2002 Acura RL lock

The digital clock displays the time
with the ignition switch ON (II). To
see the time with the ignition off,
press and hold the wide button to the
right of the clock.
To apply the parking brake, depress
the pedal f ully. To release it, pull the
release lever. The parking brake
light on the instrument panel should
go out when the parking brake is
f ully released with the engine
running (see page ). If you try to
drive the car without releasing the
parking brake, the ABS indicator
maycomeon,andtheABSmaynot
work properly. The VSA system
indicator will also come on along with the ABS indicator (see page
).
54 199
3.5 RL without Navigation System
Parking Brake
Digital Clock
Parking Brake, Digital Clock
Inst rument s and Cont rols102
P PA
A R
RKKIINNG G
B
BR RAA K
KEE P
PE
ED
D A
AL
L
R
RE
EL
LEE A
A S
SEE L
LEE V
V E
ER
R
Driving the car with the parking brake
applied can damage the rear brakes
and axles.
01/09/28 19:41:49 31SZ3660_105

To set the clock:Turn the ignition switch ON (II) to
display the time.
Swing down the f ront cover of the
wide button to the right of the
clock display. You will see HOUR,
MIN., and RESET buttons. Press and hold the HOUR button
until the hour advances to the
desired hour.
Press and hold the MIN. button
until the numbers advance to the
desired time.
You can use the RESET button to
quickly set the time to the nearest
hour. If the displayed time is bef ore
the half hour, pressing the RESET
buttonsetstheclockbacktothe
previous hour. If the displayed time
is af ter the half hour, pressing the
RESET button sets the clock f or-
ward to the beginning of the next
hour.
1:06 would RESET to 1:00.
1:52 would RESET to 2:00.
For example:
1.
2. 3.
4.
Digital Clock
Inst rument s and Cont rols103
H H
O
OU URR R
REES
SE ET
T
M
M I
INN. .
01/09/28 19:41:59 31SZ3660_106

In addition to the ceiling lights, your
Acura has courtesy lights in each
door and the ignition switch.Even if the door is open, the lights
will turn off after three minutes
when the key is not in the ignition
switch or the ignition switch is in the
LOCK (0) or ACCESSORY (I)
position, and the light switch is in the
of f position.
The door courtesy lights and ceiling
lights (with the switch in the center
position) come on when you unlock
the door with the key, lock tab on
the driver’s door, master door lock
switch,orremotetransmitter(see
page ). If you relock the driver’s
door or close the driver’s door with
the key in the ignition switch, the
lights turn of f immediately.
Otherwise, they remain on, then f ade
out in about 10 seconds.
The door courtesy lights come on
whenever you open any door. Af ter
all doors are closed tightly, they dim
slightly then f ade out in about 10
seconds. Thecourtesylightintheignition
switchcomesonwhenyouopenthe
driver’s door. It remains on about 10
seconds af ter the door is closed. The door courtesy lights and ceiling
lights (with the switch in the center
position) also come on when you
remove the key from the ignition
switch. If you do not open a door,
they stay on, then fade out in about
10 seconds.
79
Courtesy Lights
Inst rument s and Cont rols112
01/09/28 19:43:14 31SZ3660_115

You can manually select the f an
speedbyturningthefancontroldial.
When you turn the dial clockwise,
the fan is taken out of automatic
mode and starts to run at its lowest
speed. Turning the dial f ully
clockwise increases the f an’s speed,
which increases air flow.Use the MODE button to select the
vents the air flows from. Some air
will f low f rom the side vents and the
dashboard corner vents in all modes.
Each time you press the MODE
button, the display shows the mode
selected. Press the button four times
to see all the modes.
These two buttons control the
source of the air going into the sys-
tem. In Fresh Air mode ( ),
air is brought in f rom outside the ve-
hicle. In Recirculation mode
( ), air f rom the car’s interior
is sent through the system again.
You can, f or example, manually put
the system in recirculation mode
when driving through an area of
smoke or f umes. When you press
the or button, the
light in that button comes on.
Climat e Cont rol Syst em
Comf ort and Convenience Feat ures
Mode Button
Recirculat ed and Fresh A ir
Fan Cont rol Dial
118
M MO
ODDE
E B
BUUT TT
TO
ON N F
FAA N
N C
COON NTTR
RO OL L D
DI
IAA L
L
R
RE EC
CI IRRC CUUL LAA T
TE
ED
D A
AI
IRR F
FRRE ES
SH H A
AI
IRR
01/09/28 19:44:00 31SZ3660_121

