2002 Peugeot 307 Break Dag warning

Passenger airbag disarming indicator light* Illumination of this warning light is accompanied by an audible signal and the message "Passenger air bag disarmed" on the multifunction
display.
If the passager airbag is disarmed, the indicator light comes on when the ignitionis switched on and remains on.
In all cases, if the warning light flashes; contact a PEUGEOT dealer.
Seat belt not fastened warning light With the engine running, this indicator light comes on when the driver's seat belt is not fastened.Low fuel level warning light The warning light comes on for three seconds when the ignition is switched on.
When this light comes on with the engine running, it is accompanied by anaudible signal and the message "Fuel level low"on the multifunction display.
When the warning light comes on, you have enough fuel to drive at least 30 miles (50 km). The tank capacity is approximately 13 gallons (60 litres).
This light flashes to indicate a malfunction of the fuel gauge.
Contact a PEUGEOT dealer. Air bag warning light This light comes on for a few seconds when the ignition is switched on. Illumination of this warning light, with the engine running, is accompa- nied by an audible signal and a message
"Air bag fault"on the multi-
function display indicating:
- a fault in the front air bags,or
- a fault in the side air bags or curtain air bags.
Contact a PEUGEOT dealer. Coolant temperature indicator When the needle is in zone
A, the
temperature is correct. When the needle is in zone B, the
temperature is too high. The central
STOP warning light flashes, accom-
panied by an audible signal and themessage "Coolant temp. high" on
the multifunction display.
You must stop immediately.
Warning: wait for the engine to cool
before topping up the level. The cooling system is pressurised. In the event of a breakdown and in order to avoid any risk of scalding,unscrew the cap two turns to allowthe pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS
32

YOUR 307 IN DETAIL35
THE MULTIFUNCTION DISPLAY Monochrome screen B This enables the following informa- tion to be displayed:
- the time,
- the date,
- the outside temperature (the ¡C
symbol flashes when there is a risk of ice),
- the radio displays,
- the status of the doors (door, tail- gate* or bonnet* open),
- the temporarily displayed warning messages (e.g.''battery low'') or information messages (e.g. "pas-senger air bag disarmed'') can becleared by pressing button 1or 2,
- the trip computer*.
* According to specification. Setting the parameters Keep button
1pressed for two seconds to access the settings.
Then, individual presses on button 1allow you to scroll through the various para-
meters:
- language in which the information is displayed,
- unit of distance (kms or miles),
- unit of temperature (degrees Celsius or Fahrenheit),
- time format (12 then 24 hour mode),
- hour,
- minutes,
- year,
- month,
- day. Pressing button 2allows you to change the parameter selected. Maintain the
pressure for rapid scrolling.
After ten seconds without operation, the screen returns to the current display, the modified data are recorded.

FRONT SEATS
1. Forwards-backwards adjustmentLift the control and slide the seat forwards or backwards.
2. Access to rear seats (3 door) Pull the handle to fold the seatback and move the seat for-wards. On repositioning, the seat returns to its initial position.
Warning: no person or object
must prevent the seat from retur- ning to its initial position; a returnto this position is necessary forthe seat to lock in place.
3. Seat back angle adjustment Push the handle towards the
rear.
4. Driver's* or passenger's* seat height adjustment* Pull the handle upwardsor push it downwards as many times asnecessary to obtain the requiredposition.
YOUR 307 IN DETAIL
58
* According to specification.

5. Front heated seats control*Press the switch. The temperatu-
re is controlled automatically. Pressing the switch again stops operation. Note : the command for activation
of the heating of the seat(s) remains memorised for twominutes after the ignition has
been switched off.
6. Front armrests* These can be folded down andare removable.
To remove them, press the but- ton located between the armrestand the side of the seat and pullit.
7. Front head restraint height and angle* adjustment
To raise or lower the restraint, pull it forwards, sliding it at thesame time. The angle of the head restraint can also be adjusted*.
To remove the head restraint, place it in the top position, lift thelug using a coin and pull it for-wards and upwards at the sametime. To put it back in position, locatethe stems of the restraint in theholes, taking care to keep themin line with the seat back.
Active seat back (front seat) This possesses a device to prevent "whiplash". When there is an impact from the
rear, the action of the body on theseat back forces the head restraintforwards and upwards, preventingthe head being thrown backwards.
8. Storage drawers* There is a storage drawer under each front seat.
Ð To open it, lift and pull.
Ð To take it out, open to its full extent, press the ends of the slides and lift
it, then remove it completely.
Do not place heavy objects in thedrawers. Under the front passenger seat, the layout of the floor allows for storageof a first aid kit and a warning triangle(small version).
* According to specification. REAR HEAD RESTRAINTS These have a high position for when they are in use and a low position forwhen they are stored.
To lower the head restraints, press the lug. The head restraints are removable.
To remove them, pull upwards as far as the stop then press the lug.
YOUR 307 IN DETAIL
59
The adjustment is correct when the upper edge of thehead restraint is level withthe top of the head.
Never drive with the head restraints remo-ved; they should be inplace and correctlyadjusted.

