
EAU00009
TABLE OF CONTENTS
GIVE SAFETY THE RIGHT OF WAY.................1-1
DESCRIPTION....................................................2-1
Left view...........................................................2-1
Right view.........................................................2-2
Controls and instruments..................................2-3
INSTRUMENT AND CONTROL FUNCTIONS....3-1
Main switch/steering lock..................................3-1
Indicator and warning lights..............................3-2
Speedometer unit.............................................3-3
Tachometer......................................................3-3
Coolant temperature gauge..............................3-4
Handlebar switches..........................................3-4
Clutch lever.......................................................3-6
Shift pedal.........................................................3-6
Brake lever.......................................................3-7
Brake pedal......................................................3-7
Fuel tank cap....................................................3-7
Fuel (except for Switzerland and Austria).........3-8
Fuel (for Switzerland and Austria)....................3-8
Catalytic converter
(for Switzerland and Austria)..........................3-9
2-stroke engine oil..........................................3-10
Fuel cock........................................................3-11
Starter (choke) lever ......................................3-12
Seat................................................................3-12Helmet holder.................................................3-13
Adjusting the shock absorber assembly.........3-13
YEIS handling precautions.............................3-14
YPVS..............................................................3-14
Sidestand........................................................3-15
Ignition circuit cut-off system..........................3-16
PRE-OPERATION CHECKS...............................4-1
Pre-operation check list....................................4-1
OPERATION AND IMPORTANT RIDING
POINTS...............................................................5-1
Starting a cold engine.......................................5-1
Starting a warm engine.....................................5-2
Shifting..............................................................5-3
Recommended shift points
(for Switzerland only)......................................5-3
Tips for reducing fuel consumption...................5-4
Engine break-in................................................5-4
Parking.............................................................5-5
PERIODIC MAINTENANCE AND MINOR
REPAIR...............................................................6-1
OwnerÕs tool kit.................................................6-1
Periodic maintenance and lubrication chart......6-2
Removing and installing cowlings and panel....6-5
Checking the spark plug...................................6-7
123
456
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 5

Transmission oil................................................6-8
Coolant...........................................................6-10
Cleaning the air filter element.........................6-13
Adjusting the carburetor.................................6-15
Adjusting the engine idling speed...................6-16
Adjusting the throttle cable free play..............6-17
Tires................................................................6-17
Wheels............................................................6-20
Adjusting the clutch lever free play.................6-20
Adjusting the brake lever free play.................6-21
Adjusting the brake pedal position..................6-22
Adjusting the rear brake light switch...............6-22
Checking the front and rear brake pads.........6-23
Checking the brake fluid level.........................6-24
Changing the brake fluid.................................6-25
Drive chain slack............................................6-25
Lubricating the drive chain..............................6-26
Checking and lubricating the cables...............6-27
Checking and lubricating the throttle grip
and cable......................................................6-28
Adjusting the Autolube pump..........................6-28
Checking and lubricating the brake and shift
pedals...........................................................6-29
Checking and lubricating the brake and
clutch levers..................................................6-29
Checking and lubricating the sidestand..........6-29Lubricating the rear suspension.....................6-30
Checking the front fork...................................6-30
Checking the steering.....................................6-31
Checking the wheel bearings.........................6-32
Battery............................................................6-32
Replacing the fuse..........................................6-33
Replacing a headlight bulb.............................6-34
Replacing the tail/brake light bulb...................6-35
Replacing a turn signal light bulb....................6-36
Supporting the motorcycle..............................6-37
Front wheel.....................................................6-37
Rear wheel.....................................................6-39
Troubleshooting..............................................6-41
Troubleshooting charts...................................6-42
MOTORCYCLE CARE AND STORAGE.............7-1
Care..................................................................7-1
Storage.............................................................7-4
SPECIFICATIONS...............................................8-1
Conversion table...............................................8-5
CONSUMER INFORMATION.............................9-1
Identification numbers......................................9-1
Key identification number.................................9-1
Vehicle identification number............................9-1
Model label.......................................................9-2
TABLE OF CONTENTS
789
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 6

6-4
PERIODIC MAINTENANCE AND MINOR REPAIR
6
20
*Autolube pump¥Check operation.
¥Bleed if necessary.ÖÖÖÖ
21Transmission oil¥Check.ÖÖÖÖÖÖ
¥Change.ÖÖ
22*Cooling system¥Check coolant level and vehicle for coolant leakage.ÖÖÖÖÖ
¥Change.Every 3 years
23*Front and rear brake
switches¥Check operation.ÖÖÖÖÖÖ
24Moving parts and cables¥Lubricate.ÖÖÖÖÖ
25*Lights, signals and
switches¥Check operation.
¥Adjust headlight beam.ÖÖÖÖÖÖ NO.ITEMCHECK OR MAINTENANCE JOBODOMETER READING (´1,000 km)
ANNUAL
CHECK
16121824
EAU03541
NOTE:
8The air filter needs more frequent service if you are riding in unusually wet or dusty areas.
8Hydraulic brake service
9Regularly check and, if necessary, correct the brake fluid level.
9Every two years replace the internal components of the brake master cylinder and caliper, and change the brake
fluid.
9Replace the brake hoses every four years and if cracked or damaged.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 39

