2002 HONDA CR-V Ignition switch

[x] Cancel search: Ignition switch

Page 211 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual µUse this position f or
your normal driving. The transmis-
sion automatically selects a suitable
gear f or your speed and acceleration.
You may notice the transmission
shif ting up at higher speeds

Page 212 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual µ
µ If you exceed the maximum speed
f or the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may f eel
the engine cut in and out. This is
caused

Page 213 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual This allows you to move the shif t
lever out of Park if the normal
method of pushing on the brake
pedal does not work. This procedure
is also used to release the Reverse
Lockout.Put a cloth on the edg

Page 228 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual When preparing to tow your CR-V,
make sure the transmission is
f illed to the correct level (see page). Do not overf ill.
Leave the key in the ignition
switch and the ignition switch in
ACCESSORY (I)

Page 229 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual Start the engine.
Press on the brake pedal. Shif t the
lever through all the positions (P,
R, N, D, 2, 1)
ShifttoD,thentoN.Letthe
engine run f or three minutes, then
turn of f the engine.
Release the

Page 312 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual If you have a f lat tire while driving,
stop in a saf e place to change it.
Stopping in traf f ic or on the shoulder
of a busy road is dangerous. Drive
slowly along the shoulder until you
gettoanexito

Page 322 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual Diagnosing why your engine won’t
start f alls into two areas, depending
on what you hear when you turn the
key to START (III):You hear nothing, or almost
nothing. The engine’s starter
motor does n

Page 323 of 372

HONDA CR-V 2002 RD4-RD7 / 2.G Owners Manual If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is dis-
charged or the connections are
corroded. Check the condition of the
battery and terminal connect
Page:   < prev 1-10 ... 9-16 17-24 25-32 33-40 41-48 49-56 next >