Page 141 of 174
29 07 2002
MAINTENANCE OF YOUR 40635
The jack is fitted with a system
which enables it to be folded or
unfolded rapidly. Take the jack
from the toolkit and fold it by press
ing the ends A. Place the jack at
one of the locations Eunderneath
the vehicle (as close as possible to
the wheel to be changed) and
unfold it by pulling the ends A.
Extend the jack using the wheel brace 1and the extension 3.
Take out a wheel bolt at the top and fit the centralising tool 2.
Loosen the wheel bolts and remove the wheel. Fitting a wheel
Position the wheel using the cen
tralising tool to assist you.
Tighten the bolts by hand, and remove the centralising tool.
Partly tighten the bolts using the wheelbrace.
Fold the jack and remove it.
Fully tighten the wheel bolts using the wheelbrace.
Replace the wheel trim, except in the case of a space saver wheel,
by starting with the valve and
pressing on using the palm of your
hand. For your safety, always
change the wheel:
on level, stable, non slippery ground,
with the handbrake applied,
with first or reverse gear engaged (position Pfor the
automatic gearbox).
Never go underneath a vehicle which is supported only by a
jack (use a ramp).
After changing the wheel
have the tightening of the bolts and the tyre pressure checked
by a PEUGEOT dealer as soon
as possible,
have the punctured tyre repaired and refit it to the vehi
cle as soon as possible.
7 seater Estate model
The space saver spare wheel fit
ted with a 125/80R15 tyre must
only be used as a short term mea
sure. Tyre pressure is 61 lb in2
(4.2 bars), maximum speed is
50 mph (80 km/h).
Page 143 of 174
29-07-2002
PETROL / LPG DUAL FUEL VERSION167
Puncture
Insulated storage compartment
This is located in the boot and con
tains:
the temporary tyre repair cans 1
(your 406 LPG does not have a
spare wheel),
the adaptors 2 necessary for
filling the LPG tank in some
countries,
the towing eye 3.
Fuses
The LPG functions are protected
by the two fuses Ain the fuse box
located in the engine compartment.
Using the repair cans
(Refer to the directions on the cans
also)
if possible, remove the object
which caused the puncture,
rotate the wheel so that the valve is in the same position as the
figures 2 or 10 on a clock,
shake the cans vigorously before use. In very cold weather, warm
the cans between your hands for
few minutes,
hold the valve with one hand and with the other press the injection
nozzle on the can firmly onto the
valve, holding it straight,
maintain the pressure firmly for one minute, carry out the same operation with
the second can, then drive imme
diately, at a moderate speed , to
the nearest garage.
The cans enable you to carry out
a temporary repair.
After use, the tyre must be
changed.
As the cans are pressurized, they
must not be exposed to a temper
ature above 50°C.
Store them away from heat in the
insulated storage compartment.
Page 152 of 174
29-07-2002
PETROL / LPG DUAL FUEL VERSION167
Puncture
Insulated storage compartment
This is located in the boot and con
tains:
the temporary tyre repair cans 1
(your 406 LPG does not have a
spare wheel),
the adaptors 2 necessary for
filling the LPG tank in some
countries,
the towing eye 3.
Fuses
The LPG functions are protected
by the two fuses Ain the fuse box
located in the engine compartment.
Using the repair cans
(Refer to the directions on the cans
also)
if possible, remove the object
which caused the puncture,
rotate the wheel so that the valve is in the same position as the
figures 2 or 10 on a clock,
shake the cans vigorously before use. In very cold weather, warm
the cans between your hands for
few minutes,
hold the valve with one hand and with the other press the injection
nozzle on the can firmly onto the
valve, holding it straight,
maintain the pressure firmly for one minute, carry out the same operation with
the second can, then drive imme
diately, at a moderate speed , to
the nearest garage.
The cans enable you to carry out
a temporary repair.
After use, the tyre must be
changed.
As the cans are pressurized, they
must not be exposed to a temper
ature above 50°C.
Store them away from heat in the
insulated storage compartment.
Page 162 of 174
29-07-2002
MAINTENANCE OF YOUR 406
52
406 ACCESSORIES
For your PEUGEOT only use accessories and original parts approved by the manufacturer.
These accessories and parts are all adapted to your PEUGEOT, after being tested and approved for reliability and safety,
which PEUGEOT cannot guarantee for other products.
A wide choice of original accessories, approved by PEUGEOT, is availa ble through the dealer network. They all carry the
PEUGEOT guarantee.
– Security : Alarms, window engraving, wheel anti theft devices, first aid kit etc.
– Protection : Covers compatible with side air bags, mats, door sill protector, styling strips.
– Communication : Telephone, satellite navigation, audio equipment, CD changer, speakers.
– Customising : Alloy wheels, wheel trims, spoiler, sports exhaust.
– Comfort : Air conditioning, sun roofs*, storage facilities, portable ref rigerator, luggage net, telephone
console, armrest, door sill protector, boot storage, door deflect ors.
– Leisure pursuits : Tow bar, roof bars, carriers (for bicycles and skis), roof boxes, snow ch ains etc.
– Children : Booster seats and child seats, side blinds, rear blinds.
– Maintenance products : Windscreen washer fluid, internal and external cleaning and maintenance products.
* As the fitting of a sun roof may require cutting of the roof strengthener, it is essential to use original PEUGEOT
products only.