2002 MAZDA MODEL MILLENIA ignition

1-2
Your Vehicle at a Glance
Form No. 8Q47-EA-01F
Dashboard Overview
Ashtray Auto tilt switchClimate control system
Lighter
Glove box
Audio system
Passenger-side air bag
Hazard warning flasher switchFog lights switch
Power window lock switch
Lighting control/Turn signals Instrument clusterWiper and washer lever
Driver-side air bag
Cruise control switchesIgnition switch
Center console
Hood release handle
Cup holder
Shift lever
Parking brake handle
Cruise main switch
Rear window defroster switch
TCS-OFF switch Coin box Power window
switches
Outside mirror switch
Audio control switch
(page 2-23)
(page 5-33)
(page 5-18)
(page 5-32)
(page 5-12)
(page 3-23)
(page 3-17)
(page 6-38)
(page 5-31)
(page 3-22)
(page 5-12)(page 5-36)
(page 5-37)
(page 6-2)
(page 6-10)
(page 5-8)
(page 2-23)
(page 6-36)
(page 5-16)
(page 6-37) (page 3-13)
(page 3-15)(page 6-39)
(page 6-39)
(page 6-38)
(page 5-4)
(page 5-2) (page 6-32)
J76Y.book Page 2 Wednesday, March 27, 2002 5:04 PM

2-4
Essential Safety Equipment
Seats
Form No. 8Q47-EA-01F

Head Restraint
Height adjustment
To raise a head restraint, pull it up to the
desired position.
To lower the head restraint, press the stop-
catch release, then push the head restraint
down.
Adjust the head restraint so that the top
parallels the top of the passenger’s ears,
never the passenger’s neck.Angle adjustment (Driver’s seat)
To adjust the head restraint angle apply
pressure to the top of the head restraint
and change the angle to the desired
position.

Seat Warmer
The front seats are electrically heated. The
ignition switch must be in the ON
position.
Press the switch to turn the seat warmer
on or off. When the switch is in the ON
position, the indicator light will come on.
Head Restraints Adjustment:
Driving with the head restraints
adjusted too low or removed is
dangerous. With no support behind
your head, your neck could be
seriously injured in a collision.
Always drive with the head restraints
inserted when seats are being used
and make sure they are properly
adjusted.
WARNING
Stop-catch release
J76Y.book Page 4 Wednesday, March 27, 2002 5:04 PM

2-14
Essential Safety Equipment
Seat Belt Systems
Form No. 8Q47-EA-01F
If the driver’s seat belt is not fastened
when the ignition switch is turned to the
ON position, the seat belt warning light
will remain on until the belt is fastened.
If the system does not operate correctly,
consult an Authorized Mazda Dealer.
Unnecessary Use of an Extender:
Using a seat belt extender when not
necessary is dangerous. The seat belt
will be too long and not fit properly.
In an accident, the seat belt will not
provide adequate protection and you
could be seriously injured. Only use
the extender when it is required to
fasten the seat belt properly.
Using an Improper Extender:
Using a seat belt extender that is for
another person or a different vehicle
or seat is dangerous. The seat belt will
not provide adequate protection and
the user could be seriously injured in
an accident. Only use the extender
provided for you and for the
particular vehicle and seat. NEVER
use the extender in a different vehicle
or seat.
Using an Extender That is Too Long:
Using an extender that is too long is
dangerous. The seat belt will not fit
properly. In an accident, the seat belt
will not provide adequate protection
and you could be seriously injured.
Don’t use the extender or choose one
shorter in length if the distance
between the extender’s buckle and the
center of the user’s body is less than
15cm (6 in).
WARNINGSeat Belt Warning Light
J76Y.book Page 14 Wednesday, March 27, 2002 5:04 PM

2-15
Essential Safety Equipment
Seat Belt Systems
Form No. 8Q47-EA-01F
If the driver’s seat belt is not fastened
when the ignition switch is turned to the
ON position, a beep will sound for about
6 seconds.
Seat Belt Warning Beep
J76Y.book Page 15 Wednesday, March 27, 2002 5:04 PM

2-31
Essential Safety Equipment
SRS Air Bags
Form No. 8Q47-EA-01F
Non-activation of side air bag
A side air bag will not normally inflate in the following cases:

Constant Monitoring
The following components of the air bag
systems are monitored by a diagnostic
system:
•SAS unit
•Air bag modules
•Side air bag crash sensor
•Related wiring
A diagnostic module continuously
monitors the systems’ readiness. This
begins when the ignition switch is turned
to the ON position and continues while
the vehicle is being driven.

