2002 TOYOTA MR2 SPYDER engine

02 MY MR2 SMT(U) L/O 0108
204
01 06 12
2002 MR2 (OM17493U)
NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle’s paint.
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent yourself from burning,
do not replace the light bulbs while
they are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the wind-
shield fogged up in the rain. However, if
there is large drop of water on the inside
of the lens, or if there is water pooled
inside the light, contact your Toyota deal-
er.

02 MY MR2 SMT(U) L/O 0108
209
01 06 12
2002 MR2 (OM17493U)
SB73074SB73019SB73065
a: Backup light
b: Rear turn signal light
c: Stop/tail light
d: Stop light
CAUTION
Be careful when you work in the area
around the engine after driving in or-
der to prevent burning yourself. The
engine hood, the support rod, or sur-
rounding area could be hot after driv-
ing.
—Rear turn signal, stop/tail,
stop and backup lights

02 MY MR2 SMT(U) L/O 0108
211
01 06 12
2002 MR2 (OM17493U)
SB73060
SB73057
SB73058
SB73059
CAUTION
Be careful when you work in the area
around the engine after driving in or-
der to prevent burning yourself. The
engine hood, the support rod, or sur-
rounding area could be hot after driv-
ing.

02 MY MR2 SMT(U) L/O 0108
213
01 06 12
2002 MR2 (OM17493U)
SPECIFICATIONS
Dimensions and weight214
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. .
Engine 214
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . .
Fuel 214
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . .
Service specifications 215
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . .
Tires 218
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . .
Fuses 219
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . .
SECTION 8

02 MY MR2 SMT(U) L/O 0108
214
01 06 12
2002 MR2 (OM17493U)
Dimensions and weight
Overall length mm (in.) 3885 (153.0)
Overall width mm (in.) 1695 (66.7)
Overall height mm (in.) 1240 (48.8)
∗
Wheelbase mm (in.) 2450 (96.5)
Front tread mm (in.) 1475 (58.1)
Rear tread mm (in.) 1460 (57.5)
Vehicle capacity weight
(occupants + luggage)kg (lb.) 193 (425)
∗: Unladen vehicle
Engine
Model: 1ZZFE
Type: 4 cylinder in line, 4 cycle, gasoline
Bore and stroke, mm (in.): 79.0  91.5 (3.11  3.60)
Displacement, cm
3 (cu. in.):
1794 (109.5)
Fuel
Fuel type:
Unleaded gasoline, Octane Rating 87
(Research Octane Number 91) or higher
Fuel tank capacity, L (gal., Imp. gal.): 48 (12.7, 10.6)

02 MY MR2 SMT(U) L/O 0108
215
01 06 12
2002 MR2 (OM17493U)
Service specifications
ENGINE
Valve clearance (engine cold), mm (in.):Intake 0.15—0.25 (0.006—0.010)
Exhaust 0.25—0.35 (0.010—0.014)
Spark plug type: DENSO SK16R11
NGK IFR5A11
Spark plug gap, mm (in.): 1.1 (0.043) ENGINE LUBRICATION
  \f\b \b \f
!
" #! $ #%
With filter 3.7 (3.9, 3.3)
Without filter 3.5 (3.7, 3.1)
Oil grade: API grade SJ “EnergyConserving”, SL
“EnergyConserving” or ILSAC multi-
grade engine oil is recommended.
Recommended oil viscosity (SAE):COOLING SYSTEM
Total capacity, L (qt., Imp. qt.): 10.4 (11.0, 9.2)
Coolant type: “TOYOTA Long Life Coolant” or equiva-
lent
With ethyleneglycol type coolant for a
proper corrosion protection of aluminum
components
Do not use alcohol type antifreeze or
plain water alone.
BATTERY
Open voltage
∗ at 20 °C (68 °F):
12.6—12.8 V Fully charged
12.2—12.4 V Half charged
11.8—12.0 V Discharged
∗: Voltage that is checked 20 minutes af-
ter the key is removed with all the lights
turned off
Charging rates: 5 A max.

