Page 47 of 160
YOUR 206 IN DETAIL
42
AUDIO RD3
Stalk movement Function
1 - Press (behind) Increase volume
2 - Press (behind) Decrease volume
1 + 2 - Simultaneous press Sound cut-off (mute); restoring of the sound by pressing any button
3 - Press Automatic search of higher frequencies (radio)
Selection of the next track (CD)
4 - Press Automatic search of lower frequencies (radio)
Selection of the previous track (CD)
5 - Press the end Change of source (radio/CD/CD changer)
6 - Rotation Selection of next station stored in memory (radio)
(clockwise) Selection of next CD
7 - Rotation Selection of previous station stored in memory (radio)
(anti-clockwise) Selection of previous CD
17-06-2002
Page 75 of 160
YOUR 206 IN DETAIL
74
Storage compartment
Ð Lift the cover to gain access to the
storage compartment.
Ð Ensure that the cover is locked correctly before folding back the seat cushion. Folding seat back (Allmodels)
Ð Remove the head restraint for
complete folding of the seat.
Ð Push either of the two handles 2
towards the rear to fold the seat back.
Note: with the modifiable seat, this
can be tilted or removed in order to
fold down the seat back horizontally.Modifiable front passenger seat Access to the storage compartment
Ð Push the seat as far back as pos- sible.
Ð Lift then pull the front of the seat to unlock it.
Ð Tilt the seat cushion forwards.
17-06-2002
Page 76 of 160
YOUR 206 IN DETAIL75
Removing the modifiable front passenger seat
Ð Push the seat as far back as pos- sible.
Ð Lift then pull the front of the seat to unlock it.
Ð Tilt the seat forwards.
Ð Pulling upwards, tilt the seat from left to right to make it easier to remove. Refitting the modifiable frontpassenger seat
Ð Push the seat as far back as pos-
sible.
Ð Engage the seat fastener in the clips.
Ð Fold back the seat.
17-06-2002
Page 78 of 160
YOUR 206 IN DETAIL
76
REAR SEATS
To fold the rear seat(s):
Ð lift the front of the seat cushion
1,
Ð tilt the seat cushion 1against the front seats,
Ð position the seat belt under the belt holder 2,
Ð pull control 3to unlock the seat back 4,
Ð remove or lower the head restraint,
Ð tilt the seat back 4.
Always start with the seat, never the seat back (risk of damage). When repositioning:
Ð fold up the seat back,
Ð fold back the seat cushion,
Ð reposition the lap belt and the buckles before locking the front of the seat cushion.
Take care not to trap the seat belts.
17-06-2002
Page 80 of 160

YOUR 206 IN DETAIL
78
"ISOFIX" MOUNTINGS
Available on the two side rear seats, and on the front passenger seat, theIsofix mountings allow for fitting of aspecial child seat , sold within the
PEUGEOT network. The locks incorporated in the child seat fit onto the Isofix mountingsand ensure safe, reliable and fast
assembly. In the front
, the child seat must be
fitted in the 'rear facing' position forchildren from birth to 13 kg: front
seat as far forward as possible so
that the body of the child seat is incontact with or as close as possibleto the fascia. In this case, it is essential to disarm the passenger air bag. There is a risk that the child may be killed or seriously injured if theair bag inflates. In exceptional cases, the child seat may be fitted in the 'forwards facing'position if the rear seats are alreadyoccupied by other children or if therear seats cannot be used (not pre-sent, folded down). In this case, usethe Isofix mountings, the restrainingcushion of the child seat and theseat belt and adjust the front pas-senger seat to the most rearward
position. The passenger air bag maybe left active. In the rear , the child seat may be fit-
ted in the 'rear facing' or 'forwards facing' position. In this case, thefront seat must be in mid-slideposition, with the seat backupright. The combined use of the Isofix mountings, the restraining cushionof the child seat and the seat belt iscompulsory for a 'forwards facing'seat. The special approved child seat is
the Isofix KIDDY seat. It can be usedin the "rear facing" position frombirth to 13 kg and "forwards facing"from 9 to 18 kg. This seat can also be used on seats not fitted with Isofix mountings: it isthen compulsory to attach it to thevehicle's seat using the three-pointseat belt. Follow the instructions for fitting the child seat in the manufactu-rer's instruction booklet.
17-06-2002
Page 82 of 160

