2002.5 Peugeot 307 SW Dag display

22-07-2002
YOUR 307 SW IN DETAIL
55
Bass setting When "Bass" is displayed, turn button Cto vary the setting.
- "-9" for minimum bass setting,
- "0" for normal setting,
- "+9" for maximum bass setting.
Treble setting When "Treble" is displayed, turn button Cto vary the setting.
- "-9" for minimum treble setting,
- "0" for normal setting,
- "+9" for maximum treble setting.
Adjusting the loudness
This function automatically emphasises bass and treble tones when the volume is low. Rotate button Cto switch the function on or off.
Setting the front/rear sound distribution (Fader) When "Fader" is displayed:
- Turn button Cclockwise to increase the volume in the front.
- Turn button Canti-clockwise to increase the volume in the rear.
Setting the right/left sound distribution (Balance)When "Balance" is displayed:
- Turn button Cclockwise to increase the volume on the right.
- Turn button Canti-clockwise to increase the volume on the left.
Automatic volume adjustment "CAV"This function allows the volume to be adjusted automatically depending on the level of noise produced by the speed of the vehicle. Press button Cto switch the function on or off.

22-07-2002
YOUR 307 SW IN DETAIL57
Manual station search Briefly press button Hor Ito increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain continuous searching of the frequency. Scrolling stops at the first station found as soon as the button is released.
Manual station search Select the station required. Press for more than two seconds on one of the buttons "1"to "6" .
An audible signal is emitted, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory
Press the ''BND/AST' ' button for more than two seconds.
Your audio/telephone automatically stores the 6 stations with the strongest signal in FM. These stations are stored in the FMast waveband.
If it is not possible to find 6 stations, the remaining memories are empty. Recalling stations stored in the memory For each waveband, briefly press the buttons "1"to "6" to recall the corresponding stored station.

22-07-2002
YOUR 307 SW IN DETAIL
58
RDS SYSTEM Using the RDS (Radio Data System) function on FM Radio Data System allows you to continue to listen to the same station whatever the frequency it is using for the region you are going through. Switch the function on or off by pressing the "RDS"button briefly.
The multifunction screen will show: - RDS if the function is active,
- "(RDS)" if the function is active but not available.
RDS station following
This display indicates the name of the station selected. The audio/telephone is continuously searching for the station which has the best reception and which is transmitting the same programme.
Traffic information pprogramme Press the ''TA/PTY'' button to switch the function on or off.
The multifunction screen will show: - TA if the function is selected,
- "(TA)" if the function is selected but not available.
Any traffic information flash will be given priority, whatever source you are listening to (radio, CD or CD changer).If you wish to interrupt the broadcasting of a message, press the ''TA/PTY''button to switch the function off.
Note: the volume of the traffic information is independent of the volume of normal radio/telephone listening . You can
adjust it by using the volume button. The setting will be stored and will be used when the next messages are broadcast. Regional following mode (REG) When they are part of a network, certain stations broadcast regional programmes in the various areas they serve. With regional following mode you can keep listening to the same programme.
To do this, press the "RDS"button to switch the function on or off.

22-07-2002
YOUR 307 SW IN DETAIL59
PTY function This allows you to listen to stations broadcasting a specific type of programme (news, culture, sport, rock etc.). When FM is selected, press button "TA/PTY"for more than two seconds to switch the function on or off.
To find a PTYprogramme:
- select the PTYbutton,
- turn button Gto scroll down the different types of programmes offered,
- when the programme of your choice is displayed press button Mor Nto carry out an automatic
search (after an automatic search the PTYfunction is switched off if no station has been found).
In PTY mode the different types of programmes can be stored in memory. To do this, press the preselection buttons "1"to
"6' ' for more than two seconds. Recalling the type of programme stored in the memory is by brief pressure on the corrres-
ponding button.
EON system
This system connects stations which are part of the same network. It enables traffic information or a PTYprogramme trans-
mitted by a station which is part of the same network as the station to which you are listening, to be broadcast. The service is available when you have selected the TAtraffic information programme or the PTYfunction.
Contextual menu The contextual menu allows you to access the following functions:- "Inputting a frequency"- "Display Radio text" to display information connected with the station being listened to.

22-07-2002
YOUR 307 SW IN DETAIL
62
TELEPHONE
This function is a GSM dual-band telephone (800 and 1 800 MHz) incorporated in the RT3 audio system. It is a ''hands free'' telephone. This function is provided by a microphone located next to the front courtesy light, the spea-
kers and a steering column control which allows access to most of the functions (the audio/telephone control panel buttons allow access to all the functions). Display of the principal ''mobile''type functions, as well as consultation of the indexes, is provided by the multifunction dis-
play.This function is active whatever position the ignition key is in.
Note: when the key is in the accessories (1st notch) or ignition on (2nd key notch) position, this function will be interrupted
after thirty minutes, when the message ''Economy mode active'' appears on the multifunction display. If you are using the
telephone at that time, you will be able to finish your call.
Using the menus Press the ''MENU''button to display the general menu. Select the telematicsapplication, validiate Telephone functions
to access the principal telephone functions, then the various menus, in order to reach the one required.
This menu allows you to access the following functions:
- Network: allows you to select the network search mode and to see the networks avai-
lable.
- Duration of calls: allows you to consult the duration recorder of calls made and zero
re-set.
- SIM card security: allows you to use or modify the PIN code and to erase the list of
calls and mini-messages (SMS).
- Telephone options: allows you to configure the calls with entering of my number,
automatic answering after X rings and specification of ring options.
Within each menu:
Move around and select a function by turning the Gknob then validate by pressing the knob.
Cancel an operation by means of the ''ESC''button.

