2002 YAMAHA BREEZE engine oil

8-17
cC
8Be sure to use motor oils that do not con-
tain anti-friction modifiers. Passenger car
motor oils (often labeled “Energy
Conserving”) contain anti-friction addi-
tives which will cause clutch and/or starter
clutch slippage, resulting in reduced com-
ponent life and poor engine performance.
8Be sure no foreign material enters the
crankcase.
Recommended oil:
See page 10-2
Oil quantity:
Total amount
0.7 L
Periodic oil change
0.65 L
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 18

8-19
7. Start the engine and warm up for a few min-
utes. While warming up, check for oil leak-
age. If oil leakage is found, stop the engine
immediately, and check for the cause.
8. Check the oil level.
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 20

8-67
3. Thoroughly lubricate the drive chain with a
special O-ring chain lubricant.
cC
Do not use engine oil or any other lubricants
for the drive chain, as they may contain sub-
stances that could damage the O-rings.
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 68

8-69
EBU00570
Cable inspection and lubrication
w
Inspect cables frequently and replace if dam-
aged. Corrosion can result when the outer
covering of control cables becomes dam-
aged. Cables can also become frayed or
kinked. Operation of controls could be
restricted, which could cause an accident or
injury.
Lubricate the inner cables and the cable ends. If
the cables do not operate smoothly, ask a
Yamaha dealer to replace them.
Recommended lubricant:
Engine oil
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 70

9-7
EBU00528
B. STORAGE
Long term storage (60 days or more) of your
machine will require some preventive proce-
dures to guard against deterioration. After thor-
oughly cleaning the machine, prepare for stor-
age as follows:
1. Fill the fuel tank with fresh fuel and add fuel
stabilizer (if available).
NOTE:
Use of fuel stabilizer eliminates the need to
drain the fuel system. Consult a Yamaha dealer
if the fuel system is to be drained instead.
2. Remove the spark plug, pour about one
tablespoon of SAE 10W30 or 20W40 motor
oil in the spark plug hole and reinstall the
spark plug. Ground the spark plug wire and
turn the engine over several times to coat
the cylinder wall with oil.
3. Clean the drive chain thoroughly and lubri-
cate it. (See page 8-65.)
5KJ-62 (9 shou ~) 4/23/01 3:09 PM Page 8

10-1
Model YFS200
Dimensions:
Overall length 1,735 mm
Overall width 1,035 mm
Overall height 1,040 mm
Seat height 740 mm
Wheelbase 1,100 mm
Minimum ground clearance 120 mm
Minimum turning radius 3,000 mm
Basic weight:
With oil and full fuel tank 153 kg
Engine:
Engine type Air-cooled 2-stroke
Cylinder arrangement Forward-inclined single cylinder
Displacement 195 cm
3
Bore × stroke 66 ×57 mm
Compression ratio 6.6 : 1
Starting system Kick starter
Lubrication system Separate lubrication (Yamaha Autolube)
EBU00428
SPECIFICATIONS
5KJ-62 (9 shou ~) 4/23/01 3:09 PM Page 12

10-2
Model YFS200
Engine oil (2-cycle):
Type Air-cooled 2-stroke engine oil
Quantity 1.3 L
Transmission oil:
Type SAE 10W30 type SE motor oil
Recommended transmission oil
classificationAPI Service SE, SF, SG type or higher
cC
Be sure to use motor oils that do not contain
anti-friction modifiers. Passenger car motor
oils (often labeled “Energy Conserving”)
contain anti-friction additives which will
cause clutch and/or starter clutch slippage,
resulting in reduced component life and poor
engine performance.
Quantity:
Periodic oil change 0.65 L
Total amount 0.7 L
Air filter Wet type element
10
5KJ-62 (9 shou ~) 4/23/01 3:09 PM Page 13