2001 YAMAHA YFM400F steering

1-4
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-1.frame
ER
2
WARNING5FE-21568-11
Improper ATV use can result in SEVERE
INJURY or DEATH.ALWAYS USE
AN APPROVED
HELMET AND
PROTECTIVE
GEARNEVER USE
ON PUBLIC
ROADSNEVER CARRY
PASSENGERSNEVER USE
WITH DRUGS
OR ALCOHOLNEVER operate :• without proper training or instruction.
• at speeds too fast for your skills or
the conditions.
• on public roads-a collision can occur
with another vehicle.
• with a passenger-passengers affect balance
and steering and increase risk
of losing control.ALWAYS :• use proper riding techniques to avoid vehicle overturns on hills and rough terrain
and in turns.
• avoid paved surfaces-pavement may
seriously affect handling and control. LOCATE AND READ OWNER'S MANUAL.
FOLLOW ALL INSTRUCTIONS AND WARNINGS.
3
WARNING5FE-21696-01
IMPROPER TIRE PRESSURE OR OVERLOADING CAN
CAUSE LOSS OF CONTROL.
LOSS OF CONTROL CAN RESULT IN SEVERE
INJURY OR DEATH.OPERATING TIRE PRESSURE :
Set with tires cold
• Recommended : FRONT : 25 kPa, { 0.25 kgf/cm
2}, 3.6 psi
REAR : 25 kPa, { 0.25 kgf/cm2}, 3.6 psi
• Minimum : FRONT : 22 kPa, { 0.22 kgf/cm2}, 3.2 psi
REAR : 22 kPa, { 0.22 kgf/cm2}, 3.2 psi
• Never set tire pressure below minimum.
It could cause the tire to dislodge from the rim.LOADING / TRAILER TOWING• Cargo or a trailer can affect stability and handling.
Read owner's manual before loading or towing.
• When loading with cargo or towing a trailer :
Reduce speed and allow more room to stop.
Avoid hills and rough terrain.
• Maximum Vehicle Load : 210 kg, (463 lbs).
Includes weight of operator, cargo and accessories
(and if applicable, trailer tongue weight).

6-25
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-6.frame
EL
l
Do not mount an accessory where it could
interfere with your ability to control the
ATV. Examples include (but are not limited
to) a heavy or bulky object attached to the
handlebars which could make steering diffi-
cult, an accessory that limits your ability to
move around on the seat, or one that limits
your view.
l
Use extra caution when riding an ATV with
accessories. The ATV may handle different-
ly than it does without accessories.

7-59
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-7.frame
EL
CROSSING A SLOPE
Traversing a sloping surface on your ATV re-
quires you to properly position your weight to
maintain proper balance. Be sure that you
have learned the basic riding skills on flat
ground before attempting to cross a sloping
surface. Avoid slopes with slippery surfaces or
rough terrain that may upset your balance.
As you travel across a slope, lean your body in
the uphill direction. It may be necessary to cor-
rect the steering when riding on loose surfaces
by pointing the front wheels slightly uphill.
When riding on slopes be sure not to make
sharp turns either up or down hill.

7-71
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-7.frame
EL
SLIDING AND SKIDDING
Care should be used when riding on loose or
slippery surfaces since the ATV may slide. If
unexpected and uncorrected, sliding could
lead to an accident.
To reduce the tendency for the front wheels to
slide in loose or slippery conditions, position-
ing your weight over the front wheels will
sometimes help.
If the rear wheels of your ATV start to slide
sideways, control can usually be regained (if
there is room to do so) by steering in the direc-
tion of the slide. Applying the brakes or accel-
erating is not recommended until you have
corrected the slide.

Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-8.frame
ER
8-8
* It is recommended that these items be serviced by a Yamaha dealer.NOTE:

Recommended brake fluid: DOT 4
Brake fluid replacement:
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally
check the brake fluid level and add fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two
years.
3. Replace the brake hoses every four years, or if cracked or damaged.
V-belt*

• Check operation.
• Check for cracks or damage every 12 months or
2,400 km whichever comes first.

Wheels*

• Check balance/damage/runout.
• Repair if necessary.

Wheel bearing*

• Check bearing assemblies for looseness/damage.
• Replace if damaged.

Front and rear
suspension*

• Check operation.
• Correct if necessary.

Steering system*

• Check operation/Replace if damaged.
• Check toe-in/Adjust if necessary.

Front axle boots*
• Check operation.
• Replace if damaged.
Fittings and Fasteners*
• Check all chassis fittings and fasteners.
• Correct if necessary.
ITEM ROUTINEINITIAL EVERY
1
month3
months6
months6
months1
year