YOUR 607 IN DETAIL103
Make a careful note of the number on each key. The key number i
s coded on the label attached to the key. If
the key is lost, your PEUGEOT dealer can rapidly supply you with ne w keys.
The high frequency remote control key is a high performance system.
Do not operate it while it is in your pocket as there is a p ossibility that it may unlock your vehicle without your
knowledge.
The remote control cannot operate if the key is in the ignit ion, even if the ignition is switched off, except for
reprogramming.
Do not operate the deadlock if there is someone inside the vehicle.
As a safety measure (when there are children on board), remove the i gnition key when leaving the vehicle, even for a
short time.
Do not handle the buttons of your remote control when out of range of your vehicle as you run the risk of stopping it from
working. It would then be necessary to reprogramme the remote cont rol.
When buying a second hand car:
– Ensure that you are given the confidential card;
– Have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones
which can start your vehicle.
Do not make any modifications to the electronic engine immobil iser system.
Aflat battery prevents
the engine from starting.
PRACTICAL INFORMATION
150
CHANGING A WINDSCREEN
WIPER BLADE
Placing the wiper blades in the
maintenance position
Less than one minute after switch
ing off the ignition, activate the
windscreen wiper stalk to position
the blades in the centre of the
windscreen (maintenance posi
tion).
Replacing a blade Lift the arm, then unclip the blade
and remove it.
Fit the new blade and fold down
the arm.
To park the blades, switch on the
ignition and operate the wind
screen wiper stalk.
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, sunroof, rear electric blind,
electric seats, audio equipment, tele
phone etc) can only be used for thir
ty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the
message "Economy mode active"
appears on the multi–function dis
play and the active functions are put
on standby.
REMOVING A MAT
When removing a mat on the driver's
or passenger's side, push back the
seat as far as possible and remove
the clips.
To remove a rear mat, push the cor
responding front seat forward and
remove the clip.
On refitting, position the mat and
press firmly to refit the securing clips.
LOAD REDUCTION
When driving, certain functions
(heated rear screen, heating system
for passenger compartment of diesel
vehicles, etc.) may be switched off
temporarily, depending on the level
of battery charge.
Reactivation of the functions on
standby is automatic, as soon as the
battery permits.
These functions are automatically
reactivated next time the vehicle is
driven.
Note:
if the telephone is being used
when economy mode starts, it will
still be possible to finish the call.
