2002 MERCEDES-BENZ CLK430 turn signal bulb

223 What you should know at the gas station
Technical
data Instruments
and controlsOperationDrivingInstrument
cluster displayPractical hints Car care Index •Engine oil
Engine oil level check, see page 114 and page 253.
Fill quantity between upper and lower dipstick
marking level: 2.1 US qt. (2.0 l).
Recommended engine oils, see Approved Service
Products sheet.
• Coolant
For normal replenishing, use water (potable water
quality).
For further information (e.g. anticorrosion/
antifreeze), see page 305.
• Spark plugs
Approved spark plugs, see page 303.
• Tire pressure
For tire pressure, refer to tire pressure label inside
the fuel filler flap. See page 267 for further details.•Air conditioner
R-134a refrigerant and special PAG lubricant, see
page 305.
•Bulbs
High and low beams: H7 (55 W),
low beam: Xenon (optional)
fog lamps: H1 (55 W),
turn signal lamps,
front 1156 NA (26.9/5 W/32/4 cp),
parking and standing lamps, front: H 6W (6 W),
side marker lamps, front: 5 W/4 cp,
turn signal lamps, rear: 21 W/24 cp,
stop, tail, parking and side marker lamps: 21/4 W,
tail and parking lamp: 5 W/4 cp,
rear fog lamp, driver’s side: 21 W/32 cp,
backup lamps: 21 W/32 cp,
license plate lamps: 5 W/4 cp.
J_C208_II.book Seite 223 Donnerstag, 31. Mai 2001 10:13 10

226 Malfunction and indicator lamps
Technical
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car care Index
Malfunction and indicator lamps
in the instrument cluster
General information:
If a bulb in the instrument cluster fails to light up
during the bulb self-check when turning the electronic
key in steering lock to position 2, have it checked and
replaced if necessary.
On-board diagnostic system
Check engine malfunction indicator lamp
Engine malfunction indicator lamp. If the
“CHECK ENGINE” malfunction indicator
lamp comes on when the engine is running,
it indicates a malfunction of the fuel management
system, emission control system, systems which impact
emissions, or the fuel cap is not closed tight (check the
fuel cap). If the “CHECK ENGINE” lamp is illuminated
continuously and the vehicle is driving normally, you
may still drive the vehicle, however, in all cases, we
recommend that you have the system checked at your
authorized Mercedes-Benz Center as soon as possible.
If the “CHECK ENGINE” lamp comes on continuously
and / or the vehicle is not driving normally (e.g.
malfunction of the fuel management system or running out of fuel), serious damage can occur to the emission
system. Please contact your authorized Mercedes-Benz
Center immediately.
The Sequential Multiport Fuel Injection (SFI) control
module monitors emission control components that
either provide input signals to or receive output signals
from the control module. Malfunctions resulting from
interruptions or failure of any of these components are
indicated by the “CHECK ENGINE” malfunction
indicator lamp in the instrument cluster and are
simultaneously stored in the SFI control module.
If the “CHECK ENGINE” malfunction indicator lamp
comes on, have the system checked at your authorized
Mercedes-Benz Center as soon as possible.
With some exceptions, the control module switches off
the “CHECK ENGINE” malfunction indicator lamp if the
condition, causing the lamp to come on, no longer exists
during three consecutive cycles. See also page 228 for
fuel cap placement warning.
An on-board diagnostic connector is located in the
passenger compartment near to the parking brake
pedal, allowing the accurate identification of system
malfunctions through the readout of diagnostic trouble
codes.
CHECK
ENGINE
J_C208_II.book Seite 226 Donnerstag, 31. Mai 2001 10:13 10

276 Exterior lamps
Technical
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hintsCar care Index
Headlamp assembly (Halogen)
1Headlamp vertical adjustment screw
2Cover for low beam headlamp
3Cover for high beam headlamp, parking and
standing lampHeadlamp assembly (Xenon) (optional CLK 430)
4Bulb socket for turn signal lamp
5Electrical connector for low beam headlamp bulb
6Electrical connector for high beam headlamp bulb
7Bulb socket for parking and standing lamp
P82.10-2394-26
4
1
5
6
7
2
3
4
6
7
2
3P82.10-2395-26
5
1
J_C208_II.book Seite 276 Donnerstag, 31. Mai 2001 10:13 10

277 Exterior lamps
Technical
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hintsCar care Index Bulbs for low or high Beam
H7 (55 W)
Open hood.
Rotate cover (2 or 3) counterclockwise and remove. Pull
off electrical connector (5 or 6). Unhook clamping ring
and remove bulb.
Insert new bulb (seating properly in cutouts of bulb
socket), mount clamping ring. Reinstall and push
electrical connector on securely.
Reinstall cover (2 or 3).
Xenon (optional)
Bulb for low beamTurn signal lamp
1156 NA (26.9/5 W/32/4 cp bulb)
Open hood.
Twist bulb socket (4) counterclockwise and pull out.
Push bulb into socket, turn counterclockwise and
remove.
Insert new bulb in socket, push in and twist clockwise.
Reinstall bulb socket. Reinstall lamp assembly until
properly seated.
Parking and standing lamp
H6W (6Wbulb)
Open hood.
Rotate cover (3) counterclockwise and remove.
Twist bulb socket (7) counterclockwise and pull out.
Push bulb into socket, turn counterclockwise and
remove.
Insert new bulb in socket, push in and twist clockwise.
Reinstall bulb socket. Reinstall lamp assembly until
properly seated.
Reinstall cover (3).
Wa r n i n g !
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the lamp
and its components. We recommend that you have
such work done by a qualified technician.
J_C208_II.book Seite 277 Donnerstag, 31. Mai 2001 10:13 10

