2002 PEUGEOT 807 warning light

THE ALARM
This provides two types of protection:
– exterior protection: it sounds if adoor, the tailgate, the bonnet or a
sunroof is opened.
– interior protection: it sounds if the volume inside the passenger com
partment changes (breaking of a
window or a movement inside the
vehicle).
Setting the alarm  Switch off the ignition and get out
of the vehicle.
 Set the alarm within five minutes
of getting out of the vehicle, by
locking or deadlocking using the
remote control (the red indicator
light, located in the centre of the
fascia and visible from the out
side, flashes once per second). Note:
if you wish to lock your vehicle
without setting the alarm, use the
door lock.
When the alarm is triggered, the
siren sounds and the direction indi
cator lights flash for thirty seconds.
After triggering, the alarm remains
set.
Warning: if the alarm has been trig
gered ten times in succession, on
the eleventh time it becomes inac
tive.
Note: if the red warning light, located
in the centre of the fascia, flashes
rapidly, the alarm has been triggered
while you were away from your vehi
cle. To stop it flashing, insert the
remote control key and switch on the
ignition.
Disarming
Unlock the vehicle with the remote
control key (the red indicator light,
located in the centre of the fascia,
goes out).
To set the alarm with exterior
protection only
If, while you are away from the vehi
cle, you wish to leave a window
partially open or a pet inside the
vehicle, you should choose exterior
protection only.
 Close the sunroofs, 
Switch off the ignition,
 In the next ten seconds, press
button A, located on the lefthand
side of the fascia, until the red
indicator light is on continuously,
 Get out of the vehicle,
 Within the next five minutes, set
the alarm by locking or deadlock
ing using the remote control (the
red indicator light, located in the
centre of the fascia, flashes once
a second).
Note: when the alarm is set but the
remote control does not operate:
 Unlock the doors with the key and
open the door. The alarm is
triggered.
 Switch on the ignition in the next
ten seconds. The alarm is dis
armed.
Incorrect operation
When the ignition is switched on, if
the red indicator light, located in the
centre of the fascia, comes on for ten
seconds, there is a fault in the siren
connection.
Contact a PEUGEOT dealer to have
the system checked.
Do not make any modifi
cations to the alarm sys
tem as this could cause
faults.
YOUR 807 IN DETAIL
106
18-11-2002

YOUR 807 IN DETAIL107
Electric sliding
side doors
Opening / Closing from the front:
– press the corresponding switch
B
to open or close.
An audible signal accompanies the
opening and closing of the door.
Opening / Closing from the
2 nd
row:
– press the corresponding switch C
to open or close.
Disarming the 2 nd
row controls:
– press the rear electric functions disarming switch.
THE DOORS
Opening the doors
from outside
Opening the doors
from inside
Note:
the door opening switches do
not function when the vehicle is
deadlocked. Locking / Unlocking from the
inside
Press button
A, the red warning light
comes on when the vehicle is locked
and switches off when it is unlocked.
This locks/unlocks the doors and the
tailgate.
Note: if the vehicle is locked or dead
locked from outside, the red warning
light flashes and button Adoes not
function. In this case, use the key or
the remote control for unlocking.
Automatic central locking
Your vehicle locks automatically
when you are driiving (at a speed of
more than 6 mph).
You can deactivate this function or
reactivate it.
To switch off
Press and hold button A.
Deactivation of the function is
accompanied by an audible signal.
To switch on
Press and hold button A.
Activation of the function is accom
panied by an audible signal and the
message ''Automatic locking of
the doors activated'' on the
multi–function display.
"Door open" alert
With the engine running or the vehicle
moving, a diagram accompanied by
an audible signal, locating the door
on the multi–function display, warns
you that a door is not properly closed.
18-11-2002