22-07-2002
YOUR 307 SW IN DETAIL65
Making a call Press button Dto display the contextual menu of the telephone.
Note: pressing the end 5of the steering column control for more than 2 seconds calls
up a contextual menu limited to the "Directory"and "List of calls" functions.
Entering a number Select the function ''Enter number''then enter the number of the person you wish to speak to using the alpha-
numeric keypad. Press button Dto make the call.
Making a call from a directory Select the "Directory" function to access all the files containing a telephone number or the "List of calls"function to access
the list of the last ten incoming (if the number display option is active) or outgoing calls. Note: there are two directories, the RT3 audio/telephone directory and the SIM card directory. To consult the SIM directory,
insert your SIM card and enter you PIN code. Receiving a call
When a ringing sounds to let you know that a call is waiting, you can choose either to accept it by pressing but- ton Dor the end of the steering wheel remote control or not to accept it by pressing the button Qor by selecting
and validating the "NO"button from the "Answer?"menu.
If you accept the call, to end your communication, press button Q.

22-07-2002
YOUR 307 SW IN DETAIL
68
Services* Press button Eto display the "Services"menu and select one of the following services:
á "Customer Contact Centre" which enables you to contact the PEUGEOT Customer Contact Centre directly and
access the services offered (this type of call is suspended if an energency or breakown call is made).
á "Peugeot Assistance" which enables you to contact the call centre which controls the PEUGEOT breakdown ser-
vice directly and receive rapid assistance (you have 6 seconds within which to cancel the call when it is made). During the breakdown call phase it is not possible to make any other calls with the exception of emergency calls.
á "Operator services" which gives access to the list of services specific to the operator (e.g.: customer service, consump-
tion monitoring, news, stock market, weather, travel, games, etc) if they are available.
Note: during connection to a service, it is not possible to receive calls or SMS mini messages, they will be diverted to your
voice message service. Contrarily, it is possible to send a call which results in automatic disconnection. Emergency call*
In an emergency , press button Vuntil a signal is heard and a call validation / deletion screen is displayed (delay
of 6 seconds) or enter 11 2directly.
Note: in this case, a green diode flashes on the RT3 audio/telephone panel when the emergency call procedure begins then
lights permanently when the call is taken by the emergency services. In the absence of a specific service contract, the parameters of the SOSbutton are set so that a call is made to 11 2- unique
number made available by the worldwide GSM network, reserved for emergency calls. Before making a call of this kind, the audio/telephone must detect a cellular network. No security mode is required and, depending on the network, you do not need to insert your SIM card or enter your PIN. If you have signed the specific contract, refer to its general conditions.* If option and service available.

22-07-2002
YOUR 307 SW IN DETAIL69
Voice commands The voice commands make it possible to use pre-recorded words or phrases to control a certain number of functions of the
RT3 audio/telephone. Activation of the voice commands Press the button on the end of the lights stalk to activate this function. Example: to recall the radio station stored on button 3, the key words are: "Radio" "Memory" "3" .
To use these key words, you must say the word "Radio", wait for the audible confirmation signal, then say the word
"Memory" , wait for the audible confirmation signal, then end with the word "3", wait for the audible confirmaton signal which
will carry out the action requested. Notes:
- in the absence of any voice commands, this function will be switched off after approximately ten seconds,
- if a command is not understood, a double audible signal is emitted. Saying the word "Help"displays all of the commands available on the screen.
List of commands available
- To change the source (Radio, CD, CD changeur, telephone) : "RADIO" / "CD" / "CHANGER" / "CALL"
- For the radio : "LISTEN" / "PREVIOUS" / "FOLLOWING" / "MEMORY" + N¡ / "AUTOSTORE"
- For the CD : "LISTEN" / "PLAY" / " PREVIOUS TRACK" / "FOLLOWING TRACK" / "TRACK NUMBER" + N¡ / "SHUFFLE" / "SCAN" / "LOOP"
- for the CD changer : "LISTEN"/ "PLAY" / " PREVIOUS TRACK" / "FOLLOWING TRACK" / "TRACK NUMBER" + N¡ / "PREVIOUS DISC" / "FOLLOWING DISC" /
"DISC NUMBER" + N¡ / "SHUFFLE" / "SCAN" / "LOOP"
- For the telephone : "CALL" / "REPEAT" / " PEUGEOT SERVICE"
- For the navigation/card : "STOP GUIDANCE" / "RE-START GUIDANCE" / "REDUCE ZOOM " / "INCREASE ZOOM "
- Various :
"CANCEL" / "HELP"