2002.5 Peugeot 206 CC ignition

INSTRUMENTS AND CONTROLS29
Front and side air bags warning light The warning light comes on
for a few seconds when the ignition is switched on. Switching on of this warning light, with the engine running, is accompanied byan audible signal and a message onthe multifunction display indicating afault in the air bags.
Contact a PEUGEOT dealer.
Seat belt not fastened warning light* When the ignition is switched
on, the warning light comes on when the driver has not fastened his seat belt. Engine autodiagnostics warning light This comes on each time the
ignition is switched on. If it comes on when the engine is run-ning, it indicates a malfunction in theinjection, ignition or emission control
system. There is a risk of damage to
your catalytic converter.
Contact a PEUGEOT dealer rapidly.
Low fuel level warning light When the warning light first
comes on, you have enough fuel to drive at least 35 miles (50 km) (the tank capac-
ity is approximately 47 litres (10.3 gallons).
Coolant temperature indicator light
Ð When the needle is in zone (A), the
temperature is correct.
Ð When the needle is in zone ( B), the
temperature is too high. The central
STOP warning light flashes.
You must stop immediately.
Contact a PEUGEOT dealer.
Dynamic stability control (ESP/ASR) warning light This comes on for a few seconds each time the igni-
tion is switched on. If the warning light remains on or comes on with the engine running, it isaccompanied by an audible signal andthe message "ESP/ASR not opera-
tional" on the multifunction display;
contact a PEUGEOT dealer. With the engine running and the vehi- cle moving, it flashes when the systemcomes into operation (if there is a dif-ference between the trajectory fol-lowed by the vehicle and that desiredby the driver). It comes on permanently when the system is disarmed.
* According to destination.
Passenger air bag disarming indicatorlight*
Switching on of this indicator light is accompanied by an audible signal andthe message "Passenger air bag dis-
armed" on the multifunction display.
If the passenger air bag is disarmed,the indicator light switches on andremains on. In all cases, if the warning light flashes,
contact a PEUGEOT dealer.
Battery charge warning light This can indicate any of the
following situations:
Ð faulty operation of the charging circuit,
Ð loose battery or starter terminals, Ð a cut or slack alternator belt,Ð an alternator fault.
Contact a PEUGEOT dealer.
07-10-2002

INSTRUMENTS AND CONTROLS29
Front and side air bags warning light The warning light comes on
for a few seconds when the ignition is switched on. Switching on of this warning light, with the engine running, is accompanied byan audible signal and a message onthe multifunction display indicating afault in the air bags.
Contact a PEUGEOT dealer.
Seat belt not fastened warning light* When the ignition is switched
on, the warning light comes on when the driver has not fastened his seat belt. Engine autodiagnostics warning light This comes on each time the
ignition is switched on. If it comes on when the engine is run-ning, it indicates a malfunction in theinjection, ignition or emission control
system. There is a risk of damage to
your catalytic converter.
Contact a PEUGEOT dealer rapidly.
Low fuel level warning light When the warning light first
comes on, you have enough fuel to drive at least 35 miles (50 km) (the tank capac-
ity is approximately 47 litres (10.3 gallons).
Coolant temperature indicator light
Ð When the needle is in zone (A), the
temperature is correct.
Ð When the needle is in zone ( B), the
temperature is too high. The central
STOP warning light flashes.
You must stop immediately.
Contact a PEUGEOT dealer.
Dynamic stability control (ESP/ASR) warning light This comes on for a few seconds each time the igni-
tion is switched on. If the warning light remains on or comes on with the engine running, it isaccompanied by an audible signal andthe message "ESP/ASR not opera-
tional" on the multifunction display;
contact a PEUGEOT dealer. With the engine running and the vehi- cle moving, it flashes when the systemcomes into operation (if there is a dif-ference between the trajectory fol-lowed by the vehicle and that desiredby the driver). It comes on permanently when the system is disarmed.
* According to destination.
Passenger air bag disarming indicatorlight*
Switching on of this indicator light is accompanied by an audible signal andthe message "Passenger air bag dis-
armed" on the multifunction display.
If the passenger air bag is disarmed,the indicator light switches on andremains on. In all cases, if the warning light flashes,
contact a PEUGEOT dealer.
Battery charge warning light This can indicate any of the
following situations:
Ð faulty operation of the charging circuit,
Ð loose battery or starter terminals, Ð a cut or slack alternator belt,Ð an alternator fault.
Contact a PEUGEOT dealer.
07-10-2002

INSTRUMENTS AND CONTROLS
30
Instrument panel display After switching on the ignition, three functions are shown in succession:
Ð service indicator (see corresponding section),
Ð engine oil level indicator,Ð total distance recorder/total and trip distances.Note:
the total and trip distances are displayed for 30 seconds when the ignition
is switched off, on opening the driver's door, as well as on locking and unlocking the vehicle. Engine oil level When the ignition is switched on, the engine oil level is indicated for approximately 10 seconds, after the servicing information.
Maximum Check the level using the dipstick to confirm whether the level indicated is correct; a surplus ofoil can cause damage to the engine.
Consult a PEUGEOT dealer without delay. Minimum Check the level with the dipstick and top it up. The level indicated is only correct if the vehiclehas been on stable, level ground, with the enginestopped, for 10 minutes. Oil level gauge fault The 6 segments flash to indicate a fault in the oil level gauge. There is a risk the engine will be damaged.
Consult a PEUGEOT dealer.
Engine oil temperature indicator light When the engine is running, it indi- cates the oil temperature:
Ð When the needle is in zone
(C), the
temperature is correct,
Ð When the needle is in zone (D), the
temperature is too high. To lower the oil temperature, reduce yourspeed.
07-10-2002