CONT INUED
This button controls the source of
the air going into the system. When
the indicator above this button is lit,
air f rom the car’s interior is sent
through the system again (Recircula-
tion mode). When the indicator is off,
air is brought in f rom outside the car
(Fresh Air mode).
You can, f or example, manually put
the system in recirculation mode
when driving through an area of
smoke or f umes.
You can manually select the f an
speedbyturningthefancontroldial.
When you turn the dial clockwise,
the fan is taken out of automatic
mode and starts to run at its lowest
speed. Turning the dial f ully
clockwise increases the f an’s speed,
which increases air flow.Use the MODE button to select the
vents the air flows from. Some air
will f low f rom the side vents and the
dashboard corner vents in all modes.
Each time you press the MODE
button, the display shows the mode
selected. Press the button four times
to see all the modes.
Mode Button
Recirculat ion But t on
Fan Cont rol Dial
Climat e Cont rol Syst em
Comf ort and Convenience Feat ures123
R REEC
CI IRRC CUUL LAA T
TI
IOON N B
BUUT TT
TO
ON N
F
FA
A N
N C
COON NTTR
RO OL L D
DI
IAA L
L M
MO
ODDE
E B
BUUT TT
TO
ON N
01/09/28 19:44:45 31SZ3660_126

Once the security system is set,
opening any door (without using the
key or the remote transmitter), or
the hood, will cause it to alarm. It
also alarms if the radio is removed
f rom the dashboard or the wiring is
cut.With the system set, you can still
open the trunk with the master key
or the remote transmitter without
triggering the alarm. The alarm will
sound if the trunk lock is f orced, or
the trunk is opened with the trunk
releasebuttononthedriver’sdoor.
The security system will not set if
the hood, trunk, or any door is not
f ully closed. If the system will not set,
check the Door and Brake Lamp
Monitor on the instrument panel
(see page ), to see if the doors
and trunk are f ully closed. Since it is
notpartofthemonitordisplay,
manually check the hood.
The security system sets auto-
matically fifteen seconds after you
lock the doors, hood, and trunk. For
the system to activate, you must lock
the doors f rom the outside with the
key, lock tab, door lock switch, or
remote transmitter. The security
system light next to the driver’s door
lock starts blinking immediately to
show you the system is setting itself . Do not attempt to alter this system
or add other devices to it.
The security system helps to protect
your car and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lashes if
someone attempts to break into your
carorremovetheradio.Thisalarm
continues f or two minutes, then the
system resets. To reset an alarming
system bef ore the two minutes have
elapsed, unlock either f ront door
with the key or the remote
transmitter.
57
Comf ort and Convenience Feat ures
Security System
157
S SEEC
CU UR RIITT Y
Y S
SYYSSTTE
EM
M L
LIIGGH HT
T
01/09/28 19:50:11 31SZ3660_160

µ
If you are training the second or
third buttons, go directly to Step 1. Unplug the garage door opener
motor f rom the house current.
Bef ore you can use HomeLink to
operate devices around your home, it
must ‘‘learn’’ the proper codes. For
example, to train HomeLink to open
and close the garage door:
If you just took
delivery of your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the f irst button. To do this,
press and hold the two outside
buttons on the HomeLink
transceiver for about 20 seconds,
until the red light f lashes. Release
the buttons, then proceed to Step 1.
Holdtheendof thegaragedoor
opener remote control 2 to 5
inches f rom HomeLink. Make
sure you are not blocking your
view of the red light in HomeLink. Select the HomeLink button you
want to train.
Press the button on the remote
control and the button on
HomeLink at the same time. Hold
down both buttons.
1.
2. 3.
4.
CONT INUED
T raining HomeL inkBef ore you begin
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures163
01/09/28 19:51:08 31SZ3660_166

The OnStarsystem in your vehicle
gives you immediate access to a wide
range of services and inf ormation
with the touch of a button. An
OnStar advisor is available 24 hours
a day, 7 days a week.
The basic Saf ety & Security Plan
provides: Press this button to contact an
OnStar advisor. You will hear a
chime, f ollowed by the
announcement, ‘‘Connecting to
OnStar.’’ The connection should take
20 to 30 seconds. The advisor will
assist you with any of the services
included in your plan.
Depending on what service you
request, you may need to give your
Personal Identification Number
(PIN) to the advisor. Your PIN is a
number you make up and provide
when you establish your OnStar
service.
If cellular telephone service is not
available in the area you are driving
in, you will hear a f ast busy signal.
The system will retry the connection
several times bef ore returning to the
ready mode.
Roadside Assistance.
Emergency Services.
Automatic Notif ication of Airbag
Deployment.
Accident Assist.
Remote Door Locking/Unlocking.
Stolen Vehicle Tracking.
Misplaced Vehicle Assistance.
The Premium Service Plan provides
these additional f eatures: Route Support.
Ride Assist.
Inf ormation and Convenience
Services.
Concierge Services. The OnStar control buttons and
indicator are located in the base of
the rear view mirror.
CONT INUED
Comf ort and Convenience Feat ures
OnStar System
OnStar Services Button
OnStar Control Panel
167
O On nS
St taar r B
BU UT TT
TO
ON N S
SY
YSSTTE
EM
M
S
ST TA
A T
TU
US S L
LIIGGH HT
T
E
E M
M E
ER
RG GE EN
NC CYY
B
BU UT TT
TO
ON N
C
CA
A L
LLL
A
A N
NS SWWE ER
R/ /E
E N
ND D
B
BU UT TT
TO
ON N
01/09/28 19:52:02 31SZ3660_170