2002 Acura MDX buttons

If the seat belt touches or crosses
your neck, or if it crosses your arm
instead of your shoulder, you need to
adjust the seat belt anchor height.
If necessary, pull up on the belt again
to remove any slack from the
shoulder part, then check that the
belt rests across the center of your
chest and over your shoulder. This
spreads the f orces of a crash over
the strongest bones in your upper
body. To adjust the height of a f ront seat
belt anchor, squeeze the two release
buttons and slide the anchor up or
down as needed (it has f our
positions).
Driver and Passenger Saf ety
Protecting Adults
16
R RE
EL
LEE A
A S
SEE
B
BU UT TT
TO
ON N
Improperly positioning the seat
belts can cause serious injury
or death in a crash.
Make sure all seat belts are
properly positioned before
driving.
01/09/07 11:58:15 31S3V610_021

Turn of f the engine.
Press and hold the select and reset
buttons on the instrument panel,
then turn the ignition switch ON
(II).
Hold the buttons for
approximately ten seconds until
the indicator resets.
1.
2.
3.
Inst rument s and Cont rols
Gauges
70
S SE
EL
LEE C
CT T B
BUUT TT
TO
ON N
R
RE ES
SE ET
T B
BUUT TT
TO
ON N
01/09/07 12:06:55 31S3V610_075

Theremotetransmitterswillalso
activate the Driving Position
Memory System (see page ).
When you open the driver’s door
after unlocking it with the remote
transmitter, you will hear a beep.
The driver’s seat and outside mirrors
move to the positions stored in that
memory location. You will hear two
beeps when the movement iscomplete.
If the seat and mirrors are already in
the proper positions, you will hear
three beeps when you open the door.
The driving position memory
activated (Memory 1, Memory 2) is
shownonthebackof each
transmitter. Make sure you store
your desired driving position in the
memory that is activated by the
transmitter you normally carry.
To turn it back on, repeat this
procedure. The LED will come on
f or one second to indicate the
f eature has been turned on. You can turn the driving position
memory activation off and on. To
turn it of f , press and hold the LOCK
and UNLOCK buttons at the same
time f or about one second. The LED
in the remote transmitter will blink
twice. Then release the buttons.
107
On Touring Model
Recalling a Memorized Driving
Position
Keys and Locks
Inst rument s and Cont rols87
W Wi itth h M
M e
emm o
or
ryy 2
2
W
Wi itth h M
M e
emm o
or
ryy 1
1
01/09/07 12:09:40 31S3V610_092

Store the head restraints in the
storage compartment under the
cargo area f loor. Insert the shaf ts
of the head restraints into the
holes in the sides of the storage
compartment.Use the ignition key to release the
seat belt from the detachable
anchor.
To create more cargo space, you can
fold the third seat forward.
To fold the third seat:
Remove the head restraints by
pushing the release buttons and
pulling the restraints out.
1. 2. 3.
Folding the T hird Seat
Inst rument s and Cont rols
Seats
96
R RE
EL
LEE A
A S
SEE B
BUUT TT
TO
ON N
01/09/07 12:11:05 31S3V610_101

Turn the ignition switch ON (II).
You cannot add a new driving
position in the memory unless the
ignition switch is ON (II). You can
recall a memorized position with
the ignition switch in any position.
Seat and outside mirror positions, f or
two dif f erent drivers or driving
conditions,canbestoredinseparate
memories. You select a memorized
position by pushing the appropriate
button or using the appropriate
remote transmitter (Memory 1 or
Memory 2). Store a driving position as explained
in this section only when the vehicle
is parked.
Adjust the seat to a comfortable
position (see page ).
Adjust the outside mirrors f or best
visibility (see page ). Press and release the MEMO
buttononthecontrolpanel.You
will hear a beep. Immediately
press and hold one of the memory
buttons (1 or 2) until you hear two
beeps. The indicator light in the
memory button will come on. The
current positions of the driver’s
seat and outside mirrors are now
stored.
Your Acura has a memory f eature
f or the driver’s seat and outside
mirror positions.
3.
1.
2.
90
105
CONT INUED
Touring Model St oring a Driving Posit ion in Memory
Driving Posit ion Memory Syst em
Inst rument s and Cont rols107
M ME
EM
M O
O B
BUUT TT
TO
ON N
01/09/07 12:12:42 31S3V610_112

CONT INUED
When you turn the A/C of f , the
system cannot regulate the inside
temperature if you set it below the
outside temperature. With the A/C
on, use the temperature buttons to
adjust the temperature of the air
flow to a comfortable setting. Pressing the A/C button or touching
the A/C icon turns the air
conditioningonandoff.Youwillsee
A/C ON or A/C OFF displayed. You can manually select various
f unctions of the Climate Control
system when it is in FULL AUTO.
All other f eatures remain auto-
matically controlled. Some of these
f unctions appear in the Trip
Computer/Navigation System
display. With the Navigation System,
press the A/C-Trip button next to
the display to show these functions.
Climat e Cont rol Syst em
Comf ort and Convenience Feat ures
Semi-automatic Operation
A ir Condit ioning (A /C) But t ons
125
A AI
IRR C
COON NDDI
ITT I
IOON NIINNG G (
(A
A /
/C
C) )B
BU UT TT
TO
ON NSS
T
T
E
EM
M P
PE
ER
RA A T
TU
UR REE B
BUUT TT
TO
ON NSS
R
RE
EC
CI IRRC CUUL LAA T
TI
IOON N B
BUUT TT
TO
ON N
(
( w
wi itth h o
ou
ut
t N
Na avviigg a
attiioo n
n S
Syysstteem m )
)
(
(w
wi itth h N
Naavviigg a
attiioo n
n S
Syysstteem m )
)
01/09/07 12:15:20 31S3V610_130

Turning this dial clockwise increases
the temperature of the air flow.
Use the MODE buttons to select the
vents the air flows from.
With the button selected,
heated air f lows f rom the rear lower
vents.
With the button selected
cooled air f lows f rom the rear upper
vents.
Climat e Cont rol Syst em
Comf ort and Convenience Feat ures
Mode Button
T emperat ure Cont rol Dial
132
01/09/07 12:16:19 31S3V610_137

Î
Î
The anti-thef t f eature will disable the
system if it is disconnected f rom the
car’s battery. To get the system
working again, you must enter a
code number (see page ).
Your Acura’s audio system provides
clear reception on both AM and FM
bands, while the preset buttons allow
you to easily select your f avorite
stations.
The cassette system f eatures Dolby
noise reduction, automatic sensing of
chromium-dioxide (CrO ) tape, and
auto-reverse f or continuous play.
The in-dash CD changer holds up to
six discs. You operate the CD
changer with the same controls used
f or the radio. See page f or CD
changer operation.170
143
Touring Model
2
Dolby noise reduction manuf actured under
license from Dolby Laboratories Licensing Corpo-
ration. ‘‘DOLBY’’ and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
Audio System
Comf ort and Convenience Feat ures
A M/FM/Cassette/CD Changer
Audio System
133
01/09/07 12:16:30 31S3V610_138