Page 140 of 250

6-24
Interior Comfort
Audio System
Form No. 8Q50-EA-01G
Operating the Radio
Radio ON
Press a band selector button ( or
) to turn the radio on.
Band selection
Choose AM by pressing the AM button
( ) and FM by pressing the FM1/2
button ( ).
The selected mode will be indicated. If
FM stereo is being received, "ST" will be
displayed. Tuning
The radio has the following tuning
methods: Manual, Seek, Scan, Preset
channel, and Auto memory tuning. The
easiest way to tune stations is to set them
on preset channels.
Manual tuning
Turning the manual tuning knob will
change the frequency higher or lower.
Band selector buttons Display
Channel preset buttons Scan button
Auto memory
button
Manual tuning knob
Seek tuning:
Higher
frequency
Lower
frequency
NOTE
If the FM broadcast signal becomes
weak, reception automatically changes
from STEREO to MONO for reduced
noise, and the "ST" indicator will go
out.
NOTE
If the power supply is interrupted (fuse
blows or the battery is disconnected),
the preset channels will be canceled.
J94S.book Page 24 Saturday, June 23, 2001 1:04 PM
Page 148 of 250

6-32
Interior Comfort
Audio System
Form No. 8Q50-EA-01G
Operating the In-Dash CD Changer
Inserting the CD
The CD must be label-side up when
inserting. The auto-loading mechanism
will set the CD and begin play. There will
be a short lapse before play begins while
the player reads the digital signals on the
CD.
The disc number and the track number
will be displayed. Normal insertion
1. Press the load button ( ).
2. When "In" is displayed, insert the CD.
Inserting CDs into desired tray number
1. Press and hold the load button ( )
for about 2 seconds until a beep is
heard.
2. Press the channel preset button for the desired tray number within 5 seconds
after the beep is heard.
3. When "In" is displayed, insert the CD.
Display
CD slot
Disc-in indicator
CD ejectbutton
CD play button
Random button
Repeat button
Disc up button Scan
button
Fast-forward button
Reverse
button
Track up
button
Track down
button
Disc down
button
Load button
Power/Volume knob
NOTE
A CD cannot be inserted while the
display reads "WAIT". A beeping
sound can be heard during this waiting
time. Simultaneously pressing the
power/volume knob and the load
button ( ) for about 2 seconds will
turn this beeping sound ON or OFF.
NOTE
The CD can not be inserted to the
desired tray number if the number is
already occupied.
J94S.book Page 32 Saturday, June 23, 2001 1:04 PM
Page 162 of 250
7-2
In Case of an Emergency
Form No. 8Q50-EA-01G
Parking in an Emergency
The hazard warning lights should always
be used when you stop on or near a
roadway.
The hazard warning lights warn other
drivers that your vehicle is a traffic hazard
and that they must take extreme caution
when near it.
Depress the hazard warning switch and all
four turn signals will flash at once.
Parking in an Emergency
NOTE
•The turn signals don ’t work when
the hazard warning lights are on.
• Check local regulations about the
use of hazard warning lights while
the vehicle is being towed. They
may forbid it.
Hazard warning flasher switch
J94S.book Page 2 Saturday, June 23, 2001 1:04 PM
Page 205 of 250
8-29
Maintenance and Care
Owner Maintenance
Form No. 8Q50-EA-01G
Light Bulbs
Headlights
Interior light
Courtesy lights
Front-turn signal lights/Parking lights
License plate lights
High-mount brake lightTrunk light
Rear-turn signal lights
Reverse lights
Brake lights/Taillights
J94S.book Page 29 Saturday, June 23, 2001 1:04 PM
Page 208 of 250
8-32
Maintenance and Care
Owner Maintenance
Form No. 8Q50-EA-01G
Replacing a Bulb (Front)
Replacing a Bulb (Interior)
To replace the map light bulbs, contact an Authorized Mazda Dealer.
Front-turn signal lights/Parking lights
Interior light Courtesy lights
J94S.book Page 32 Saturday, June 23, 2001 1:04 PM
Page 209 of 250
8-33
Maintenance and Care
Owner Maintenance
Form No. 8Q50-EA-01G
Replacing a Bulb (Rear)
Rear bulb access
To replace the turn-signal light, brake
light/taillight or reverse light bulb, pull the
center section of the plastic retainer and
remove the retainers and trunk end trim.
J94S.book Page 33 Saturday, June 23, 2001 1:04 PM
Page 210 of 250
8-34
Maintenance and Care
Owner Maintenance
Form No. 8Q50-EA-01G
License plate lights
Rear-turn signal lights
Brake lights/Taillights
Reverse lights
Trunk light
High-mount brake light
J94S.book Page 34 Saturday, June 23, 2001 1:04 PM
Page 215 of 250

8-39
Maintenance and Care
Owner Maintenance
Form No. 8Q50-EA-01G
Fuse panel (Driver’s side)
DESCRIPTION FUSE
RATING PROTECTED
COMPONENT
1 AUDIO 15A Audio system
2 ROOM 15A Interior lights,
Trunk light
3 S.ROOF 15A Sunroof
4 METER 10A Gauges, Reverse
lights
5 D.LOCK 30A Power door lock
6 HAZARD 15A Hazard warning
lights
7A/B&ABS 10A Air bag system,
Antilock brake system
8 —— —
9 A/C 10A Air conditioner
10 —— —
11 TURN 10A Turn signals
12 WIPER 20A Windshield
wipers and washer
13 P.WIND 30A Power windows
14 —— —DESCRIPTION FUSE
RATING PROTECTED
COMPONENT
15 RADIO 15A Audio system,
Socket, Outside mirror
16 ENGINE 10A Engine control
system
17 ILLUMI 10A Taillights,
License plate
lights, Parking
lights, Dashboard illumination
18 STOP 15A Brake lights,
Horn, Cruise control
19 CIGAR 15A Accessory
socket, Clock,
Radio, Outside mirror
20 —— —
21 —— —
22 P.SEAT 30A Power seat
23 M.DEF 15A Mirror defroster
24 P.POINT 15A Power point
J94S.book Page 39 Saturday, June 23, 2001 1:04 PM