PERIODIC MAINTENANCE AND MINOR REPAIR
6-11
6
NOTE:_ Make sure that the O-ring is properly
seated. _7. Add the specified amount of the
recommended engine oil, and
then install and tighten the engine
oil filler cap.
ECA00105
CAUTION:_
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives with
the oil or use oils of grade “CD”
or higher. In addition, do not
use oils labeled “ENERGY CON-
SERVING II” or higher.
Make sure that no foreign mate-
rial enters the crankcase.
_8. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
9. Turn the engine off, and then
check the oil level and correct it if
necessary.
EAU04228*
Final transmission oil The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
motorcycle. In addition, the final trans-
mission oil must be changed as follows
at the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine, warm it up by
riding the motorcycle for several
minutes, and then stop the engine.
2. Place the motorcycle on the cen-
terstand.
3. Place an oil pan under the final
transmission case to collect the
used oil. Tightening torques:
Engine oil drain bolt A:
20 Nm (2.0 m·kgf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf)
Recommended engine oil:
See page 8-1.
Oil quantity:
Periodic oil change:
0.8 L
Total amount (dry engine):
0.9 L1. Oil filler cap
U5MXE0.book Page 11 Thursday, December 20, 2001 2:08 PM
