Page 20 of 155

 
20n
 
Indicator and warning lamps
 
Add washer fluid
The washer fluid level is too low. 
Top off the fluid at the earliest 
opportunity. For additional information 
refer to page 114
SERVICE ENGINE SOON 
 
l
 
If the indicator lamp comes on 
either continuously or intermit-
tently, this indicates a fault in the emis-
sions-related electronic systems. 
Although the vehicle remains opera-
tional, you should have the systems 
checked by your BMW center at the 
earliest possible opportunity. 
For additional information refer to 
page 12 1.
SERVICE ENGINE SOON 
warning lamp for Canadian 
models.
Engine electronics 
 
l
 
 
There is a fault in the electronic 
engine-management system. 
You can continue to drive with reduced 
engine output or engine speed. Please 
have the system inspected at your 
BMW center.
Add coolant
The coolant level is too low. Add 
coolant at the earliest opportu-
nity. For additional information refer to 
page 117
 
Green: for your information
 
Turn signal indicator
Flashes when the turn signals 
are on. 
Rapid flashing indicates a system 
malfunction.
For additional information refer to 
page 60
Cruise control
Lights up when the cruise 
control is activated: available for 
operation via the multifunction steering 
wheel.
For additional information refer to 
page 63
Fog lamps
Lights up whenever you switch 
on the fog lamps.
For additional information refer to 
page 83
 
Blue: for your information
 
High beams
Comes on when the high beams 
are on or the headlamp flasher 
is actuated.
For additional information refer to 
pages 60, 83 
     
        
        Page 60 of 155

60n
Automatic transmission with Steptronic
*
Indicator/Headlamp flasher 
Possible displays 
P R N D SD M1 M2 M3 M4 M5
Electronic transmission control 
module
If the indicator lamp comes on, 
there is a malfunction in the 
transmission system.
Bring the vehicle to a stop, select trans-
mission position "P", engage the 
parking brake  and switch the engine off 
(ignition key to position 0). 
Wait a few seconds, then start the 
engine.
If the indicator lamp goes out after a 
few seconds, normal transmission 
performance has been restored. Drive 
off normally.
If the indicator lamp does not go out, all 
selector lever positions can still be 
selected; however in the forward posi-
tions the vehicle has limited perfor-
mance as it drives only in 3
rd and 4
th 
gear.
If this happens, avoid extreme engine 
loads and consult the nearest BMW 
center.
Never work in the engine 
compartment when a drive gear 
(forward or reverse) is engaged. If you 
do this, the vehicle could move.<
For towing or jump-starting, refer to the 
information beginning on page 134.
1 High beams (blue indicator lamp)
2 Headlamp flasher (blue indicator 
lamp)
3 Turn signal indicator (green indicator 
lamps accompanied by a periodic 
clicking sound from the relay).To signal brieflyPress the lever up to but not beyond 
the detent. It then returns to the center 
position when released.
If the flashing of the turn signal 
indicators and the clicking from 
the relay are both faster than normal, 
one of the turn signal indicators has 
failed.< 
     
        
        Page 66 of 155

66n
Fuel gauge  Temperature gauge  Service Interval DisplayOnce the indicator lamp stays on 
continuously, there are still approx. 
2 gallons (8 liters) of fuel in the fuel 
tank.
For fuel tank capacity, refer to 
page 143.
Certain operating conditions (such as 
those encountered in mountainous 
areas) may cause the needle to fluc-
tuate slightly.
Please refuel early, since driving 
to the last drop of fuel can result in 
damage to the engine and/or catalytic 
converter.<
When you switch on the ignition, the 
indicator lamp lights up briefly as an 
operation check.
BlueThe engine is still cold. Drive at 
moderate engine and vehicle speeds.RedWhen you switch on the ignition, the 
warning lamp comes on briefly to 
confirm that the system is operational.
If the lamp comes on during normal 
vehicle operation: the engine has over-
heated. Switch off the engine immedi-
ately and allow it to cool down.
Checking coolant level, refer to 
page 117.Between the blue and red zonesNormal operating temperature. The 
needle may rise as far as the edge of 
the red sector in normal operation.
Remaining distance to serviceThe displays shown in the illustration 
appear for a few seconds when the 
ignition key is in position 1 or after the 
engine is started.
The next service due appears with the 
message OIL SERVICE or INSPEC-
TION, together with the distance 
remaining in miles (kilometers) before 
the next scheduled service. The 
computer bases its calculations of the 
remaining distance on the preceding 
driving style.
A flashing message and a "Ð" in front of 
the number mean that the service 
interval has already been exceeded by 
the distance shown on the display. 
Please contact your BMW center for an 
appointment. 
     
        
        Page 83 of 155
83n
OverviewControlsMaintenanceRepairsDataIndex
Instrument lighting
High beams/Standing lamps
Fog lamps
Turn the rotary dial to adjust the illumi-
nation intensity.
1 High beams 
(blue indicator lamp)
2 Headlamp flasher 
(blue indicator lamp)
3 Standing lampsStanding lamps, left or rightAs an additional feature, you can illumi-
nate your vehicle on either side for 
parking:
With the ignition key in position 0, 
engage the lever in the appropriate 
turn-signal position.
Front fog lamps
The green indicator lamp in the 
instrument cluster lights up to 
indicate that the front fog lamps 
are on.
If the automatic headlight control 
is on, the low beams will come on 
automatically whenever you switch on 
the front fog lamps.<