YOUR 807 IN DETAIL107
Electric sliding
side doors
Opening / Closing from the front:
– press the corresponding switch
B
to open or close.
An audible signal accompanies the
opening and closing of the door.
Opening / Closing from the
2 nd
row:
– press the corresponding switch C
to open or close.
Disarming the 2 nd
row controls:
– press the rear electric functions disarming switch.
THE DOORS
Opening the doors
from outside
Opening the doors
from inside
Note:
the door opening switches do
not function when the vehicle is
deadlocked. Locking / Unlocking from the
inside
Press button
A, the red warning light
comes on when the vehicle is locked
and switches off when it is unlocked.
This locks/unlocks the doors and the
tailgate.
Note: if the vehicle is locked or dead
locked from outside, the red warning
light flashes and button Adoes not
function. In this case, use the key or
the remote control for unlocking.
Automatic central locking
Your vehicle locks automatically
when you are driiving (at a speed of
more than 6 mph).
You can deactivate this function or
reactivate it.
To switch off
Press and hold button A.
Deactivation of the function is
accompanied by an audible signal.
To switch on
Press and hold button A.
Activation of the function is accom
panied by an audible signal and the
message ''Automatic locking of
the doors activated'' on the
multi–function display.
"Door open" alert
With the engine running or the vehicle
moving, a diagram accompanied by
an audible signal, locating the door
on the multi–function display, warns
you that a door is not properly closed.
18-11-2002

YOUR 807 IN DETAIL111
FILLING
THE
FUEL TANK
Low fuel level
When the tank's minimum
level is reached, this warn
ing light comes on, accom
panied by the message
"Fuel level low" on the
multi–function display.
You have enough fuel left to cover
approximately 30 miles (50 km).
If the warning light flashes, this
indicates a fuel gauge malfunction.
Contact a PEUGEOT dealer.
If the warning light flashes, accom
panied by the message "Fuel circuit
disarmed" , this indicates that the
fuel supply has been cut off.
Restore the supply (refer to the
corresponding section). The tank must be filled with fuel with
the engine off
.
 Open the fuel filler flap.
 Insert the key then turn it to the
left.
 Remove the cap and attach it to
the clip located on the inside of
the flap.
A label on the inside of the flap indi
cates which type of fuel to use.
If you fill your tank, do not continue
after the third cutoff of the pump
nozzle. This could result in vehicle
malfunctions.
The capacity of the tank is approx
imately 18 gallons (80 litres).  After filling the tank, lock the cap
and close the flap.
When the fuel filler flap isopen, a system limits theopening of the rear left
sliding side door. The keycannot be removed from
the capÕs lock until the cap is refit-ted on the tank.
18-11-2002

YOUR 807 IN DETAIL
118
Trip computer configuration
This function allows inputting of the
distance to the destination (when
guidance is not activated; otherwise
the information is given by the navi
gation) and also changing of the
units (°C or °F, km and litres or miles
and gallons).
Diagnostics
This function tells you the warnings,
the quantity of emergency fuel and
the GPS cover present at the time
consulted.
Note:
these warnings have previous
ly been displayed in the form of mes
sages and/or warning lights on the
control unit.
There are 6 categories of diagnostics :
engine diagnostics (warnings linked to the engine, gearbox
etc....),
brake diagnostics,
suspension diagnostics (warnings linked to the suspension, ESP
etc....),
wheel diagnostics (warnings linked to tyres),
door and window diagnostics,
passenger compartment diagnos tics. Distance to destination
When guidance is not activated, this
enables an approximate value to be
entered to make all the trip computer
calculations possible.
Specific features of the
monochrome screen CT and
the colour screen DT
General menu
Press the
"MENU"button to access
the general menu.
Select the icon ''Trip computer''
using the dial, then validate to
access the ''Trip computer'' menu.
The ''trip computer'' menu offers var
ious choices:
Trip computer configuration,
Diagnostics.
'Trip computer' context menu
The context menu associated with
the "Trip Computer" application
appears as a superimposed display
when the Trip Computer is the appli
cation currently being used in the
main screen window.
Briefly press the continuous applica
tion 'Trip computer' button to select
one of the following functions:
Warnings log,
Distance to destination.
18-11-2002

