Selection of the audio source: FM1, FM2, FM3, LW, MW, CD.
B ON/OFF VOL Press: system on/off - Rotation: volume adjustment.
C MAIN DARK Displaying of the main screen - Radio or CD on.
Pressing for more than 1 second: display on standby.
D AUDIO OFF Displaying of the audio source - Activation of the display.
Pressing for more than 1 second: radio or CD off.
E TEL OFF Displaying of the telephone source - Telephone system on.
Pressing for more than 1 second: telephone system off.
F NAV MUTE Displaying of the navigation source.
Pressing for more than 1 second: cut-off/restoration of voice messages.
G TRIP Displaying of the trip computer source.
H SEL Rotation: selection of the required function - Adjustment of the display brightness (video camera). Map zoom +/Ð.
Press: confirmation of the selected function - Displaying of the "MAIN" and "NAV" pull-down menu.
I ESC Cancellation of the current operation - Exit from the current screen and return to the previous screen.
Deletion of a character.Pressing for more than 1 second: deletion of all characters.
J SIM card flap.
K RPT Repetition of the last updated voice message (navigation).
L Displaying of the information and assistance services.
M

Ejection of the CD-Rom or audio CD.
N Activation/Deactivation of the voice commands. Pressing for more than 1 second: recording of a voice description.
17-11-2003

17-11-2003
YOUR BOXER IN DETAIL79
The control buttons These let you select and validate the functions, controls and programmes displayed. The control buttons are an integral part of the audio/tele- phone/GPS.
SEL Dial; this has two functions:
Ð Rotation of the dial: This allows you to moveround the screen and thus
select a function. It also allows you:
¥ with a "setting "type parameter, after selection, to
increase or decrease the value,
¥ with a "list "type parameter, to open the list and scroll
through the values,
¥ with mapguidance, to increase or reduce the zoom. Ð Pressing the dial:
This allows:¥ access to the list of controls (contextual menu) of the
permanent display, if there is no other display superim- posed.
¥ confirmation of the selected function or the modified
value.
¥ selection of a "setting" or "list" type parameter for
modification.
"MAIN DARK" button:
Ð Brief press: Displaying of the main screen.
Ð Pressing for more than one second: display stand-by. "AUDIO OFF" button
Ð Brief press: Displaying of the audiosource - Activation of
the display.
Ð Pressing for more than one second: radio or CD off.
"TEL OFF" button:
Ð Brief press: Displaying of the telephonesource -
Telephone source on.
Ð Pressing for more than one second: telephone source off.
"NAV MUTE" button:
Ð Brief press: selection of the navigationsource.
Ð Pressing for more than one second: cutting-off/restoring of voice messages .
"ESC" button:
Ð Brief press: cancellingof operation in progress or
erasing of last superimposed display.
Ð Pressing for more than one second: erasing of all super- imposed displays and return to the permanent display.
"TRIP" button:
Ð Brief press: Displaying of the trip computer source.