2002 TOYOTA LAND CRUISER phone

11
UN201
Touch the ºInfoº switch on the screen to
display the selected destination name, ad-
dress and telephone number.
INFORMATION
The desired point of interest can be dis- played on the map screen. (For details,see page 29.)
LIST OF POINTS OF INTEREST
ALL AUTOMOTIVE
AUTOMOBILE CLUB
AUTO SERVICE & MAIN-
TENANCE
GAS STATION
LEXUS DEALERSHIPS
(all search areas)
PARKING GARAGE/HOUSE
PARKING LOT
TOYOTA DEALERSHIPS
(all search areas)
ALL BANKING
AT M
BANK
ALL COMMUNITY
CITY HALL
CIVIC/COMMUNITY CEN-
TER
CONVENTION/EXHIBITION
CENTER
COURT HOUSE

16
UN027
The distance from your current position up to
the destination is displayed on the right of the
name.
You can see the names of the emergency
destinations in alphabetical order by touch-
ing the
ºName Sortº switch on the
screen.
Touch the
of your desired item. The
screen changes and displays the map
location of the selected destination and
the route preference. (See
ºEntering
Destinationº on page 19.)
Touch the
ºInfoº switch on the screen to
display the selected emergency destination
name, address and telephone number.
INFORMATION
The navigation system does not guide in areas while route guidance is un-available. (See page 38.)
Touch the ºIntersectionº switch on
the destination screen.
UN028
Input the name of the two intersecting
streets which are located near the des-
tination to be set.
When you touch the
ºListº switch or the
number of sites becomes 4 or less, the list of
matching street names appears.
Destination Input by
INTERSECTION

50
UN081
When you finish registration of the
marked point, the ºEdit Marked Pointº
screen appears. The information shown
depends on the method used to enter the
marked point.
If you want to change the icon or name or en-
ter a telephone number, touch the item to be
edited (on the left side of the screen).
3. Touch the
ºOKº switch.
INFORMATION
Up to 100 marked points can be regis-tered.
Once a marked point is registered, you
can edit the icon, name or telephone
number.
1. Push the
ºMENUº button on the bez-
el to display the menu screen and touch
the
ºMarked Pointº switch.
UN082
2. Touch the ºEditº switch.
UN083
The screen lists the marked points.
Sort by Mark: Touch this switch to list the
marked points in order of the type of symbol.
Sort by Date: Touch this switch to list the
marked points in order of the registered date.
Sort by Name: Touch this switch to list the
marked points in alphabetical order.
Sort by Dist: Touch this switch to list the
marked points in order of nearest place from
your current location.
Touch
of the desired marked point to
display the edit marked point screen.
(b) Editing marked points

51
UN084
Touch the item to edit (on the left side of
the screen).

Editing an ºIconº
UN085
Touch your desired icon.
Special Purpose Icon: During driving, only
special purpose icons can be selected in the
marked point list. You can register up to 5. Sound Icon:
When you set on these icons,
the buzzer sounds as your vehicle ap-
proaches them.
When you touch the desired symbol or
ºBackº, the previous screen is displayed.

Editing a ºNameº
UN086
Touch alphabet or numeral keys directly
to input the name.
After you finish your entry, touch the
ºEn-
terº
switch at the bottom right of the screen.
The previous screen will be displayed.

Editing a ºPhoneº (telephone number)
UN087
Touch numeral keys directly.
After you finish your entry, touch the
ºEn-
terº
switch at the bottom of the screen.
The previous screen will be displayed.

8

Editing a ºPhoneº (telephone number)
UN134
Touch numeral keys directly.
After you finish your entry, touch the
ºEn-
terº
switch at the bottom of the screen.
The previous screen will be displayed.
After you finish any editing, touch the
ºOKº switch.
UN135
1. Touch the ºDelete Dealerº switch.
UN136
UN136t
2. A selected point will appear. Also, a
message will appear at the bottom of the
screen. To delete, touch the
ºYESºswitch. To cancel the deletion, touch theºNOº switch. The registered dealer can be set as a des-
tination.
Touch the ºGo to Dealerº switch. The
screen changes and displays the map
location of the registered dealer and the
route preference. (See ºEntering Des-
tinationº on page 19.)
(c) Deleting dealer (d) Going to dealer

