2002 JEEP LIBERTY motor fan

[x] Cancel search: motor fan

Page 830 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual 8W-15 GROUND DISTRIBUTION
Component Page
A/C Compressor Clutch...................8Wa-15-6
A/C Low Pressure Switch.................8Wa-15-3
A/C- Heater Control...................8Wa-15-7, 8
Airbag Cont

Page 862 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual 8W-30 FUEL/IGNITION SYSTEM
Component Page
A/C Compressor Clutch.............. 8Wa-30-34
A/C Compressor Clutch Relay..... 8Wa-30-34, 2, 3
A/C High Pressure Switch............ 8Wa-30-29
A/C Low Pressure

Page 1058 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual Component Page
Left Power Seat Motors
(Midline/Highline)................ 8Wa-80-74
Left Power Seat Switch
(Midline/Highline)................ 8Wa-80-74
Left Rear Door Ajar Switch (Base)..... 8Wa-80-74

Page 1139 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual POWERTRAIN CONTROL MODULE-C3 (GAS) - LT. GRAY 32 WAY
CAV CIRCUIT FUNCTION
26 K226 18DB/WT FUEL LEVEL SENSOR SIGNAL
27 D21 18PK SCI TRANSMIT
28 - -
29 D32 18LG SCI RECEIVE (PCM)
30 D25 18YL/VT PCI BUS

Page 1162 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual CONNECTOR NAME/NUMBER COLOR LOCATION FIG.
Output Speed Sensor BK Left Side of Transmission 5
Overhead Map/Courtesy Lamp BK Overhead Console N/S
Oxygen Sensor 1/1 Upstream (2.4L) BK Right Side of Engin

Page 1225 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual ²Tapping the hole with a special Heli-Coil Tap, or
equivalent.
²Installing an insert into the tapped hole to bring
the hole back to its original thread size.
STANDARD PROCEDURE - ENGINE CORE AND
OIL

Page 1283 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual INTAKE MANIFOLD
DESCRIPTION
The intake manifold (Fig. 86) is made of a compos-
ite material and features 300 mm (11.811 in.) long
runners which maximizes low end torque. The intake
manifold uses singl

Page 1309 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual NOTE: Plastigage is available in a variety of clear-
ance ranges. Use the most appropriate range for
the specifications you are checking.
(4) Install the proper crankshaft bearings to
achieve the spec
Page:   < prev 1-8 9-16 17-24 25-32 next >