
Remote keyless entry system
Your car is equipped with a  remote control transmitter. This transmitter uses a  radio frequency which  will allow
"keyless"  entry into the passenger  compartment or the tailgate.  Your car is supplied with two coded key  ring
transmitters, which  will enable you to lock/ unlock all doors and  the tailgate  from  a  distance of 10-15 feet (3-5 meters).
The remote transmitter will also activate or deactivate the your car's alarm system(s). The car can also be
locked/unlocked  with the key.
As an  extra security precaution in certain situations (valet parking, etc.), Volvo recommends that the transmitter not be
included  when the keys are given to anyone. The service key  can be  used instead. If one  of the transmitters is
misplaced, contact your nearest authorized Volvo retailer for assistance. 
Using the remote control
Press the LOCK button once to lock all doors, fuel filler  door and  tailgate.
Press the UNLOCK button once to unlock the driver's door only. Press this  button again (within 10 seconds) to
unlock all doors, fuel filler  door and  tailgate.
To open  the tailgate  (without unlocking the other doors), press the tailgate -unlock button twice.
NOTE:
If the doors are unlocked with the remote, the locks will automatically  reengage (re-lock) and  the alarm will reset
after 2 minutes unless a  door has been opened.
The lock/unlock and  alarm features can also be  utilized by using the keys.
FCC ID:LQNP2T-APU
This device complies with part 15 of the FCC rules.  Operation is subject to the following conditions:  (1) This device
may not cause harmful interference, and  (2) this  device must  accept any  interference received,  including interference
that may cause undesired operation.
Canadian 2306104388 
ProCarManuals.com 

Driving with the tailgate  open: Driving with the tailgate  open  could mean that poisonous exhaust gases enter the
passenger  compartment. If the tailgate  must  be  kept open  for any  reason, proceed as follows:
- Close the windows.
- Set the ventilation system control to air flow to floor,  windshield and  side windows and  blower control to its
highest setting.
Floor mats: An extra mat on the driver's floor  can cause the accelerator  pedal to catch. Check that the movement
of the accelerator  pedal is not impeded.  Not more than one  protective floor  covering may be  used at one  time.
Electrical system
When replacing the battery or when carrying out work involving the electrical system, the following should be
observed:
A battery connection to the wrong terminal will damage the electrical system. Be sure to connect the positive battery
cable to the positive battery terminal and  the negative battery cable to the negative battery terminal.
If booster  batteries are used for starting, they must  be  properly connected to minimize the risk of the electrical
system being damaged. For correct connection, see "Jump starting" section.
Never  disconnect the battery circuit (for example, to replace  the battery) while the engine is running, as this  may
damage the generator. Always make sure that all the battery connections are properly cleaned and  tightened.
If any  electrical welding work is performed on the vehicle, the battery's ground lead (negative cable)  and  all the
connecting cables of the generator must  be  disconnected and  the welder cables placed as near the welding points  as
possible.
The radio must  be  turned off before the battery is disconnected.
Switch off the ignition for at least 10 minutes before disconnecting the battery. 
pg. 91 Roof racks/Load carriers
Load carriers (accessory)
Load carriers are available as Volvo accessories. Observe the following points  when in use:
To avoid damaging  your car and  to achieve maximum safety when driving, we recommend using the load carriers
that Volvo has developed especially for your car.
The maximum weight that may be  loaded on the roof is 220 lbs (100 kg), including load carriers.
Avoid single-point loads. Distribute loads evenly.
Place heavier  cargo at the bottom of the load.
Anchor the cargo correctly with appropriate tie-down equipment.
Check periodically that the load carriers  and load are properly secured.
Remember that the car's center  of gravity and  handling change when you carry a  load on the roof.
The car's wind resistance  (and correspondingly, fuel consumption) will increase with the size of the load.
Drive smoothly. Avoid rapid starts, fast  cornering and  hard braking. 
ProCarManuals.com 

6 Power passenger's  seat30A
7 Heated front  seat - left15A
8 Heated front  seat - right 15A
9 ABS 5A
10 -
11 -
12 Headlight  wipers 15A
13 Electric socket 12 V 20A
14 Power passenger's  seat, seat belt buckle switches,  SRS 5A
15 Audio system 5A
16 Audio system 20A
17 Radio amplifier 30A
18 Front fog lights 15A
19 VNS  display (option) 15A
20 -
21 Transmission module 10A
22 Direction indicators 20A
23 Headlight  switch module, module for electrical connections, climate  control system, onboard diagnostic
connector,  steering wheel lever modules 5A
24 Relay for extended X-feed: climate  control system, power driver's seat, text window, shiftlock
geartronic 10A
25 Ignition switch, Relay starter motor 10A
26 Control module - climate  control blower 30A
27 Central  locking system, power windows 15A
28 Power sun roof, courtesy lights, vanity mirror lights 10A
29 Telephone (option) 10A
30 Left front/rear parking lights 10A
31 Right front/rear parking lights, license plate  lights 10A
32 Central  electrical module, interior  courtesy lights, power steering 10A
33 Fuel pump 15A
34 Power sun roof 15A
35 Defroster, Lighting,  Sideview mirrors,  central locking system, power windows - left front 25A
36 Defroster, Lighting,  Sideview mirrors,  central locking system, power windows - right front 25A
37 Power windows - rear doors 30A
38 Siren alarm 5A
pg. 115 Fuses  in  the cargo area
Fuses in the cargo area
The fuses in the cargo area are located on the trim on the left-hand  side. When replacing a  blown fuse, be  sure to
replace  it with a  new one  of the same color and  amperage  (written on the fuse). 
ProCarManuals.com 

