Page 327 of 399

324 Tires, Wheels
Te ch n i c a l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hintsCar care Index
Wheels
Replace rims or tires with the same designation,
manufacturer and type as shown on the original part.
See your authorized Mercedes-Benz Center for further
information.
See your authorized Mercedes-Benz Center for
information on tested and recommended rims and tires
for summer and winter operation. They can also offer
advice concerning tire service and purchase.
Tire replacement
Front and rear tires should be replaced in sets. Rims
and tires must be of the correct size and type. For
dimensions, see “Technical Data”.
We recommend that you break in new tires for
approximately 60 miles (100 km) at moderate speed.
Wa r n i n g !
The jack is designed exclusively for jacking up the
vehicle at the jack take-up brackets built into either
side of the vehicle. To help avoid personal injury,
use the jack only to lift the vehicle during a wheel
change. Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet away
from the area under the lifted vehicle. Always
firmly set parking brake and block wheels before
raising vehicle with jack.Do not disengage parking brake while the vehicle is
raised. Be certain that the jack is always vertical
when in use, especially on hills. Always try to use
the jack on level surface. Be sure that the jack arm
is fully seated in the jack take-up bracket. Always
lower the vehicle onto sufficient capacity
jackstands before working under the vehicle.
Page 328 of 399

325 Tires, Wheels
Te ch n i c a l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hintsCar care Index It is imperative that the wheel mounting bolts be
fastened to a tightening torque of 80 ft.lb. (110 Nm)
whenever wheels are mounted.
For rim and tire specifications, refer to “Technical Data”.Rotating wheels
The wheels can be rotated according to the degree of
tire wear while retaining the same direction of travel.
Rotating, however, should be carried out as
recommended by the tire manufacturer, before the
characteristic tire wear pattern (shoulder wear on front
wheels and tread center wear on rear wheels) becomes
visible, as otherwise the driving properties deteriorate.
Notes:
Thoroughly clean the inner side of the wheels any time
you rotate the wheels or wash the vehicle underside.
The use of retread tires is not recommended. Retread
tires may adversely affect the handling characteristics
and safety of the vehicle.
Dented or bent rims can cause tire pressure loss and
damage to the tire beads. For this reason, check rims for
damage at regular intervals. The rim flanges must be
checked for wear before a tire is mounted. Remove
burrs, if any.
Check and ensure proper tire inflation pressure after
rotating the wheels. For tire inflation pressure see
inside of fuel filler flap and also page 278.
Wa r n i n g !
Worn, old tires can cause accidents. If the tire tread
is badly worn, or if the tires have sustained
damage, replace them.When replacing rims, use only genuine
Mercedes-Benz wheel bolts specified for the
particular rim type. Failure to do so can result in
the bolts loosening and possibly an accident.
Page 391 of 399

388 Index
Te ch n i c a l
data Instruments
and controlsOperation DrivingInstrument
cluster displayPractical hints Car careIndex
Front airbags .................................................................... 72
Front center console storage compartment
ventilation .................................................................. 171
Front seat adjustment ..................................................... 48
Front seat backrest - locking and unlocking ............... 56
Fuel filler flap, manual release ................................... 354
Fuel reserve warning .................................................... 286
Fuse box .......................................................................... 311
Fuses ................................................................................ 311
GGarage door opener ....................................................... 221
Global locking
See Central locking system ....................................... 31
Glove box ......................................................................... 207HHazard warning flasher switch ................................... 151
Head restraint height ...................................................... 61
Head restraints
Rear seat ....................................................................... 60
Head restraints, front seats
Removal and installation ........................................... 54Headlamp cleaning system........................................... 147
Headlamp mode (HEADLAMPS) .................................. 144
Heated seats ...................................................................... 58
High beams
See Combination switch........................................... 148
IIdentification labels ...................................................... 369
Indicator lamps in the instrument cluster .......... 98, 282
Individual settings ......................................................... 121
"CONVENIENCE"
(vehicles with memory function) ...................... 134
"INSTRUMENT CLUSTER"....................................... 124
"LIGHTING"................................................................ 128
"VEHICLE" (audio and central locking system) ... 132
Infant and child restraint systems ................................ 82
Child seat mounts - LATCH type............................... 85
Installation ................................................................... 84
Inflating the collapsible spare tire ............................. 333
Information call
See Tele Aid............................................................... 228
Instrument cluster ........................................................... 96
Indicator lamps............................................................ 98
Instruments and controls ............................................... 18