Page 380 of 432
8-121 1. Headlight fuse
2. Ignition fuse
3. Auxiliary DC jack fuse
4. Four-wheel-drive fuse
5. Signal fuse
6. Spare fuse (× 3)
1. Fusible de phare
2. Fusible d’allumage
3. Fusible de prise pour accessoires
4. Fusible du système 4x4
5. Fusible de signalisation
6. Fusible de rechange (× 3)
1. Fusible del faro
2. Fusible del sistema de encendido
3. Fusible de la toma de CC auxiliar
4. Fusible del sistema de tracción en las cuatro ruedas
5. Fusible señalización
6. Fusible de repuesto (× 3)
WARNING
Always use a fuse of the specified rating. Nev-
er use any type of material or object in place of
the proper fuse. An improper fuse can cause
damage to the electrical system which could
lead to a fire.CAUTION:
To prevent accidental short-circuiting, turn off
the main switch when checking or replacing a
fuse.
U5GH62.book Page 121 Monday, August 6, 2001 9:09 AM
Page 382 of 432
8-123 1. Cover
1. Cache
1. Cubierta
1. Bulb holder cover
1. Cache de la fixation d’ampoule
1. Cubierta del portabombillas
EBU00685*
Replacing a headlight bulb
If a headlight bulb burns out, replace it as follows:
1. Remove the cover at the rear of the head-
light.
2. Remove the bulb holder cover.
U5GH62.book Page 123 Monday, August 6, 2001 9:09 AM
Page 384 of 432
8-125 1. Bulb holder
1. Fixation d’ampoule
1. Portabombillas
3. Unhook the bulb holder spring and remove
the defective bulb.
WARNING
The headlight bulb is hot when it is on and im-
mediately after it is turned off. Wait for the bulb
to cool down before touching or removing it.
You can be burned, or a fire could start if the
bulb touches something flammable. 4. Put a new bulb into position and secure it in
place with the bulb holder spring.
5. Install the bulb holder cover.
U5GH62.book Page 125 Monday, August 6, 2001 9:09 AM
Page 386 of 432
8-127 1. Headlight beam adjusting screw
1. Vis de réglage du faisceau de phare
1. Tornillo de ajuste de la luz del faro
EBU00409
Headlight beam adjustmentCAUTION:
It is advisable to have a Yamaha dealer make
this adjustment.1. Vertical adjustment:
To raise the beam, turn the adjusting screw
clockwise.
To lower the beam, turn the screw counter-
clockwise.
U5GH62.book Page 127 Monday, August 6, 2001 9:09 AM
Page 388 of 432
8-129 1. Tail/brake light unit 2. Nut (× 2)
1. Feu arrière/stop 2.Écrou (× 2)
1. Luz de freno/piloto trasero 2. Tuerca (× 2)
1. Tail/brake light unit 2. Bulb holder
1. Feu arrière/stop 2. Fixation d’ampoule
1. Luz de freno/piloto trasero 2. Portabombillas
EBU00964
Tail/brake light bulb replacement
1. Remove the nuts together with the washers.
2. Remove the bulb holder (together with the
bulb) by turning it counterclockwise.
U5GH62.book Page 129 Monday, August 6, 2001 9:09 AM
Page 392 of 432

8-133
EBU00413
Troubleshooting
Although Yamaha machines receive a rigid in-
spection before shipment from the factory, trouble
may occur during operation.
Any problem in the fuel, compression, or ignition
systems can cause poor starting and loss of pow-
er. The troubleshooting chart describes a quick,
easy procedure for making checks. If your ma-
chine requires any repair, take it to a Yamaha
dealer.
The skilled technicians at a Yamaha dealership
have the tools, experience, and know-how to prop-
erly service your machine. Use only genuine
Yamaha parts on your machine. Imitation parts
may look like Yamaha parts, but they are often in-
ferior. Consequently, they have a shorter service
life and can lead to expensive repair bills.
WARNING
Do not smoke when checking the fuel system.
Fuel can ignite or explode, causing severe in-
jury or property damage. Make sure there are
no open flames or sparks in the area, including
pilot lights from water heaters or furnaces.
U5GH62.book Page 133 Monday, August 6, 2001 9:09 AM
Page 408 of 432
9-9
5. Tie a plastic bag over the exhaust pipe outlet
to prevent moisture from entering.
6. If storing in a humid or salt-air atmosphere,
coat all exposed metal surfaces with a light
film of oil. Do not apply oil to any rubber parts
or the seat cover.
7. Remove the battery and charge it. Store it in
a dry place and recharge it once a month. Do
not store the battery in an excessively warm
or cold place (less than 0°C or more than
30°C).NOTE:Make any necessary repairs before storing the
machine.
U5GH62.book Page 9 Monday, August 6, 2001 9:09 AM
Page 414 of 432
10-5
Brake:
Front brake type Dual disc brake
operation Right hand operation
Rear brake type Single disk brake
operation Left hand and right foot operation
Suspension:
Front suspension Double wishbone
Rear suspension Swingarm (monocross)
Shock absorber:
Front shock absorber Coil spring / oil damper
Rear shock absorber Coil spring / oil damper
Wheel travel:
Front wheel travel 160 mm
Rear wheel travel 180 mm
Electrical:
Ignition system DC-C.D.I.
Generator system A.C. magneto
Battery type YTX20L-BS
Battery voltage, capacity 12 V, 18 AH
Headlight type: Krypton bulbModel YFM4FAP
U5GH62.book Page 5 Monday, August 6, 2001 9:09 AM