Page 28 of 72
6-1
6
EAU00462
6-PERIODIC MAINTENANCE AND MINOR REPAIR
EAU00464
Safety is an obligation of the owner.
Periodic inspection, adjustment and lu-
brication will keep your vehicle in the
safest and most efficient condition pos-
sible. The most important points of in-
spection, adjustment, and lubrication
are explained on the following pages.
The intervals given in the periodic
maintenance and lubrication chart
should be simply considered as a gen-
eral guide under normal riding condi-
tions. However, DEPENDING ON THE
WEATHER, TERRAIN, GEOGRAPHI-
CAL LOCATION, AND INDIVIDUAL
USE, THE MAINTENANCE INTER-
VALS MAY NEED TO BE SHORT-
ENED.
EW000060
WARNING
_ If you are not familiar with motor-
cycle maintenance work, have a
Yamaha dealer do it for you. _
EAU03846*
Owner’s tool kit The owner’s tool kit is located on the
bottom of the seat. (See page 3-6 for
seat opening and closing procedures.)
The service information included in this
manual and the tools provided in the
owner’s tool kit are intended to assist
you in the performance of preventive
maintenance and minor repairs. How-
ever, additional tools such as a torque
wrench may be necessary to perform
certain maintenance work correctly.
NOTE:_ If you do not have the tools or experi-
ence required for a particular job, have
a Yamaha dealer perform it for you. _
EW000063
WARNING
_ Modifications not approved by
Yamaha may cause loss of perfor-
mance and render the vehicle un-
safe for use. Consult a Yamaha
dealer before attempting any chang-
es. _
1. Owner’s tool kit
U5MXE0.book Page 1 Thursday, December 20, 2001 2:08 PM
Page 30 of 72
PERIODIC MAINTENANCE AND MINOR REPAIR
6-3
6
* Since these items require special tools, data and technical skills, have a Yamaha dealer perform the service.
EAU03057*
NOTE:_
From 16,000 km, repeat the maintenance intervals starting from 4,000 km.
Depending on riding conditions, the V-belt replacement interval may vary.
The air filter needs more frequent service if you are riding in unusually wet or dusty areas.
Hydraulic brake system
After disassembling the brake master cylinder, and caliper cylinder, always change the fluid. Regularly check the
brake fluid level and fill reservoir as required.
Replace the oil seals on the inner parts of the brake master cylinder and caliper cylinder every two years.
Replace the brake hose every four years or if cracked or damaged.
_16
*Shock absorber
assembliesCheck operation and shock absorbers for oil leakage.√√√√
17*CarburetorCheck starter (choke) operation.
Adjust engine idling speed.√√√√√
18 Engine oilChange.
Check oil level and vehicle for oil leakage.√√Every 2,000 km
19*Engine oil strainer
Clean.√√
20 Final transmission oilCheck vehicle for oil leakage.√√√√√
Change.√Every 10,000 km
21*V-beltCheck the damage and wear.√√√
Replace. Every 25,000 km (See NOTE.)
22*Front and rear brake
switchesCheck operation.√√√√√
23 Moving parts and cables
Lubricate.√√√√
24*Lights, signals and
switchesCheck operation.
Adjust headlight beam.√√√√√ NO. ITEM CHECK OR MAINTENANCE JOBODOMETER READING (
×1,000 km)
0.5 2 4 8 12
U5MXE0.book Page 3 Thursday, December 20, 2001 2:08 PM
Page 43 of 72
PERIODIC MAINTENANCE AND MINOR REPAIR
6-16
6 To clean the air filter check hoses
1. Check each hose at the bottom of
the air filter case and the V-belt
case for accumulated dirt or water.2. If dirt or water is visible, remove
the hose, clean it, and then install
it.
EAU00629
Adjusting the carburetor The carburetor is an important part of
the engine and requires very sophisti-
cated adjustment. Therefore, most car-
buretor adjustments should be left to a
Yamaha dealer, who has the neces-
sary professional knowledge and expe-
rience. The adjustment described in
the following section, however, may be
serviced by the owner as part of routine
maintenance.
EC000094
CAUTION:_ The carburetor has been set and ex-
tensively tested at the Yamaha fac-
tory. Changing these settings
without sufficient technical knowl-
edge may result in poor perfor-
mance of or damage to the engine. _
1. Check hose (× 2)
1. Check hose
U5MXE0.book Page 16 Thursday, December 20, 2001 2:08 PM
Page 64 of 72
PERIODIC MAINTENANCE AND MINOR REPAIR
6-37
6
EAU01008
Troubleshooting Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
U5MXE0.book Page 37 Thursday, December 20, 2001 2:08 PM
Page 67 of 72
8-1
8
EAU01038
8-SPECIFICATIONS
Specifications CS-01E
Model AT115
Dimensions
Overall length 1,935 mm
Overall width 675 mm
Overall height 1,070 mm
Seat height 755 mm
Wheelbase 1,280 mm
Ground clearance 135 mm
Minimum turning radius 1,900 mm
Basic weight (with oil and full
fuel tank)
103 kg
Maximum load*
116 kg
* Total weight of rider, passenger, cargo and accessories
Engine
Engine type Forced air-cooled 4-stroke,
SOHC
Cylinder arrangement Forward inclined single cylinder
Displacement 113.7 cm
3
Bore × stroke 50.0 × 57.9 mm
Compression ratio 8.8:1
Starting system Electric and kickstarter
Lubrication system Wet sumpEngine oil
Ty p eSAE 20W-50 API Service “SF”
type motor oil
Capacity
Periodic oil change 0.8 L
Total amount (dry engine) 0.9 L
Final transmission oil
Type SAE 10W-40 API Service “SE”
type motor oil
Quantity 0.1 L
Air filter
Dry element
Fuel
Type REGULAR GASOLINE
Fuel tank capacity 4.9 L
Carburetor
Manufacturer MIKUNI
Model × quantity BS25 × 1
Spark plug
Manufacturer/Type NGK / CR7HSA
Gap 0.6–0.7 mm
Clutch type
V-belt automatic
U5MXE0.book Page 1 Thursday, December 20, 2001 2:08 PM