6-22
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
a
1
EAU00712
Adjusting the brake pedal
positionThe top of the brake pedal should be
positioned approximately 23 mm
below the top of the footrest as
shown. Periodically check the brake
pedal position and, if necessary,
have a Yamaha dealer adjust it.1.Footrest
a.Brake pedal position
EW000109
wA soft or spongy feeling in the
brake pedal can indicate the pres-
ence of air in the hydraulic system.
If there is air in the hydraulic sys-
tem, have a Yamaha dealer bleed
the system before operating the
motorcycle. Air in the hydraulic
system will diminish the braking
performance, which may result in
loss of control and an accident.
EAU00713
Adjusting the rear brake light
switchThe rear brake light switch, which is
activated by the brake pedal, is prop-
erly adjusted when the brake light
comes on just before braking takes
effect. If necessary, adjust the brake
light switch as follows.
Turn the adjusting nut while holding
the rear brake light switch in place.
To make the brake light come on ear-
lier, turn the adjusting nut in direction
a. To make the brake light come on
later, turn the adjusting nut in direc-
tion b.
b
a12
1.Rear brake light switch
2.Adjusting nut
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 57

6-35
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU01078
Replacing the tail/brake light
bulb1.Remove the seat. (See page
3-12 for seat removal and instal-
lation procedures.)
2. Remove panel A. (See page 6-6
for panel removal and installation
procedures.)
EC000105
cCDo not touch the glass part of the
headlight bulb to keep it free from
oil, otherwise the transparency of
the glass, the luminosity of the
bulb, and the bulb life will be
adversely affected. Thoroughly
clean off any dirt and fingerprints
on the headlight bulb using a cloth
moistened with alcohol or thinner.5.Install the bulb cover, and then
connect the coupler.
6.Install the cowling.
a
a.Do not touch this area.
7.Have a Yamaha dealer adjust
the headlight beam if necessary.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 70

1
2
3
4
5
67
8
9
7-2
8Do not use any harsh chemical
products on plastic parts. Be
sure to avoid using cloths or
sponges which have been in
contact with strong or abra-
sive cleaning products, sol-
vent or thinner, fuel (gasoline),
rust removers or inhibitors,
brake fluid, antifreeze or elec-
trolyte.
8Do not use high-pressure
washers or steam-jet cleaners
since they cause water seep-
age and deterioration in the
following areas: seals (of
wheel and swingarm bearings,
fork and brakes), electric com-
ponents (couplers, connec-
tors, instruments, switches
and lights), breather hoses
and vents.8For motorcycles equipped
with a windshield: Do not use
strong cleaners or hard
sponges as they will cause
dulling or scratching. Some
cleaning compounds for plas-
tic may leave scratches on the
windshield. Test the product
on a small hidden part of the
windshield to make sure that it
does not leave any marks. If
the windshield is scratched,
use a quality plastic polishing
compound after washing.
After normal useRemove dirt with warm water, a mild
detergent, and a soft, clean sponge,
and then rinse thoroughly with clean
water. Use a toothbrush or bottle-
brush for hard-to-reach areas.
Stubborn dirt and insects will come
off more easily if the area is covered
with a wet cloth for a few minutes
before cleaning.After riding in the rain, near the sea
or on salt-sprayed roadsSince sea salt or salt sprayed on
roads during winter are extremely
corrosive in combination with water,
carry out the following steps after
each ride in the rain, near the sea or
on salt-sprayed roads.NOTE:
Salt sprayed on roads in the winter
may remain well into spring.1.Clean the motorcycle with cold
water and a mild detergent, after
the engine has cooled down.
ECA00012
cCDo not use warm water since it
increases the corrosive action of
the salt.2.Apply a corrosion protection
spray on all metal, including
chrome- and nickel-plated, sur-
faces to prevent corrosion.
MOTORCYCLE CARE AND STORAGE
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 80

SPECIFICATIONS
1
2
3
4
5
6
78
9
Wheels
Front
TypeCast
Size18 ´MT2.15
Rear
TypeCast
Size17 ´MT2.50
Brakes
Front
TypeSingle disc brake
OperationRight hand
FluidDOT 4
Rear
TypeSingle disc brake
OperationRight foot
FluidDOT 4
Suspension
Front
TypeTelescopic fork
Rear
TypeSwingarm (Monocross)Spring/shock absorber
Front
TypeCoil spring / oil damper
Rear
TypeCoil-gas spring / oil damper
Wheel travel
Front180 mm
Rear180 mm
Electrical
Ignition systemC.D.I.
Charging system
TypeC.D.I. magneto
Standard output14 V, 12A @5,000 r/min
Battery
TypeYTX5L-BS
Voltage, capacity12 V, 4 AH
Headlight typeQuartz bulb (halogen)
Bulb voltage, wattage ´quantity
Headlight12 V, 60/55W ´2
12 V, 35/35W ´2 (GB, IRL)
8-3
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 86

SPECIFICATIONS
1
2
3
4
5
6
78
9
8-4 Tail/brake light12 V, 5/21W ´2
Front turn signal light12 V, 21W ´2
Rear turn signal light12 V, 21W ´2
Auxiliary light12 V, 4W ´2
12 V, 3.4W ´2 (GB, IRL)
Meter lighting12 V, 3.4W ´3
Neutral indicator light12 V, 3.4W ´1
High beam indicator light12 V, 3.4W ´1
Oil level warning light12 V, 3.4W ´1
Turn indicator light12 V, 3.4W ´1
Fuse20A
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 87