Horn
Press one of the spokes or
the centre of the steering
wheel.
YOUR 807 IN DETAIL
122
Manual adjustment of the
headlamps
Depending on the load in your vehi
cle, adjusting the beam of your head
lamps is recommended.
0 1 or 2 people in the front seats.
1 5 people.
2 6 to 8 people.
3 Driver + maximum authorised
loads.
Initial setting is position 0.
Automatic adjustment of
headlamps
Refer to the paragraph on Lighting
under the section entitled 'Towing a
trailer...'. Hazard warning lights
Press the button, the direction indi
cators flash.
They can operate with the ignition
off.
Steering wheel height and
depth adjustment
When the vehicle is stationary,
unlock the steering wheel by lower
ing the lever
A.
Adjust the height and depth of the
steering wheel, then lock by pushing
lever Afully upwards.
Automatic lighting of hazard
warning lights*
When braking in an emergency,
depending on the force of decelera
tion, the hazard warning lights come
on automatically. They switch off
automatically the first time you accel
erate.
It is also possible to switch them off
by pressing the button on the fascia.
*According to destination.
18-11-2002

When this warning light
comes on, connected to the
STOPwarning light,
accompanied by a buzzer
and the message "Braking
fault" , it indicates that there is a mal
function of the electronic brake force
distribution, which can cause a loss of
control of the vehicle when braking.
Stop immediately.
In both cases, consult a Peugeot
dealer.
ANTILOCK BRAKING
SYSTEM (ABS) AND THE
ELECTRONIC BRAKE FORCE
DISTRIBUTION (EBFD)
The ABS, in conjunction with the elec
tronic brake force distribution, increas
es the stability and manoevrability of
your vehicle, particularly on poor or
slippery road surfaces.
Note: when changing wheels (tyres
and rims), make sure that these are
approved.
The antilock braking system comes
into operation automatically when
there is a risk of wheel lock.
When this warning light
comes on, accompanied by
a buzzer and the message
"ABS fault" , it indicates
that there is a malfunction
of the ABS, which can cause a loss
of control of the vehicle when brak
ing.
YOUR 807 IN DETAIL
128
To return to normal operation, pull
the lever upwards until a click is
heard.Illumination of this light,
accompanied by an audible
signal and the message
"handbrake on" on the
multi–function display, indi
cates that the handbrake is still on or
has not been properly released.
HANDBRAKE
Applying
When parking, pull the handbrake to
immobilize your vehicle.
Warning : when parking on a slope,
direct your wheels towards the pave
ment and pull the handbrake.
Releasing
Pull on the handle and press the but
ton to release the handbrake.
Disengaging
Apply the handbrake.
Pull the button located at the end of
the handbrake forwards.
The handbrake lever lowers.
You can now pivot the seat. EMERGENCY BRAKING
ASSISTANCE SYSTEM
In an emergency, this system
enables the optimum braking pres
sure to be reached more quickly,
thus reducing the stopping distance.
It is triggered according to the speed
of activation of the brake pedal. The
effect of this is a reduction in the
resistance of the pedal and an
increase in braking efficiency. Normal operation of the ABS may
make itself felt by slight vibrations
of the brake system.
In emergency braking, press
very firmly without releasing
the pressure.
18-11-2002

Changing a memorised speed
To memorise a speed higher than
the previous one: press button 3;
 release it when you have
reached the required speed.
To memorise a speed lower than the
previous one:  press button 2;
 release it when you have
reached the required speed.
Cancelling the cruise control  place knob 1in the OFFposition
or switch off the ignition.
YOUR 807 IN DETAIL
130
CRUISE CONTROL
Cruise control enables the vehicle to
maintain a steady speed pro
grammed by the driver, regardless of
the road characteristics and without
the driver having to touch the accel
erator or brake pedals.
In order for it to be memorised, the
vehicle speed must be greater than
approximately 25 mph (40 km/h) and
fourth or fifth gear must be engaged.
Operation Place knob 1 in the ON
position.
A speed can be memorised.
Illumination of this indicator light indi
cates that the cruise control is on.  Place knob 1 in the OFF position
to cancel. Memorising a speed
As soon as you reach the chosen
speed, press button
2or 3. This
memorises the speed, which will be
maintained automatically.
Note: It ispossible to accelerate
momentarily without disarming the
cruise control.
Cancelling the memorised speed
If you wish to cancel the memorised
speed:  Press button 4or the brake or
clutch pedal.
The warning light goes out to indi
cate that the cruise control is dis
armed.
Recalling the memorised speed
After cancellation, press button 2 or
3 . Your vehicle will return to the last
memorised speed.
Illumination of the indicator light
indicates that the cruise control is
operating again.
Do not use cruise control
on slippery roads or in
heavy traffic.
18-11-2002