2002 Peugeot 607 Dag lights

Rear sunblind
The blind, fitted to the rear parcel
shelf, is intended to protect occu
pants from the glare of the sun and
the lights of cars behind.
Sunblind operation:
With the engine running:  Briefly press button Don the cen
tre console to open it out.
 Briefly press button Dagain to
store it away.
Warning: Do not place anything on
the blind, to avoid it being damaged. Rear armrest
This provides access to the ski flap
from the passenger compartment.
It has two cup holders. Storage compartments
There are two storage compartments
located behind the side trim of the
boot.
The left side storage compartment is
fitted with a CD storage bracket for
eight single CDs and one double CD.
To access a storage compartment:
Push the handle downwards and
fold down the panel.
YOUR 607 IN DETAIL 121
Rear shelf compartment
This is provided for the storage of a
first aid kit.
The catch on the lid is designed to
withstand a weight of 9 lbs (4kg) on
impact.Luggage net
Six stowing rings allow the net to be
placed in different positions.

YOUR 607 IN DETAIL
126
ELECTRONICALLY
CONTROLLED SUSPENSION
T
he suspension adapts automatically
and instantly to different driving styles
and road characteristics, improving the
comfort of the occupants and the vehi
cle's road holding capabilities.
The suspension favours smooth shock
absorption, ensuring a comfortable ride,
but as soon as conditions demand a
change (sporty driving, tight bends,
avoidance action, etc.) it automatically
selects firmer shock absorption, guaran
teeing optimum road holding.
Selecting the SPORT position
 Press switch 1, the SPORT indi
cator light will come on,
accompanied by an audible
signal.
In this position, the suspen
sion is maintained in the
SPORT position.
To return to automatic
operation
 Press switch 1again. The indicator
light will go out and the
AUTO indicator light comes
on, accompanied by an audi
ble signal.
Operating check
This is confirmed by the switch light
and the indicator lights. The switch
light comes on for approximately three
seconds every time the ignition is
switched on.
If the switch light flashes or if the indi
cator light comes on, accompanied by
an audible signal and the message
' Hydraulic suspension pressure
insufficient' , contact your PEUGEOT
dealer.
Handbrake
Locking
When parking, pull the handbrake to
immobilise your vehicle.
Warning: when parking on a slope,
direct your wheels towards the pave
ment and pull on the handbrake.
Unlocking
Pull the handle and press the button
to release the handbrake.

Operating check
When a malfunction of the sys
tems occurs, the switch light
flashes and the warning light
comes on, accompanied by an
audible signal and the mes
sage 'ESP/ASR system faulty' on the
multifunction display.
Contact a PEUGEOTdealer to have the
system checked.
YOUR 607 IN DETAIL
125
The ESP system offers
exceptional safety in normal
driving, but this should not
encourage the driver to take
extra risks or drive at high
speed.
The correct functioning of this sys
tem depends on observation of the
manufacturer's recommendations
regarding wheels (tyres and rims),
the braking components and the
electronic components, as well as
the PEUGEOT assembly and opera
tion procedures.
After an impact, have the system
checked by a PEUGEOT dealer.
Disarming the ASR/ESP
systems
In exceptional conditions (starting a
vehicle which is bogged down, stuck
in snow, on soft ground...), it may be
advisable to disarm the ASR system,
so that the wheels can move freely
and regain grip.
Press the 'ESP OFF'
switch, located under the
steering wheel to the left.
The switch lights up and the
warning light comes on,
accompanied by an audible
signal and the message
'ASR/ESP system deacti
vated' on the multi–function
display : the ASR and ESP systems
no longer have any effect on the
engine operation.
These are triggered again :
 automatically if the ignition is
switched off,
 manually by pressing the switch
again.DYNAMIC STABILITY
CONTROL (ESP) AND
TRACTION CONTROL (ASR)
These systems are linked and com
plementary to the ABS system.
In the event of a significant variation
between the trajectory of the vehicle
and the path required by the driver,
the ESP system acts automatically
on the engine and on the brake of
one or more wheels, to put the vehi
cle back on course. The traction con
trol (ASR) system optimises drive, in
order to avoid the wheels slipping, by
acting on the brakes of the drive
wheels and on the engine. It also
enables the directional stability of the
vehicle to be improved during accel
eration.
Operation of the ESP
and ASR systems
When one of the two sys
tems is in operation, this
indicator light flashes.

PRACTICAL INFORMATION 143
CHANGING A BULB
Front lights
In the engine compartment, remove the style cover secured
by one or two butterfly screws, a plastic retainer clip and
two screws.
Note:
handle the bulbs with a dry cloth.
1 Dipped beam headlamps: H755W or Xenon bulb.
WARNING: RISK OF ELECTROCUTION
Xenon bulbs must be replaced by a PEUGEOT
dealer.
2 Main beam headlamps: H155W.
 Turn the protective cover of the faulty bulb a quarter
of a turn and remove it.
 Disconnect the connector.
 PPress the end of the securing clip to free it. Change
the bulb.
 When fitting the new bulb, ensure that the direction
notches are positioned correctly and the securing
clip is fixed properly. 
Reconnect the connector.
 Refit the protective cover.
The headlamps are fitted with polycarbonate glass with a
protective coating. Do not clean them with a dry or abra
sive cloth, nor with a detergent or solvent product.
3 Side lights: W 5 W.
 Pull the socket rearwards, remove the bulb and
change it.
4 Direction indicators: PY 21 W (amber).
 Turn the bulb holder a quarter turn and remove it.
 Change the bulb.
 Refit the style cover.
Front foglamps: H1 55 W.
Note: In certain climatic conditions (low temperature,
humidity), condensation on the inside surface of the
headlamp glass is normal ; it disappears a few minutes
after the lights are switched on.

