6-40
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9 6.While supporting the brake
caliper, pull the wheel axle out.
7.Remove the wheel.
ECA00048
cCDo not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
1
EAU01620
To install the rear wheel
1.Install the brake caliper onto the
swingarm as shown.NOTE:
Make sure that the slot in the brake
caliper bracket fits over the retainer
on the swingarm.2.Install the drive chain onto the
rear sprocket.
3.Insert the wheel axle from the
left-hand side, install the axle
nut, and then lower the rear
wheel so that it is on the ground.
NOTE:
Make sure that there is enough
space between the brake pads
before inserting the brake disc
between the brake pads.4.Adjust the drive chain slack.
(See page 6-26 for drive chain
slack adjustment procedures.)
5.Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
104 Nm (10.4 m0kg)
1.Retainer
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 75
SPECIFICATIONS
8
8-5
EAU01064
Conversion tableAll specification data in this manual are listed in SI and
METRIC UNITS.
Use this table to convert METRIC unit data to
IMPERIAL unit data.
Ex.
METRICMULTIPLIERIMPERIAL
** mm´0.03937=** in
2 mm´0.03937=0.08 inCONVERSION TABLE
METRIC TO IMPERIAL
Metric unitMultiplierImperial unit
m¥kg7.233ft¥lb
Torquem¥kg86.794in¥lb
cm¥kg0.0723ft¥lb
cm¥kg0.8679in¥lb
Weightkg2.205lbg0.03527oz
Speedkm/hr0.6214mph
km0.6214mi
m3.281ft
Distancem1.094yd
cm0.3937in
mm0.03937in
cc (cm
3)0.03527oz (IMP liq.)
Volume/cc (cm3)0.06102cu¥in
CapacityL (liter)0.8799qt (IMP liq.)
L (liter)0.2199gal (IMP liq.)
kg/mm55.997lb/in
Misc.kg/cm
2
14.2234psi (lb/in
2)
Centigrade (¡C)9/5+32Fahrenheit (¡F)
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 88
