2002 Peugeot 607 Dag run flat

YOUR AT A GLANCE9
REAR PARKING
ASSISTANCE
This system, installed in the rear
bumper, detects any obstacle (per
son, vehicle, tree, gate, kerb...)
located behind the vehicle.
To activate
With the engine running, the sys
tem is activated as soon as
reverse gear is engaged; a bleep
sounds to inform you that it is
active.
The proximity information is
given by an audible signal, con
sisting of bleeps which become
more and more rapid as the vehi
cle approaches the obstacle.
When the distance between the
rear of the vehicle and the obsta
cle is less than approximately
twentyfive centimetres, the
signal becomes con
tinuous.The system ceas
es to be active
when you change
to neutral. TYRE UNDERINFLATION
DETECTION
Sensors check the tyre pressure
during driving, and trigger a warn
ing if there is a malfunction (speed
greater than 15 mph (25 km/h).
Tyre underinflation
When this warning light
comes on, accompanied
by a bleep and the mes
sage 'Tyre(s) pressure
low', have the tyre pressure
checked as soon as possible.
Puncture
Display of this warning
light, accompanied by an
audible signal and the
message 'Punctured
tyre(s) detected', is followed by
illumination of the STOPwarning
light.
Stop immediately, avoiding all
abrupt manoeuvres with the
steering wheel and the brakes.
Change the damaged (punctured
or very underinflated) wheel and
have the tyre pressure checked
as soon as possible.
Note: if the damaged wheel is
stored temporarily in the boot, it
will again send this message as a
reminder of the necessity of hav
ing it repaired. This will prevent a
similar warning being displayed. Sensor(s) not detected
Display of this warning
light, accompanied by an
audible signal and the
message 'X tyre pres
sure sensor(s) missing', indi
cates that one or more wheels
are not being detected.
Contact a PEUGEOT dealer to
replace the faulty sensor(s).
Warning: this message is dis
played when one of the wheels is
at a distance from the vehicle
(being repaired) or when a wheel
without a sensor is fitted (winter
fitting).
This system does not eliminate
the need to check the tyre
pressure regularly.
128139

INSTRUMENTS AND CONTROLS33
Tyre underinflation warning light
Display of this warning light is acompanied by an audible si
gnal and the message 'Tyre(s) pressure low' on the
multifunction display.
Have the tyre pressure checked as soon as possible.
Low coolant level warning light
Display of this warning light is accompanied by an audible si gnal and the message 'Cooling circuit level low' on
the multifunction display .
Stop immediately.
Warning: wait for the engine to cool before topping up.
The cooling system is pressurised.
In the event of breakdown and to prevent the risk of scalding , unscrew the cap by two turns to allow the pressure to drop.
When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
Seat belt not fastened warning light
Display of this warning light is accompanied by an audible si gnal and the message 'Seat belt not fastened' on the
multifunction display.
With the engine running, the warning light comes on when the driver's seat belt is unfastened.
Electronic immobiliser warning light
Display of this warning light is accompanied by an audible si gnal and the message 'Electronic theft protection
faulty' on the multifunction display.
It indicates a malfunction of the electronic immobiliser system.
Contact a PEUGEOT dealer.

Notes
It is only possible to change from one gear
to another if the vehicle speed and engine
speed permit. If they do not, the vehicle will
operate temporarily in automatic mode.
When the vehicle is stationary or moving
very slowly, the gearbox automatically
selects gear M1.
Programmes S(sport) and
(snow) do not
operate in manual mode.
Operating abnormality
Any operating abnormality is
shown by illumination of this warn
ing light, accompanied by an audi
ble signal and the message 'Auto
matic gearbox faulty' on the
multifunction display.
In this situation the gearbox operates in
downgrade mode (locked in 3rd gear). You
may feel a substantial knock when selecting
reverse from Pto Rand from Nto R(this will
not cause any damage to the gearbox).
Do not exceed 60 mph (100 km/h).
Contact a PEUGEOT dealer as soon as
possible.
If the battery is flat and the
lever is in position P, it will
be impossible to change
to another position.
YOUR 607 IN DETAIL 123
Automatic operation
Automatic changing of the
four gears:
select function Din the gate.
The gearbox always selects the most
suitable gear according to the follow
ing parameters:
– the style of driving,
– the road profile,
– the vehicle load.
The gearbox is then operating in auto
adaptive mode, without any action on
your part.
WARNING
Never select function N when the vehi
cle is moving.
Never select functions Por Runless
the vehicle is stationary.
Never change betwen functions to
optimise braking on a slippery surface.
Notes
For immediate maximum acceleration
without touching the gear lever, press
the accelerator pedal down as far as it
will go (kickdown). The gearbox will
automatically change down or main
tain the gear selected until maximum
engine speed is reached.
When the brake is applied, the gear
box will automatically change down in
order to provide efficient engine brak
ing.
If you take your foot off the accelerator
suddenly, the gearbox will not change
to a higher gear for reasons of safety. Sport and snow programmes
In addition to the autoadaptive pro
gramme, there are two special pro
grammes.
The programme is displayed on the
instrument panel screen.
Sport programme
Press button
Sonce the vehicle has
been started and function Dselected.
The gearbox automatically favours
sporty driving and more dynamic
acceleration.
Snow programme
This programme improves starting
and drive when traction is poor.
Press button once the vehicle has
been started and function Dselected.
The gearbox adapts to driving on slip
pery roads.
Note: you can return to the autoadap
tive programme at any time.
Press button Sor again to switch
off the programme you are in.
Manual operation
Manual changing of the four gears:
select function Min the gate,
push the lever to the + sign to
change to a higher gear,
pull the lever to the sign to change
to a lower gear.
You can change from position D(dri
ving in automatic mode) to position M
(driving in manual mode) at any time.