02 MY MR2 SMT(U) L/O 0108
216
01 06 12
2002 MR2 (OM17493U)
CLUTCH (manual transmission only)
Pedal free play, mm (in.):5—15 (0.2—0.6)
 % &'( )*+, \f -.&& /0
1 ,
MANUAL TRANSAXLE
Oil capacity, L (qt., Imp. qt.): Vehicle with limitedslip differential1.8 (1.9, 1.6)
Vehicle without limitedslip differential 1.9 (2.0, 1.7)
Oil type: Gear oil API GL4 or GL5
Recommended oil viscosity: SAE 75W90 SEQUENTIAL MANUAL TRANSMISSION
SYSTEM
Fluid type:
Sequential M/T Fluid
NOTICE: Using Fluid other than Toyota
Genuine Sequential M/T Fluid may
cause deterioration in shift performance
and durability, and ultimately damage
the sequential manual transmission of
your vehicle. BRAKES
Minimum pedal clearance when depressed
with the force of 490 N (50 kgf, 110 lbf)
with the engine running, mm (in.):
85 (3.4)
Pedal free play, mm (in.): 1—6 (0.04—0.24)
Pad wear limit, mm (in.): 1.0 (0.04)
Parking brake adjustment when pulled with
the force of 196 N (20 kgf, 44 lbf): 5—8 clicks
 % &'( )*+, \f -.&& /0
1 ,

02 MY MR2 SMT(U) L/O 0108
220
01 06 12
2002 MR2 (OM17493U)
SB73068
Engine compartment
20. OBD 7.5 A: Onboard diagnosis
system
21. AM1 7.5 A: “GAUGE” “ACC” “TURN”
“ECUIG” “WIPER” “WASHER” “SRS”
“HTR 10A” “FANIG” fuses
22. ACC 25 A: “RADIO2” “CIG” fuses
23. DOOR 15 A: Power door lock system
24. STOP 15 A: Stop lights, high mounted
stop light, sequential manual
transmission system
25. TAIL1 20 A: “TAIL2” “PANEL” fuses
26. D P/W 20 A: Power window system
27. P P/W 20 A: Power window system 28. RADIO1 15 A:
Power antenna, radio
29. DOME 10 A: Clock
30. ECUB 10 A: Daytime running light
system, g auges and meters
31. TAIL2 10 A: Taillights, parking lights,
license plate lights, gauges and meters
32. PANEL 7.5 A: Clock, illuminations
33. RADIO2 7.5 A: Gauges and meters,
outside rear view mirror system, clock
34. CIG 15 A: Cigarette lighter
35. I/UP 7.5 A: Engine idle up system
36. ALTS 7.5 A: Charging system
37. ECUB1 25 A: “ECUB” “DOME” fuses
38. SMTB 10A: Sequential manual
transmission system
39. HORN 10 A: Horn
40. HAZ 15 A: Turn signal lights,
emergency flashers
41. AM2 15 A: Starter system, multiport
fuel injection system/sequential
multiport fuel injection system, SRS
airbag system
42. IG2 15 A: Ignition system, multiport
fuel injection system/sequential
multiport fuel injection system 43. EFI1 15 A:
Multiport fuel injection
system/s equential multiport fuel
injection system, engine immobiliser
system
44. ETCS 15A: Multiport fuel injection
system/s equential multiport fuel
injection system
45. HPU 30A: Sequential manual
transmission system
46. DRL NO.1 7.5 A: Daytime running light
system
47. DRL NO.2 20 A: “HEAD LH LWR”
“HEAD RH LWR” “HEAD LH UPR”
“HEAD RH UPR” fuses
48. EFI2 7.5 A: Multiport fuel injection
system/s equential multiport fuel
injection system
49. ST 7.5 A: Starter system
50. SMTIG 10A: Sequential manual
transmission system
Fuses (type B)
51. ABS2 40 A: Antilock brake system
52. EHPS 50 A: Power steering system
53. MAIN 40 A: Starter system, “DRL”
“DRL NO.2” fuses
54. HTR 40 A: Ai
r conditioning system