Rear lights
Rear wing lights
1 Direction indicators: PY 21 W (amber).
2 Brake lights/side lights: P21/5 W.
 Detach the luggage net.
 Lift the boot carpet with the lifting
hook. Secure this hook behind
the boot seal.
 Unclip the lower part of the sill
trim, then dislodge it by pulling
upwards.
 Remove the plastic retainer clip
securing the side trim to the
floor. 
Unclip the side trim.
 Remove the two butterfly nuts
securing the light.
 Remove the eyelet.
 Take out the lamp.
 Turn the lamp holder a quarter
turn.
 Change the faulty bulb.
 Lock the bulb holder in place.
When refitting it, ensure that the
lamp is correctly positioned and
secured.
PRACTICAL INFORMATION
144
Direction indicator repeaters:
WY 5 W (amber).
 Push the repeater forwards or
backwards and release the
assembly.
 Hold the connector and turn the
transparent cover a quarter turn.
 Change the bulb.
Amber coloured bulbs
(direction indicators and
side repeaters) must be
replaced with bulbs of
identical specification and
colour.

Rear lights
Rear wing lights
1 Direction indicators: PY 21 W (amber).
2 Brake lights/side lights: P21/5 W.
 Detach the luggage net.
 Lift the boot carpet with the lifting
hook. Secure this hook behind
the boot seal.
 Unclip the lower part of the sill
trim, then dislodge it by pulling
upwards.
 Remove the plastic retainer clip
securing the side trim to the
floor. 
Unclip the side trim.
 Remove the two butterfly nuts
securing the light.
 Remove the eyelet.
 Take out the lamp.
 Turn the lamp holder a quarter
turn.
 Change the faulty bulb.
 Lock the bulb holder in place.
When refitting it, ensure that the
lamp is correctly positioned and
secured.
PRACTICAL INFORMATION
144
Direction indicator repeaters:
WY 5 W (amber).
 Push the repeater forwards or
backwards and release the
assembly.
 Hold the connector and turn the
transparent cover a quarter turn.
 Change the bulb.
Amber coloured bulbs
(direction indicators and
side repeaters) must be
replaced with bulbs of
identical specification and
colour.

145
PRACTICAL INFORMATION
Boot lid lights
1 Reversing lights: P 21 W.
2 Fog lamps: P 21 W.
 Remove the three plastic retain
er clips securing the cover trim
(those nearest to the lamp).
 Move aside the trim. 
Turn the bulb holder a quarter
turn.
 Change the faulty bulb. Number plate lights:
W 5 W.
 Remove the transparent cover
using a screwdriver blade.
 Change the faulty bulb.

Fuse N° RatingFunctions
10* 20 AAutomatic headlamp lighting control unit.
11* 70 A Builtin systems interface.
12* 70 A Ignition supply (+ve accessories / ignition controlled +ve).
13* 20 A Automatic headlamp lighting control unit.
14 15 A Double injection relay supply.
15* Not used.
16* Not used.
17* 30 A ESP hydraulic unit.
18 30 A Ignition supply (+ starter).
19 20 A Variable suspension control unit.
20 10 A Fan unit relay Cruise control safety switch Manual gearbox clut ch switch
Manual gearbox reversing lights switch or automatic gearbox multifu nction switch
Automatic headlamp lighting control unit Vehicle speed senso r Coolant level sensor
Water in diesel sensor Power switch control unit relay.
21 5 A Automatic gearbox control unit Automatic gearbox multifunction sw itch.
22 25 A ESP control unit.
23 15 A Diesel heating.
24 5 A Engine management control unit – Dual control control unit.
25 10 A Fuel pump.
26 30 A Driver's seat memory control unit.
27 25 A Double injection relay supply.
28 10 A Throttle housing deicing resistor, Intake pilot solenoid val ve Flow meter Piston deactivator
injectionpump Oil heating.
29 30 A Air pump, diesel additive control unit Diesel additive inje ctor.
30 Cannot be used.
31 5 A Automatic gearbox shift lock.
32 10 A ESP or ABS control unit.
33 15 A Automatic gearbox control unit Automatic gearbox multifunction sw itch (except reversing lights) Automatic
gearbox sequential control.
34 5 A Oxygen sensors Exhaust gas recirculation solenoid valve, Exhaust gas reci rculation throttle solenoid valve
Turbo pressure regulation solenoid valve..
PRACTICAL INFORMATION 149