31
(iv) Searching by track
unx626
Enter the track numbers using -º, +º
and +10º switches and touch Enterº.
The player starts playing video for that
title number.
You can select a track number by pushing


º or º on the TRACKº button.
Touch Returnº, the previous screen returns.
(h) If the player malfunctions
If the player or another unit equipped with the
player malfunction, your audio system will
display one of the six following messages.
If DISC CHECKº appears on the display:
It indicates that the disc dirty, damaged, or it
was inserted up-side down. Clean the disc
or insert it correctly.
If NO DISCº appears on the display: It in-
dicates that there is no disc in the DVD play-
er.
If REGION CODE ERRORº appears on
the display: It indicates that the DVD region
code is not set properly.
If DVD DOOR OPENº appears on the dis-
play: It indicates that the door of the DVD
player is open.
If DVD ERRORº appears on the display:
It indicates that the inside of the player unit
may be too hot due to the very high ambient
temperature. Remove the magazine from
the player and allow the player to cool down.
If NO DVD MAGAZINEº appears on the
display: It indicates that the magazine is not
inserted into the DVD player.
If the malfunction is not rectified: Take
your vehicle to your Toyota dealer.
NOTICE
To ensure correct audio system opera- tion:
Be careful not to spill beveragesover the audio system.
Do not put anything other than a cas-sette tape or magazine into the cas-
sette tape slot or DVD player.
The use of a cellular phone inside ornear the vehicle may cause a noise
from the speakers of the audiosystem which you are listening to.
However, this does not indicate amalfunction.
Radio reception
Usually, the problem with radio reception
does not mean there is a problem with your
radio - it is just the normal res ult of conditions
outside the vehicle.
Car audio system operating
hints

32For example, nearby buildings and terrain
can interfere with FM reception. Power lines
or telephone wires can interfere with AM sig-
nals. And of course, radio signals have a lim-
ited range, and the farther you are from a sta-
tion, the weaker its signal will be. In addition,
reception conditions change constantly as
your vehicle moves.
Here are some common reception
problems
that probably do not indicate a problem with
your radio:
FM
Fading and drifting stations - Generally,
the effective range of FM is about 40 km (25
miles). Once outside this range, you may no-
tice fading and drifting, which increase with
the distance from the radio transmitter. They
are often accompanied by distortion.
Multi-path - FM signals are reflective, mak-
ing it possible for two signals to reach your
antenna at the same time. If this happens,
the signals will cancel each other out, caus-
ing a momentary flutter or loss of reception.
Static and fluttering - These occur when
signals are blocked by buildings, trees, or
other large objects. Increasing the bass lev-
el may reduce static and fluttering. Station
swapping - If the FM signal you are
listening to is interrupted or weakened, and
there is another strong station nearby on the
FM band, your radio may tune in the second
station until the original signal can be picked
up again.
AM
Fading - AM broadcasts are reflected by the
upper atmosphere - especially at night.
These reflected signals can interfere with
those received directly from the radio station,
causing the radio station to sound alternately
strong and weak.
Station interference - When a reflected sig-
nal and a signal received directly from a radio
station are very nearly the same frequency,
they can interfere with each other, making it
difficult to hear the broadcast.
Static - AM is easily affected by external
sources of elec trical noise, such as high ten-
sion power lines, lightening, or electrical mo-
tors. This results in static.
Caring for your cassette player and tapes
For high performance from your cassette
player and tapes:
Clean the tape head and other parts regular-
ly. 
A dirty tape head or tape path can de-
crease sound quality and tangle your cas-
sette tapes. The easiest way to clean
them is by using a cleaning tape. (A wet
type is recommended.)
Use high-quality cassettes:
 Low-quality cassette tapes can cause
many problems, including poor sound, in-
consistent playing speed, and constant
auto-reversing. They can also get stuck
or tangled in the cassette player.
 Do not use a cassette if it has been dam-
aged or tangled or if its label is peeling off.
 Do not leave a cassette in the player if you
are not listening to it, especially if it is hot
outside.
 Store cassettes in their cases and out of
direct sunlight.
 Avoid using cassettes with a total playing
time longer than 100 minutes (50 minutes
per side). The tape used in these cas-
settes is thin and could get stuck or
tangled in the cassette player.