YOUR 206 IN DETAIL
80
From 3 to 10 years (15 to 36 kg)"Recaro start'': installed in the rear with a three-point seat belt. The height, width and length of the seat must be adjusted according to the age and build of your child. "Klippan Optima": installed in the rear with a three-point seat belt. From the age of 6 years (approximately 22 kg), the booster is used on its own.
Remember, even for short journeys, to fasten the three-point seat belts or thechild seat straps, keeping the slack in relation to the child's body to a minimum.
To prevent the doors from opening accidentally, use the child-lock.Also, do not open the rear windows more than a third.
* According to current legislation in the country of destination.
** Unless the rear seats are already occupied by other children or the rear seats cannot be used (because they are missing or folded down). In this case, move the front passenger seat as far back as possible and leave the air bag active.
Never leave a child or an animal in a vehicle whichis exposed to the sunand has the windows clo-
sed. Never leave the keys within
reach of children inside the car. Disarm the passenger air bag when installing a '"earwardsfacing" child seat on the frontpassenger seat. Observe strictly the recommen- dations for assembling the childseat as shown in the child seatinstructions.4
5
17-06-2002
Page 84 of 160

YOUR 206 IN DETAIL
82
SEAT BELTS Seat belt height adjustment:
Ð to lower: pull the control and slideit downwards.
Ð to raise: slide the control upwards. To lock the seat beltsPull the strap, then insert the end into the buckle. Front seat belts with pre- tensioner and force limiter Safety in the event of front impacts has been improved by the introduc-tion of seat belts with pre-tensionerand force limiter for the front seats.Depending on the seriousness ofthe impact, the pre-tensioning sys-tem instantly tightens the seat beltsand pulls them against the bodies ofthe occupants. The pre-tensioning seat belts are active when the ignition is on. The force limiter eases the pressure of the seat belt on the body of theoccupant in the event of an acci-dent. Rear seat belts The rear seats are fitted with two three-point inertia reel seat beltsand a lap belt (one-piece rear seat)or with three three-point inertia reelseat belts (two-part rear seat, 1/3 -2/3).
To be effective, a seat belt must be tightenedas close to the body aspossible.
Depending on the nature andseriousness of the impact, thepre-tensioning system may betriggered before and indepen-dently of the air bags. In all cases, the air bag warning light on the instrument panelcomes on. Following an impact, have the system checked by a PEUGEOT
dealer. The system has been designed to be fully operational for tenyears. Have it replaced at the end of this period.
17-06-2002
Page 85 of 160

YOUR 206 IN DETAIL83
Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message ''Remote
control battery low'' on the multi-
function display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
THE KEYS The keys allow you to switch on the ignition and operate the passengerair bag disarming switch and the fuelfiller cap, as well as independentlyoperate the locks on the front doors. Central locking The keys allow you to lock or unlock the doors and tailgate from the frontdoors. If one of the doors, the tailgate (206 SW) or the rear screen (206 SW) isopen, the central locking does notwork. The remote control This performs the same functions as
the key, at a distance. LockingPress button
Ato lock the vehicle.
This is confirmed by fixed lighting ofthe direction indicators for approxi-mately two seconds. Unlocking Press button Bto unlock the vehicle.
This is confirmed by the rapid flashing of the direction indicators.
206 SW: Press and hold button Bto
unlock the vehicle and open the rear screen. Note: If the vehicle is locked and
unlocking is activated inadvertently, unless the doors are opened within30 seconds, the vehicle will lockautomatically (206 SW).
Avoid pressing the buttons of your remote control out of range of your
vehicle. You risk causing it not towork and the remote control wouldthen have to be reprogrammed. Locating your car
To locate your car in a car park, if you have locked it:
press button A, the courtesy
lights come on and the direction indicators flash for a fewseconds.
Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
Programming the remote control Switch off the ignition.
Switch the ignition on again.
Press button A.
Switch off the ignition and remo- ve the remote control key from
the ignition lock. The remotecontrol is now working again.
17-06-2002