2002.5 Peugeot 307 SW Dag seats

22-07-2002
6YOUR 307 SW AT A GLANCE
FRONT SEATS 1. Forwards-backwards
adjustment.
2 . Seat back angle adjustment.
3 . Driver or passenger seat
height adjustment.
4 . Heated seats switch.
5 . Front removable armrest.
6 . Head restraint height and
angle adjustment
To raise or lower the head restraint, pull it forwards, sliding it at the same time.
Never drive with the
head restraints removed.
7. Storage drawer.
8 . "Aircraft" type table.
88

22-07-2002
Manoeuvring an additional seat: ➜seat back angle adjustment (1),
➜ head restraint height adjustment (2),
➜ folding (3),
➜ removal/refitting (4).
7YOUR 307 SW AT A GLANCE
REAR SEATS Manoeuvring a side seat: ➜forwards-backwards adjustment (1),
➜ seat back angle adjustment (2),
➜ head restraint height adjustment (3),
➜ folding (4),
➜ removal/refitting (5). Manoeuvring a centre seat: ➜
forwards-backwards adjustment (1),
➜ seat back angle adjustment,table position (2),
➜ head restraint height adjustment (3),
➜ folding (4),
➜ removal/refitting (5).
90

8YOUR 307 SW AT A GLANCE
22-07-2002
SEAT MODULARITY AND CONFIGURATIONS
99
5 seats 5 seats with centre seat in row 3
6 seats with one additional seat 7 seats with two additional seats
Transportation of long objects with table position Loading of a large volume

22-07-2002
YOUR 307 SW IN DETAIL83
VENTILATION 1. Windscreen de-icing or demisting vents.
2. Front window de-icing or demisting vents.
3. Side vents.
4. Centre vents.
5. Air outlet to front footwells.
6. Air outlet to rear footwells.
Advice on operation Place the air flow control at a level sufficient to ensure a good renewal of air in the passenger compartment. The ''OFF''
position cuts off all the air circulation in the passenger compartment. Note : only use the ' 'OFF''position occasionally (risk of condensation).
For perfectly even air distribution, take care not to obstruct the exterior air intake grilles, the vents and the air ducts und er
the front seats, as well as the air extractor located in the boot. Check that the pollen filter is in good condition.

FRONT SEATS
1. Forwards-backwards adjustment Lift the control and slide the seat forwards or backwards.
2. Seat back angle adjustment Push the handle towards the rear.
3. Driver's or passenger's seat height adjustment Pull the handle upwards or push it downwards as many times asnecessary to obtain the requiredposition.
4. Heated seats control Press the switch. The temperatu-
re is controlled automatically. Pressing the switch again stops operation. Note: the command for activa-
tion of the heating of the seat(s) remains memorised for twominutes after the ignition has
been switched off.
YOUR 307 SW IN DETAIL
88
22-07-2002

REAR SEATS Forwards-backwards adjustment* Lift the bar Aand slide the seat for-
wards or backwards.
From the 3rd row, you can pull thestrap Band slide the seat forwards
or backwards.This manoeuvre makes it easier for
passengers to exit the 3rd row, whenthe 2nd row seat is folded.
Seat back angle adjustment Pull one strap C(two straps for each
side seat, one for the centre seat) and adjust to the required angle. Release the strap to lock.
To adjust the angle of the seat from the 3rd row or the boot, pull onestrap Cat the rear of the seat.
Note: the additional seat can be
angled and folded by means of asingle strap Cat the rear of the seat
on the right or on the left. Folding a side seat: access to the 3rd row: Place the head restraint in the low position. Push the seat back fully
using bar A.
Fold the seat back onto the cushion using the strap C.
Note: you can lock the seat back in
this position (e.g. for removal) bypressing down on it. Push control Dupwards to release
the rear feet.Place the seat in the "folded" posi- tion. exit from the 3rd row or folding from the boot: Place the head restraint in the low posi- tion. Push the seat back fully
using the
strap B.
Fold the seat back onto the cushion using the strap C.
Note: you can lock the seat back in this
position (for removal) by pressing downon it. Push the control Dupwards to release
the rear feet.Place the seat in the folded position.
YOUR 307 SW IN DETAIL
90
While driving attach the retaining strap (contained in the storage pocket of the corresponding front seat): - on the 2nd row: on one side, to the carrying handle G and on the other
side, to the grab handle,
- on the 3rd row: on one side, to the carrying handle G and on the other side, to the rear armrest grab handle. * Excluding additional seat.
22-07-2002

22-07-2002
YOUR 307 SW IN DETAIL91
Centre seat table position Place the head restraint in the low position. Fold the seat back onto the cushion using the strap C.
You now have a small table with fourcan holders, two pen holders and a
document holder.
Folding the centre seat Place the head restraint in the low position. Push the seat back full y using the
bar Aor the strap B.
Fold the seat back onto the cushion using the strap C.
Note: you can lock the seat back in
this position (for removal) by pres-sing down on it. Push control Dupwards to release
the rear feet.Place the seat in the folded position. While driving, attach the retaining strap (contained in the storagepocket of one of the front seats)on one side to the carrying handleG and on the other side, to thegrab handle. Folding an additional seat Place the head restraint in the low position. Slide the strap
C(at the rear of the
seat to the right or to the left) down- wards, while pulling it backwards andpress on the seat back at the sametime to release it. Fold the seat back onto the seat cushion. Note: you can lock the seat back in
this position (for removal) by pres- sing down on it. Push the two levers Eupwards to
unlock the rear feet.Place the seat in the folded position. While driving, attach the retaining strap (contained in the storagepocket of the additional seat) onone side to the carrying handle Gand on the other side, to the reararmrest grab handle.

22-07-2002
Removing a seat Fold the corresponding seat.
Tilt the two red levers Funder the
seat to release the front feet.Lift it and carry it using the carrying handle G.
In the 3rd row, position the fixingpoint closers to obtain a flat boot
floor. Refitting a seat
In the 3rd row, first remove the floor fixing point closers using a screwdri-ver or a coin. Before positioning the 3rd row seats, move those of the 2nd row forward. Check that nothing is obstructing the floor fixing points thus pre-venting correct locking of the seatfeet. Carry the seat using the carrying handle
G.
Position the front feet in the securingpoints.
Locked Free Push control Dupwards to check
that the rear feet are free.
Tilt the folded seat backwards. The rear feet lock automatically, as do the two red levers
F.
Check that the seat is locked cor-
rectly. Lift the seat back, first releasing it by pulling the strap C.
To lock the additional seats, pressthe two levers E.
YOUR 307 SW IN DETAIL
92
Only lock the seat back on the cushion occasio-
nally, to avoid undue wearof the seat covers.
Avoid placing luggage on foldedseats. Never use the adjusting straps to remove, refit or carry a seat.