2002 HONDA CR-V Owners Manual

CONT INUED
Turn the jack’s end bracket
counterclockwise to loosen it, then
remove the jack.
To keep the tailgate door open,
use the stop f rom the tool kit. Put
the stop on the support strut as
shown. The tool and jack are behind a
cover in the cargo area on the
passenger’s side. Remove the
cover by turning the handle
counterclockwise, then pulling out
the cover.6.
5.
4.
T aking Care of t he Unexpect ed
Changing a Flat T ire
309
S ST TO
OP P C
CO
OV VE
ER
R

Remove the spare tire cover. Do
not f orcibly pull of f the cover or
you may damage it.
Your vehicle is equipped with a
sof t vinyl spare tire cover. The
f ollowing shows you how to
remove the cover.
Your vehicle is equipped with a
hard plastic spare tire cover. See
page f or how to remove the
cover.Zip open the cover.Pull out the cover’s two lower f laps.
Don’t pull the top of the cover, or
you will tear it.
Remove the cover. Pull the upper f laps out by
gradually working your hands up
the sides of the cover.
7.
8.9.
11. 10.
311
OnLXandEXmodelsintheU.S.and
Canada
On EX-L model in Canada OnLXandEXmodelsintheU.S.and
Canada
Sof t vinyl spare t ire cover
Changing a Flat T ire
T aking Care of t he Unexpect ed310

Unzip the flap around the lower
edge of the cover.Pull of f the center spacer. Using
the wheel wrench, loosen the
three wheel nuts and remove them.
Remove the spare tire from the
holder.
Pull out the bottom of the cover,
then gradually pull it of f .
12.
14.
13.
CONT INUED
On EX-L model in Canada
Hard plastic spare tire cover
T aking Care of t he Unexpect ed
Changing a Flat T ire
311
C CE
EN
NT TE
ER
R S
SPPA
A C
CEER
R

Loosen the f ive wheel nuts 1/2
turn with the wheel wrench.Locate the jacking point nearest
thetireyouneedtochange.Itis
pointed to by an arrow molded into
the underside of the body. Place
the jack under the jacking point.
Turn the end bracket clockwise
until the top of the jack contacts
the jacking point. Make sure the
center of the jacking point tab is
restinginthejacknotch.Use the extension and wheel
wrench as shown to raise the
vehicle until the f lat tire is of f the
ground.
15.
16.17.
T aking Care of t he Unexpect ed
Changing a Flat T ire
312
W WHHE
EE
EL
L N
NUUTT E
E
X
X T
TE
EN
NS SIIOON N
W
WH HE
EE
EL
L W
WR REEN
NC CHH
J
JA A C
CKKIINNG G P
PO
OI INNT T

CONT INUED
Put on the spare tire. Put the
wheel nuts back on f inger-tight,
then tighten them in a crisscross
pattern with the wheel wrench
until the wheel is f irmly against
the hub. Do not try to tighten
them f ully.
Bef ore mounting the spare tire,
wipeanydirtoff themounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully,itmaybehotfrom
driving.
Remove the wheel nuts and f lat
tire. Temporarily place the f lat tire
on the ground with the outside
surf ace of the wheel f acing up.
You could scratch the wheel if you
putitfacedown.
18.
19.20.
Changing a Flat T ire
T aking Care of t he Unexpect ed313
B BRRAA K
KEE H
HU
UB B

Put the flat tire on the spare tire
holder. Put the wheel nuts on
finger-tight, then tighten them
with the wheel wrench.
Put the center spacer in the center
of the wheel.
Store the jack in its holder. Turn
the jack’s end bracket to lock it in
place. Install the cover on the side
of the cargo area.
Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
f acility.
Tighten the wheel nuts to:
Remove the center cap from the
flat tire.
Lower the vehicle to the ground
and remove the jack.
23.
21.
22.
24.
25.
T aking Care of t he Unexpect ed
Changing a Flat T ire
314
C CEEN
NT TE
ER
R S
SPPA
A C
CEER
R
80 lbf·ft (108 N·m , 11 kgf·m)

CONT INUED
Step back to check the alignment
of the logo. If needed, pivot the
cover until the logo is straight.
Hold the cover at the 10 o’clock
and 2 o’clock positions, then place
the top of it over the spare tire.
Store the tool kit in the storage bin
under the cargo area f loor.
Close the tailgate.
Install the spare tire cover.
26.
27.
28.
29.30.
OnLXandEXmodelsintheU.S.and
Canada
Changing a Flat T ire
T aking Care of t he Unexpect ed
Sof t vinyl spare t ire cover
315
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.
Make sure the cover is at room
temperature bef ore you install it. If it’s
too cold, it won’t f it easily over the tire.

Starting at the top of the tire,
position the outside seam of the
cover slightly over the outside
edge of the tire. Pull the cover on,
a little at a time, and alternate side
to side along the tire until you
reach the bottom.If needed, readjust the cover to
smooth out any wrinkles. Pull the bottom of the cover over
the tire.
Zip the cover closed.
31. 32.
33.34.
Changing a Flat T ire
T aking Care of t he Unexpect ed316
S SP
PA
A R
REE T
TI
IRRE E B
BRRAA C
CKKEET
T
O
OU
UTTS
SI IDD E
E S
SEEA
A M
M