Air Bag System Warning Light
If the air bag system is OK, the warning
light comes on when the ignition switch is
turned to the ON position or after the
engine is cranked. After about 6 seconds it
goes out.
A system malfunction is indicated when
the warning light constantly flashes, stays
on or doesn’t come on at all. If any of
these occur, consult an Authorized Mazda
Dealer as soon as possible. The system
may not work in an accident.
Collision from the rear. Collision from the front, but it may deploy
the front air bags.
J76Y.book Page 31 Wednesday, March 27, 2002 5:04 PM

2-32
Essential Safety Equipment
SRS Air Bags
Form No. 8Q47-EA-01F

Maintenance
The air bag systems do not require regular
maintenance. But if any of the following
occurs, take your vehicle to an Authorized
Mazda Dealer as soon as possible:
•The air bag system warning light
flashes.
•The air bag system warning light stays
on.
•The air bag system warning light stays
off when the ignition switch is turned
to the ON position.
•The air bags inflate.
Self-Servicing the Air Bag Systems:
Self-servicing or tampering with the
systems is dangerous. An air bag
could accidentally activate or become
disabled. This could cause serious
injuries. Never tamper with the
systems and always have an
Authorized Mazda Dealer perform all
servicing and repairs.
WARNING
Damaged Air Bag Sensors:
Driving with damaged air bag sensors
is dangerous. A collision, even one
not strong enough to inflate the air
bags, could damage the sensors. If
there was a subsequent collision, a
damaged sensor would not inflate the
air bags. Always have an Authorized
Mazda Dealer inspect the air bag
systems after a collision.
Removing Interior Parts:
Removing any components such as
the front seat, front dashboard, the
steering wheel or parts containing air
bag parts or sensors is dangerous.
These parts contain essential air bag
parts. The air bag could accidentally
activate and cause serious injuries.
Always have an Authorized Mazda
Dealer remove these parts.
Air Bag Disposal:
Improper disposal of an air bag or a
vehicle with live air bags in it can be
extremely dangerous. Unless all
safety procedures are followed, injury
can result. Ask an Authorized Mazda
Dealer how to safely dispose of an air
bag or how to scrap an air bag
equipped vehicle.
WARNING
J76Y.book Page 32 Wednesday, March 27, 2002 5:04 PM

3-2
Knowing Your Mazda
Form No. 8Q47-EA-01F
Doors and Locks
Your Mazda has two kinds of keys:
primary and secondary.
Here’s what the keys are used for:If you must leave your vehicle with
another person, such as a parking
attendant, protect items by locking the
glove box and trunk lid with the primary
key. Keep that key and give the other
person only the secondary key.
A code number is stamped on the plate
attached to the key set; detach this plate
and store it in a safe place (not in the
vehicle) for use if you need to make a
replacement key.
Also write down the code number and
keep it in another safe and handy place,
but not in the vehicle.
If your key is lost, consult your
Authorized Mazda Dealer with the code
number ready.
Keys
Keys and Children:
Leaving children in a vehicle with the
ignition key is dangerous. This could
result in someone being badly injured
or even killed. They could play with
power windows or other controls, or
even make the vehicle move. Don’t
leave the keys in your vehicle with
children.
Lock OperatesPrimary
keySecondary
key
Ignition switch
and steering
column lockYe s Ye s
Doors Yes Yes
Glove box Yes No
Trunk lid Yes No
WARNING
Primary
key
Secondary
key
Key code
number plate
J76Y.book Page 2 Wednesday, March 27, 2002 5:04 PM

3-3
Knowing Your Mazda
Doors and Locks
Form No. 8Q47-EA-01F
This system locks and unlocks the doors
and opens the trunk.
It can also help you signal for attention in
an emergency.
Press the button slowly and accurately.
Keyless Entry System
To avoid damage to the transmitter, do
not:
•Drop it.
•Get it wet.
•Disassemble it.
•Expose it to heat or sunlight.
CAUTION
NOTE
•The keyless entry system is
designed to operate up to about 2.5
m (8 ft) from the center of the
vehicle, but this may vary because
of local conditions.
•The system doesn’t operate when
the ignition switch is in the ON
position.
•If the transmitter does not operate
when pressing a button or the
operation range becomes too small,
the battery may be dead. To install a
new battery, refer to Maintenance
(page 3-5).
•Additional transmitters can be
obtained at an Authorized Mazda
Dealer. Up to 3 transmitters can be
used with the keyless entry system
per vehicle. Bring all transmitters to
an Authorized Mazda Dealer when
the electronic codes need to be
reset.
J76Y.book Page 3 Wednesday, March 27, 2002 5:04 PM