2 0 0 2 
VOLVO V70
Chapter 10 - Audio systems
pg. 145 Audio systems
HU-413 overview146
HU-613 overview147
HU-803 overview148
Functions149
Specifications160
General  information161
pg. 146 Audio system  HU-413 - overview
1. Display 
2. Radio - Manual station selection
Cassette - Fast winding forward/backward
CD - Fast forward/backward. 
3. Radio - Station seek up/down
Cassette - selecting next/previous  track
CD - Selecting next/previous  track
4. Fader - press and  turn Balance - press, pull and  turn
5. Selector knob: 
Radio
Cassette
CD changer
ProCarManuals.com 

6. Cassette eject
7. Selector knob for:  
Stored radio frequencies
CD changer - selecting disc
8. Cassette opening
9. Tape direction selector
CD random play
10. On/off - press
Volume - turn
11. Bass - press and  turn
Treble - press, pull and  turn
12. Automatic presetting  of radio stations
13. Dolby B Noise Reduction
14. Active Sound Control (ON or OFF) 
15. Scan  function
pg. 147 Audio system  HU-613 - overview
1. On/off - press
Volume - turn
2. Selector knob for:  
Stored radio frequencies
CD changer - selecting disc
3. Selector knob: 
Radio
Cassette
CD
CD changer
TV (option on certain models) 
4. Fader - press and  turn
Balance - press, pull and  turn
5. Radio - Station seek up/down
Cassette - selecting next/previous  track
CD - Selecting next/previous  track
6. Radio - Manual station selection
Cassette - Fast winding forward/backward
CD - Fast forwards/backward
7. CD eject
ProCarManuals.com 

8. CD slot
9. CD random play
10. Active Sound Control (ON or OFF) 
11. Scan  function
12. Dolby B Noise Reduction
13. Automatic presetting  of radio stations
14. Bass - press and  turn
Treble - press, pull and  turn
15. Tape direction selector
16. Cassette opening
17. Cassette eject
18. Display
pg. 148 Audio system  HU-803 - overview
1. On/off - press
Volume - turn
2. Bass - press and  turn
Treble - press, pull and  turn
3. Fader - press and  turn
Balance - press, pull and  turn
4. Center volume - press and  turn
Effect  channel volume - press, pull and  turn
5. Selector knob for:  
Stored radio frequencies
CD - selecting disc
6. Selector knob: 
Radio
Internal CD changer
Station scan - press
TV (option on certain models) 
External CD changer (option) 
7. Radio - Station seek up/down
CD - Selecting next/previous  track
8. Radio - Manual station selection
CD - Fast forward/backward
9. CD eject
10. Dolby Pro Logic - switching on
ProCarManuals.com 

11. 2 channel stereo
12 3 channel stereo
13. CD slot
14. CD random play
15. Program  type
16. News
17. Traffic information
18. Automatic presetting  of radio stations
19. Display
pg. 149 Audio systems  HU-413/HU-613/HU-803
Switch on/off
Press the knob to switch on or turn off the radio.
Volume control
Turn  the knob clockwise to increase volume. Volume control is electronic  and  does not have an  end  stop. If you have
a  key  pad  in the steering wheel, increase or decrease  the volume with the +  or - buttons.  
Bass
Adjust the bass by pressing the button to ex -tend the control and  turning it to the left (less bass) or to the right (more
bass). A "detent"  indicates "equalized" bass. Press the button back in when you have made the adjustment.
Treble
Adjust the treble by pressing the button to ex -tend the control, pulling it out as far as possi-ble, and  then turning it to
the left (less treble) or to the right (more treble). A "detent"  indicates "equalized" treble. Press the button back in when
you have made the adjustment. 
ProCarManuals.com 

A - Setting station
Press the left side of the button to select lower frequencies and  the right side for higher frequencies. Set frequencies are
displayed.
B - Station seek up/down
Press the left side (lower frequency) or right side (higher frequency) of the button to start the seek function. The radio
seeks the next audible  station and  tunes it in. Repeat the procedure to continue  the seek function. 
Station seek up/down
If you have a  key  pad  in the steering wheel press the right or left arrow to switch between preset stations.
Scan function
Press the SCAN button (HU-613) or the SOURCE  button (HU-803) to start the station scan function. When a  station
is found, scanning stops for several seconds, after which  scanning will continue.
Press the SCAN or SOURCE  button when a  station has been found if you would like to listen to that station and  to
discontinue the scan function. 
pg. 151 Audio systems  HU-413/HU-613/HU-803 - radio
A - Automatic station preset
This function seeks and  stores up to 10 strong AM or FM  stations in a  separate memory. This function is especially
useful  in areas where  you are not familiar with the radio stations.
1. Press in the "AUTO" button. A number of strong signal stations (max. 10) from  the currently selected waveband are
now stored  automatically  in the memory. An "A" and  "AUTO" is displayed. If there is no station with sufficient signal
strength "NO STATION" is displayed.
ProCarManuals.com