278 Exterior lamps
Technical
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hintsCar care Index
Taillamp assemblies
Open trunk lid.
Swing cover aside (bulbs 1, 2 and 3).
1Turn signal lamp (21 W/24 cp bulb)
2Stop, tail, parking, and side marker lamp
(21/4 W bulb)
3Tail and parking lamp (5 W/4 cp bulb)4Driver’s side:
Rear fog lamp (21 W/32 cp bulb)
5Backup lamp (21 W/32 cp bulb)
Twist bulb socket counterclockwise and pull out. Push
bulb into socket, turn counterclockwise and remove.
Insert new bulb in socket, push in and twist clockwise.
Reinstall bulb socket. Close cover (bulbs 1, 2 and 3).
1
2
3
P82.10-2080-26
P82.10-2083-26
4
5
J_C208_II.book Seite 278 Donnerstag, 31. Mai 2001 10:13 10

317 Index
Technical
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car careIndex Engine oil level indicator ...............................................114
ENGINE OIL LEVEL NOT WHEN ENGINE ON
(measuring) - multifunction indicator ....................115
Engine oils ...................................................................... 307
Capacities ...................................................................305
Enlarged cargo area ....................................................... 160
ESP (Electronic stability program) ............ 209, 218, 273
Control switch ...........................................................220
Malfunction and warning message ........................ 243
Malfunction indicator lamp ..................................... 229
Synchronizing ........................................................... 219
Warning lamp ............................................................229
Express opening and closing
See Power windows .................................................. 148
Exterior lamp malfunction
and warning message ..............................................240
Exterior lamp switch ......................................................116
Exterior lamps ................................................................ 275
Adjusting headlamp aim .......................................... 280
Fog lamps ....................................................................116
Headlamps ...................... 116, 240, 241, 276, 280, 294
Low and high beam .......................................... 119, 277
Parking lamps ................................................... 116, 277Replacing bulbs ........................................................ 275
Side marker lamp, front .......................................... 279
Standing lamps ..................................................116, 277
Taillamp assemblies ................................................ 278
Turn signal lamp ...............................................119, 277
FFirst aid kit ..................................................................... 248
Flat tire
See Changing wheels .............................................. 262
Flexible service system (FSS) .......................................111
Fuel
Gasoline additives .................................................... 309
Premium unleaded gasoline ..................222, 306, 308
Fuel cap placement warning ....................................... 228
Fuel filler flap
Manual release ......................................................... 287
Fuel requirements ........................................................ 308
Fuel reserve warning .................................................... 228
Fuels, coolants, lubricants etc. - capacities .............. 305
Fuses, electrical ............................................................. 249
J_C208_II.book Seite 317 Donnerstag, 31. Mai 2001 10:13 10

319 Index
Technical
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car careIndex
KKeys, changing battery ................................................. 283
Keys, vehicle ..................................................................... 24LLamps, exterior .............................................................. 275
Fog lamps ....................................................................116
Headlamp, adjusting ................................................280
Headlamps ...................... 116, 240, 241, 276, 280, 294
Low and high beam .......................................... 119, 277
Parking lamp ..................................................... 116, 277
Replacing bulbs ......................................................... 275
Side marker lamp, front ........................................... 279
Standing lamp ................................................... 116, 277
Taillamp assemblies ......................................... 116, 278
Turn signal lamp ............................................... 119, 277
Layout of poly-V-belt drive ............................................ 300
LIGHT SENSOR - malfunction
and warning messages ............................................ 241
Lighter ............................................................................. 159
LIGHTING SYSTEM - malfunction
and warning messages ............................................ 240
Limp home mode (Automatic transmission) ............. 201
Loading instructions ..................................................... 162Locking and unlocking .................................................... 29
Low engine coolant level warning .............................. 238
MMaintenance ................................................................... 177
Malfunction and indicator lamps
in the instrument cluster ........................................ 226
Malfunction and warning messages .......................... 232
ABS-SYSTEM ............................................................. 235
BATTERY/ALTERNATOR ......................................... 234
BRAKE ASSIST ......................................................... 235
BRAKE FLUID ........................................................... 236
BRAKE LINING WEAR ............................................ 236
COOLANT (coolant level) ........................................ 238
COOLANT TEMP.
(coolant temperature) ......................................... 239
DISPLAY DEFECTIVE
(engine control unit) ........................................... 233
DISPLAY DEFECTIVE
(several systems) ................................................. 233
ELEC. STABIL. PROGR. ............................................ 243
ENGINE FAN ............................................................. 237
ENGINE OIL LEVEL ................................................. 242
LIGHT SENSOR .......................................................... 241
LIGHTING SYSTEM .................................................. 240
J_C208_II.book Seite 319 Donnerstag, 31. Mai 2001 10:13 10