3-3
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
1
23
EAU00118Handlebar switches
EAU00122Dimmer switch “LIGHTS”
Turn the switch to “HI” for the high
beam and to “LO” for the low
beam.
EAU00128Turn signal switch “TURN”
This is a three-position switch. The
center position is off.
Turn to “L” to turn on the left
flasher, and to “R” for the right
flasher. Be sure to turn the switch
off after completing a turn.
1. Dimmer switch “LIGHTS”
2. Turn signal switch “TURN”
3. Horn switch “HORN”
EAU00130Horn switch “HORN”
Press the switch to sound the horn.1
2
EAU00137
Engine stop switch “ENGINE
STOP”
The engine stop switch is a safety
device for use in an emergency
such as when the motorcycle over-
turns or if trouble occurs in the
throttle system. Turn the switch to
“RUN” to start the engine. In case
of emergency, turn the switch to
“OFF” to stop the engine.
1. Engine stop switch “ENGINE STOP”
2. Start switch “START”
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 13
6-30
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1
3. Remove the connector and the
bulb holder cover.
4. Turn the bulb holder counter-
clockwise to remove it and
remove the defective bulb.
EW000119
w
Keep flammable products and your
hands away from a bulb while it is
on, as it is hot. Do not touch a bulb
until it cools down.
5. Put a new bulb into position
and secure it in place with the
bulb holder.
1. Bulb holder cover
EAU01191
Headlight bulb replacement
This motorcycle is equipped with a
quartz bulb headlight. If the head-
light bulb burns out, replace it as
follows:
1. Remove cowling A. (See page
6-6 for cowling removal and
installation procedures.)
2. Remove the headlight unit.
1
EC000105
cC
Avoid touching the glass part of a
bulb. Keep it free from oil; other-
wise, the transparency of the
glass, life of the bulb, and lumi-
nous flux will be adversely affect-
ed. If oil gets on a bulb, thoroughly
clean it with a cloth moistened
with alcohol or lacquer thinner.
6. Install the bulb holder cover,
connector and headlight unit.
7. Install the cowling.
8. If the headlight beam adjust-
ment is necessary, ask a
Yamaha dealer to make that
adjustment.
1. Bulb holder
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 59