Page 56 of 390
Seat, seatbelt and SRS airbags
1-33
– CONTINUED –
HB1090BA
The lower anchorages (bars) are used for installing
a child restraint system only on the rear seat win-dow-side seating positions. For each window-side
seating position, two lower anchorages are pro-vided.
HG1030BA
The tether anchorages (upper anchorages) are pro- vided for all the seating positions (middle and both
window-side ones) of the rear seat.
HB1085BA
Page 57 of 390

Seat, seatbelt and SRS airbags
1-34
You will find marks “Child” at the bottom of the rear
seat seatbacks. These marks indicate the positions of the lower anchorages (bars).
HB1088BA
Each lower anchorage is located where the seat
cushion meets the seatback.
1. Use the “Child” marks to locate the two lower an-
chorages (bars) for the position where you want to
install the child restraint system.
2. While following the instructions supplied by the
child restraint system manufacturer, connect the
connectors of the child restraint system to the loweranchorages.
When the connectors are fastened, make sure that
the adjacent seatbelts are not caught. If your child restraint system is of a flexible attach-
ment type (which uses tether straps to connect the
child restraint system proper to the lower anchor-
ages), firmly tighten the straps after connecting theconnectors.
3. Connect the top tether hook to the tether anchor-
age and firmly tighten the tether.
For information on how to set the top tether, read the
following “
Top tether anchorages ”.
4. Before seating a child in the child restraint sys-
tem, try to move seat back and forth to verify that it
is held securely in position.
If you have any question concerning this type of
child restraint system, ask your SUBARU dealer.
WARNING
When you install a child restraint system, fol- low the manufacturer ’s instructions supplied
with it. After installing the child restraint sys-tem, check to ensure that it is held securely in
position. If it is not held tight and secure, the
danger of your child suffering personal injuryin the event of an accident may be increased.
Page 59 of 390
Seat, seatbelt and SRS airbags
1-36
Wagon: There is an anchorage for the center seat-
ing position at the rear end of the ceiling, and
anchorages for each of the two window-side seating
positions on the rear wall of the cargo area.
To hook the top tether
n Sedan
HGS035BB
F: Front of vehicle
1) Top tether hook
2) Upper anchorage
Fasten the top tether hook of the child restraint sys-
tem to the appropriate upper anchorage.
Tighten the top tether securely. n
Wagon
HGS031BA
1. Remove the headrest at the seating position
where the child restraint system has been installed with the seatbelt or lower anchorages; lift up the
headrest while pressing the release button. Store the
headrest in the cargo area. Avoid placing the head-
rest in the passenger compartment to prevent it from
being thrown around in the passenger compartment
in a sudden stop or a sharp turn.
Page 60 of 390
Seat, seatbelt and SRS airbags
1-37
– CONTINUED –
HGS032BB
Center
F: Front of vehicle
1) Top tether hook
2) Upper anchorage
HGS033BB
Window-side
F: Front of vehicle
1) Top tether hook
2) Upper anchorage
2. Fasten the top tether hook of the child restraint
system to the appropriate upper anchorage.
3. Tighten the top tether securely.
CAUTION
Always remove the headrest when mounting a
child restraint system with a top tether. Other- wise, it may happen that the top tether cannot
be fastened tightly.
Page 62 of 390