6-40
PERIODIC MAINTENANCE AND MINOR REPAIR
6 6. While supporting the brake
caliper, pull the wheel axle out.
7. Remove the wheel.
ECA00048
cCDo not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
EAU01620
To install the rear wheel
1. Install the brake caliper onto the
swingarm as shown.NOTE:
Make sure that the slot in the brake
caliper bracket fits over the retainer
on the swingarm.2. Install the drive chain onto the
rear sprocket.
3. Insert the wheel axle from the
left-hand side, install the axle
nut, and then lower the rear
wheel so that it is on the ground.
NOTE:
Make sure that there is enough
space between the brake pads
before inserting the brake disc
between the brake pads.4. Adjust the drive chain slack.
(See page 6-26 for drive chain
slack adjustment procedures.)
5. Tighten the axle nut to the speci-
fied torque.
1
1. Retainer
Tightening torque:
Axle nut:
104 Nm (10.4 m0kgf)
5AE-28199-E5 honbun 7/6/01 10:18 AM Page 75
8-5
SPECIFICATIONS
8
EAU03941
Conversion tableAll specification data in this manual are listed in SI and
METRIC UNITS.
Use this table to convert METRIC unit data to
IMPERIAL unit data.
Ex.
METRIC MULTIPLIER IMPERIAL
** mm×0.03937 = ** in
2 mm×0.03937 = 0.08 inCONVERSION TABLE
METRIC TO IMPERIAL
Metric unit Multiplier Imperial unit
m•kgf 7.233 ft•lb
Torque m•kgf 86.794 in•lb
cm•kgf 0.0723 ft•lb
cm•kgf 0.8679 in•lb
Weightkg 2.205 lbg 0.03527 oz
Speed km/hr 0.6214 mph
km 0.6214 mi
m 3.281 ft
Distance m 1.094 yd
cm 0.3937 in
mm 0.03937 in
cc (cm
3) 0.03527 oz (IMP liq.)
Volume/ cc (cm3) 0.06102 cu•in
Capacity L (liter) 0.8799 qt (IMP liq.)
L (liter) 0.2199 gal (IMP liq.)
kgf/mm 55.997 lb/in
Misc. kgf/cm
2
14.2234 psi (lb/in
2)
Centigrade (°C) 9/5+32 Fahrenheit (°F)
5AE-28199-E5 honbun 7/6/01 10:18 AM Page 88