5. Front heated seats control*Press the switch. The temperatu-
re is controlled automatically. Pressing the switch again stops operation. Note : the command for activation
of the heating of the seat(s) remains memorised for twominutes after the ignition has
been switched off.
6. Front armrests* These can be folded down andare removable.
To remove them, press the but- ton located between the armrestand the side of the seat and pullit.
7. Front head restraint height and angle* adjustment
To raise or lower the restraint, pull it forwards, sliding it at thesame time. The angle of the head restraint can also be adjusted*.
To remove the head restraint, place it in the top position, lift thelug using a coin and pull it for-wards and upwards at the sametime. To put it back in position, locatethe stems of the restraint in theholes, taking care to keep themin line with the seat back.
Active seat back (front seat) This possesses a device to prevent "whiplash". When there is an impact from the
rear, the action of the body on theseat back forces the head restraintforwards and upwards, preventingthe head being thrown backwards.
8. Storage drawers* There is a storage drawer under each front seat.
Ð To open it, lift and pull.
Ð To take it out, open to its full extent, press the ends of the slides and lift
it, then remove it completely.
Do not place heavy objects in thedrawers. Under the front passenger seat, the layout of the floor allows for storageof a first aid kit and a warning triangle(small version).
* According to specification. REAR HEAD RESTRAINTS These have a high position for when they are in use and a low position forwhen they are stored.
To lower the head restraints, press the lug. The head restraints are removable.
To remove them, pull upwards as far as the stop then press the lug.
YOUR 307 IN DETAIL
59
The adjustment is correct when the upper edge of thehead restraint is level withthe top of the head.
Never drive with the head restraints remo-ved; they should be inplace and correctlyadjusted.

YOUR 307 IN DETAIL
64
SEAT BELTS
To adjust the height of the front seat belts To lower the attachment point, squeeze control 1and slide it
downwards.
To raise the attachment point,squeeze control 1and slide it
upwards.
To lock the seat belts Pull the strap, then insert the buckle into the stalk. Pre-tensioning and force- limiting front seat belts* Safety in the event of a frontal impact has been improved by the introduc-tion of pre-tensioning and force-limi-ting front seat belts. Depending onthe seriousness of the impact, thepre-tensioning system instantly tigh-tens the seat belt firmly against thebody of the occupant. The pre-tensioning seat belts are armed when the ignition is on. The force-limiting device reduces the pressure of the seat belt against thebody of the occupant in the event ofan accident. Rear seat belts The three rear seats are all fitted with three-point inertia reel seat belts.The side seats are fitted with force-limiting devices.
To be effective, a seat beltmust be tightened asclose to the body as pos-sible.
Depending on the nature and theseriousness of the impact, thepre-tensioners may be triggeredbefore and independently of theair bags. In all cases of an air bag being triggered, the air bag warning lighton the instrument panel comeson. After an impact, have the system
checked by a PEUGEOT dealer. The system has been designed to be fully operational for ten years. Have it replaced after this period.

65
THE KEYS The keys allow you to switch on the ignition and to independently opera-te the locks on the front doors, thefuel filler cap, the glove box and thepassenger air bag disarming switch. Central locking
From the driver's door, the keys allow you to lock, deadlock* or unlock thedoors and tailgate, as well as fold backthe exterior mirrors*. If one of the doors or the boot is open, the central locking does not work; ableep indicates this when locking byremote control. The remote control performs the same functions at a distance.The remote control LockingPress button
Ato lock the vehicle.
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. Note : a long press on button A, in
addition to locking, automatically closes the windows* and the sun-roof*.
Vehicles fitted with deadlocking*
Warning: deadlocking* renders the
internal and external door locking controls inoperative. Pressing button Adeadlocks the
vehicle. This is confirmed by fixed lighting of the direction indicators forapproximately two seconds. Note: a long press on button Aper-
mits automatic closing of the win- dows* and the sunroof*, in additionto deadlocking.
A second press on button Awithin
five seconds of deadlocking changes
this to normal locking. This is confir-med by fixed lighting of the directionindicators for two seconds, followedby a brief sound from the horn.
YOUR 307 IN DETAIL
Unlocking Press button Bto unlock the vehicle
This is confirmed by rapid flashing of the direction indicators. Note: if the vehicle is locked and
unlocking is activated inadvertently without the doors being openedwithin 30 seconds, the vehicle will
lock automatically. Do not repeatedly press the buttons of your remote control out of range
of your vehicle. You risk causing itnot to work and the remote controlwould have to be reprogrammed. Locating your car
To locate your car, if you have loc- ked it, in a car park: press button A(the courtesy
lights come on and the direction indicators flash for a fewseconds).
* According to specification.

Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOT
dealer on the system. This code ishidden by a film which should be
removed only if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.Changing the battery of the remote control The information
"battery flat"is given
by an audible signal accompanied by the message "Remote control batte-
ry low" on the multifunction display.
To replace the battery, remove the boltthen unclip the casing using a coin atthe ring (CR2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control Switch off the ignition.
Switch the ignition on again.
Immediately press button A.
Switch off the ignition and remo- ve the remote control key from
the ignition lock. The remotecontrol is now working again.
YOUR 307 IN DETAIL
66
Electronic engine immobiliser This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone who
does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode is recognised and starting ispossible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the instrument panel, flashesrapidly when the ignition is switched
on (2nd notch on the ignition key,accompanied by an audible signaland the message "Anti-theft device
faulty" on the multifunction display.
WARNING: your vehicle is no longer
protected in this event. Contact a
PEUGEOT dealer as soon as pos-sible.