INSTRUMENTS AND CONTROLS
30
Instrument panel display After switching on the ignition, three functions are shown in succession:
Ð service indicator (see corresponding section),
Ð engine oil level indicator,Ð total distance recorder/total and trip distances.Note:
the total and trip distances are displayed for 30 seconds when the ignition
is switched off, on opening the driver's door, as well as on locking and unlocking the vehicle. Engine oil level When the ignition is switched on, the engine oil level is indicated for approximately 10 seconds, after the servicing information.
Maximum Check the level using the dipstick to confirm whether the level indicated is correct; a surplus ofoil can cause damage to the engine.
Consult a PEUGEOT dealer without delay. Minimum Check the level with the dipstick and top it up. The level indicated is only correct if the vehiclehas been on stable, level ground, with the enginestopped, for 10 minutes. Oil level gauge fault The 6 segments flash to indicate a fault in the oil level gauge. There is a risk the engine will be damaged.
Consult a PEUGEOT dealer.
Engine oil temperature indicator light When the engine is running, it indi- cates the oil temperature:
Ð When the needle is in zone
(C), the
temperature is correct,
Ð When the needle is in zone (D), the
temperature is too high. To lower the oil temperature, reduce yourspeed.
07-10-2002

INSTRUMENTS AND CONTROLS31
Hazard warning lights
Press the button, the direction indica- tors flash.
They can operate with the ignition off.
Automatic lighting of hazard warning lights*
When braking in an emergency, depending on the force of decelera-tion, the hazard warning lights come
on automatically. They switch off auto-matically the first time you accelerate.
It is also possible to switch them off by pressing the button.
* According to destination.Total distance recorder Briefly pressing button 1alternates
between the total distance and trip dis- tance displays.
To reset the trip recorder to zero, when it is displayed press and hold the resetbutton for just over 3 seconds.Lighting rheostat With the lights on, press the button to vary the intensity of the lighting on theinstrument panel and the multifunction
display. When the lighting reaches theminimum (or maximum) setting, releasethe button then press it again toincrease (or reduce) the brightness. As soon as the lighting is of the required brightness, release the button.
07-10-2002

YOUR 206 CC IN DETAIL
36
GENERAL FUNCTIONS On/off With the ignition key in the accessories or ignition position, press button Ato switch the set on or off.
The set can operate for 30 minutes without the vehicle ignition being switched on.
Anti-theft systemThe audio system is coded in such a way that it can operate only on your vehicle. It would not function if fitted to another vehicle. The anti-theft system is automatic and requires no action on your part. ADJUSTING THE VOLUME Press the button Cto increase the volume, or button Bto decrease it.
Continuous pressure on buttons Band Callows a gradual adjustment of the volume.
AUDIO SETTINGS Press button Gseveral times in succession to access the bass (BASS), treble (TREB) , loudness (LOUD), fader
(FAD) , balance (BAL)and automatic volume correction.
Exit from audio mode is automatic after a few seconds without pressing any button, or by pressing button G after
configuration of the automatic volume correction. Note: bass and treble settings are specific to each source. It is possible to set them differently for radio, CD or
CD changer.
07-10-2002

07-10-2002
Navigation / Guidance Following selection of the"Navigation/guidance"menu, a
screen warns you about the use of the navigation system. Follow the regulations in force and do not use the remotecontrol while driving. Press the "VAL" button to access the next screen.
The "Navigation/guidance" menu offers various options for
selecting guidance:
Ð By entering the address of a new destination.
Ð By selecting a service (hotel, station, airport...) available in a town.
Ð By selecting an address stored in one of the two direc- tories.
Ð By resuming previously interrupted guidance or by stop- ping current guidance. Two messages may be displayed depending on the previous actions: "Resume guidance"
or "Stop guidance" .
Ð Radio functions are suspended when the system is in guidance mode.Main menu Switch on the ignition. Press the "Menu"button to access the main menu.
Select a function using the direction arrows, then confirm ( "VAL" button).
YOUR 206 CC IN DETAIL 47

07-10-2002
Navigation / Guidance Following selection of the"Navigation/guidance"menu, a
screen warns you about the use of the navigation system. Follow the regulations in force and do not use the remotecontrol while driving. Press the "VAL" button to access the next screen.
The "Navigation/guidance" menu offers various options for
selecting guidance:
Ð By entering the address of a new destination.
Ð By selecting a service (hotel, station, airport...) available in a town.
Ð By selecting an address stored in one of the two direc- tories.
Ð By resuming previously interrupted guidance or by stop- ping current guidance. Two messages may be displayed depending on the previous actions: "Resume guidance"
or "Stop guidance" .
Ð Radio functions are suspended when the system is in guidance mode.Main menu Switch on the ignition. Press the "Menu"button to access the main menu.
Select a function using the direction arrows, then confirm ( "VAL" button).
YOUR 206 CC IN DETAIL 47