EAU00009
TABLE OF CONTENTS
1
2
3
4
5
6
7
8
9 GIVE SAFETY THE RIGHT OF WAY ..................1-1
DESCRIPTION .....................................................2-1
Left view............................................................2-1
Right view .........................................................2-2
Controls/Instruments .......................................2-3
INSTRUMENT AND CONTROL
FUNCTIONS ........................................................3-1
Main switch/Steering lock ...............................3-1
Indicator lights..................................................3-2
Speedometer ....................................................3-2
Handlebar switches..........................................3-3
Clutch lever .......................................................3-4
Shift pedal.........................................................3-4
Front brake lever ..............................................3-5
Rear brake pedal ..............................................3-5
Fuel tank cap.....................................................3-5
Fuel ....................................................................3-6
Fuel cock ...........................................................3-7
Starter (choke) “1” .........................................3-8
Kick starter ........................................................3-8
Seat ...................................................................3-9
Helmet holder ...................................................3-9
Rear shock absorber ......................................3-10
Rear carrier .....................................................3-10Sidestand ........................................................3-10
Sidestand/clutch switch operation check .....3-11
PRE-OPERATION CHECKS.................................4-1
Pre-operation check list ...................................4-1
OPERATION AND IMPORTANT RIDING
POINTS................................................................5-1
Starting and warming up a cold engine.........5-1
Starting a warm engine ...................................5-4
Shifting..............................................................5-4
Engine break-in ................................................5-5
Parking ..............................................................5-6
PERIODIC MAINTENANCE AND MINOR
REPAIR ................................................................6-1
Tool kit ..............................................................6-1
Periodic maintenance and lubrication............6-3
Cowling and panel removal and
installation ........................................................6-6
Cowling A .........................................................6-6
Panel A ..............................................................6-7
Panel B ..............................................................6-7
Spark plug inspection ......................................6-7
Engine oil ..........................................................6-8
Air filter ...........................................................6-12
1
2
3
4
5
6
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 5
6-8
PERIODIC MAINTENANCE AND MINOR REPAIR
6 break down and erode. If electrode
erosion becomes excessive, or if
carbon and other deposits are
excessive, you should replace the
spark plug with the specified plug.
Before installing the spark plug,
measure the electrode gap with a
wire thickness gauge; adjust the
gap to specification as necessary.
When installing the plug, always
clean the gasket surface and use a
new gasket. Wipe off any grime
from the threads and tighten the
spark plug to the specified torque.Specified spark plug:
DR8EA (NGK) or
X24ESR-U (DENSO)Spark plug gap:
0.6 ~ 0.7 mm
Tightening torque:
Spark plug:
17.5 Nm (1.75 m0kg)
NOTE:
If a torque wrench is not available
when you are installing a spark
plug, a good estimate of the cor-
rect torque is 1/4 to 1/2 turn past
finger tight. Have the spark plug
tightened to the specified torque as
soon as possible.EAU00517Engine oil
1. Oil level measurement
a. Place the motorcycle on a level
place and hold it in an upright
position. Warm up the engine
for several minutes.
NOTE:
Be sure the motorcycle is posi-
tioned straight up when checking
the oil level. A slight tilt toward the
side can result in false readings.
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 37
