2001 SUBARU LEGACY light

7-6
HB3008BB
2. Remove the fuel filler c ap b y turning it slowly counterc loc kwise.
3. Stop filling the tank after the fuel filler p ump automatic ally c lic ks off.
Do not ad d any more fuel.
4. Put the c ap b ac k on, turn it c loc kwise until you hear a c lic king
noise. Be c ertain not to c atc h the tether und er the c ap while tig hten-
ing .
5. Close the fuel filler lid c omp letely.
If you sp ill any fuel on the p ainted surfac e, rinse it off immed iately.
Otherwise, the p ainted surfac e c ould b e d amag ed . NOTE If the fuel filler cap is not tightened until it clicks or if the tether is caught under the cap, the CHECK ENGINE warning light maycome on. Refer to the “Warning and indicator lights ” section lo-
cated in chapter 3.
State emission testing (U.S. only)
WARNING
Testing of an All-Wheel Drive vehicle must NEVER be performed
on a single two-wheel dynamometer. Attempting to do so willresult in uncontrolled vehicle movement and may cause an acci-
dent or injuries to persons nearby.

7-24started . This is c aused b y an automatic func tional
test of the ABS sys-
tem b eing c arried out and d oes not ind ic ate any ab n ormal c ond ition.
ABS warning light
HB4010GA
The ABS warning lig ht c omes on when the ig nition sw itc h is turned to
the “ON ” p osition and g oes out after ab out two sec ond s.
This is an ind ic ation that the ABS system is workin g p rop erly.
CAUTION
If the warning light behaves as follows, the ABS system may not
be working properly.When the warning light is on, the ABS function shuts down; how-
ever, the conventional brake system continues to operate normal-
ly. The warning light does not come on when the ignition switch
is turned to the “ON” position.
The warning light comes on when the ignition switch is turned
to the “ON” position, but it does not go out even when the vehicle
speed exceeds approximately 8 mph (12 km/h). The warning light comes on during driving.
If these occur, have the ABS system repaired at the first available
opportunity by your SUBARU dealer.

Starting and operating7-25
–
CONTINUED –
NOTE
If the warning light behavior is as described below, the ABS sys- tem may be considered normal.
The warning light comes on right after the engine is started
but goes out immediately, remaining off. The warning light remains on after the engine has been
started, but it goes out when the vehicle speed reaches about 8mph (12 km/h). The warning light comes on during driving, but it goes out
immediately and remains off.
When d riving with an insuffic ient b attery voltag e s uc h as when the en-
g ine is jump started , the ABS warning lig ht may c om e on. This is d ue
to the low b attery voltag e and d oes not ind ic ate a malfunc tion. When
the b attery b ec omes fully c harg ed , the lig ht will g o out.
VDC (Vehicle Dynamics Control) system (if equipped)
WARNING
Always use the utmost care in driving — overconfidence because
you are driving with a VDC system equipped vehicle could easily lead to a serious accident.
CAUTION
Even if your vehicle is equipped with VDC, winter tires or snow
chains should be used when driving on snow-covered or icyroads; in addition, vehicle speed should be reduced consider-
ably. Simply having a VDC system does not guarantee that the
vehicle will be able to avoid accidents in any situation. Activation of the VDC system is an indication that the road
being travelled on has a slippery surface; since having VDC is no
guarantee that full vehicle control will be maintained at all timesand under all conditions, its activation should be seen as a sign
that the speed of the vehicle should be reduced considerably.

Starting and operating7-27
–
CONTINUED –
ind ic ator lig ht will flash on and off when this sys
tem ac tivates.
NOTE Slight twitching of the brake pedal may be felt when the VDC-sys-
tem operates; a small degree of vehicle or steering wheel shaking may also be noticed in this situation. These are normal effects of
VDC operation and are no cause for alarm. When driving off immediately after starting the engine, a short-
lived operation noise may be noticed coming from the enginecompartment. This noise is generated as a result of a check beingperformed on the VDC system and is normal. Depending on the timing of activation of the brakes, certain situa-
tions may occur just after driving off where the brake pedal seemsto exhibit a jolting motion. This too is a consequence of the VDCoperational check and is normal. Activation of the VDC system will cause operation of the steering
wheel to feel slightly different compared to that for normal condi-tions. Even if the vehicle is equipped with a VDC system, it is important
that winter tires be used when driving on snow-covered or icyroads. (All four wheels should be fitted with tires of the same sizeand brand). Furthermore, if snow chains are to be used, they shouldbe fitted on the front wheels. When a vehicle is fitted with snow
chains, however, the effectiveness of the VDC system is reduced
and this should be taken into account when driving the vehicle insuch a condition. It is always important to reduce speed when approaching a cor-
ner, even if the vehicle is equipped with VDC. All four wheels should be fitted with tires of the same size, type,
and brand; furthermore, the amount of wear should be the same for
all four tires. If these precautions are not observed and non-match-ing tires are used, it is quite possible that the VDC system will beunable to operate correctly as intended. Always turn off the engine before replacing a tire as failure to do
so may render the VDC system unable to operate correctly.

7-28
VDC system monitor
HB4010FB
nVDC OFF indicator light
The VDC OFF ind ic ator lig ht turns on initially when the ig nition key
is turned to the ON p osition; it sub seq uently turns off 6 sec ond s after
the eng ine is started . This lig ht turns on to ind ic ate that the VDC and TC S systems are in
non-op eration (read y) mod e. This d oes not c onstitut e failure of the
VDC system. NOTE When the engine is started on cold mornings and in other sim-
ilar circumstances, a certain amount of time may pass before the
VDC OFF indicator light turns off. This occurs because the
engine has not yet warmed up and is completely normal. The
light will turn off when the engine has reached a suitable operat-ing temperature. When an engine problem occurs and the CHECK ENGINE
warning light turns on, the VDC OFF indicator light will also turnon. Depending on the type of gasoline used, it may take sometime
before the light goes out after the engine has been started.
The following two situations c ould ind ic ate malfunc tion of the VDC
system; if either should oc c ur, have an authorized SUBARU d ealer
c arry out an insp ec tion of that system at the first availab le op p ortunity.

Starting and operating7-29
–
CONTINUED –

The VDC OFF ind ic ator lig ht d oes not turn on when t he ig nition key
is turned to the ON p osition. The VDC OFF ind ic ator lig ht fails to turn off after the eng ine is
started , even when several minutes have p assed to a llow the eng ine
to heat up suffic iently. n VDC operation indicator light
The VDC op eration ind ic ator lig ht turns on when the ig nition key is
turned to the ON p osition; it turns off ap p roximate ly two sec ond s later.
It flashes on and off when the VDC is op erating b ut stays c ontinuously
lit when only the TCS is op erating .
The following two situations c ould ind ic ate a malfu nc tion of the VDC
system; if either should oc c ur, have an authorized SUBARU d ealer
c arry out an insp ec tion of that system at the first availab le op p ortunity.
The VDC op eration ind ic ator lig ht d oes not turn on when the ig ni-
tion key is turned to the ON p osition. The VDC op eration ind ic ator lig ht d oes not turn off ap p roximately
two sec ond s after the ig nition key has b een turned to the ON p osition.
n VDC warning light
The VDC warning lig ht turns on when the ig nition ke y is turned to the
ON p osition and off when the eng ine is started . Thi s lig hting p attern
ind ic ates that the VDC system is op erating normally .
The following situations c ould ind ic ate a malfunc ti on of the VDC sys-
tem; if any should oc c ur, have an authorized SUBARU d ealer c arry
out an insp ec tion of the system at the first availa b le op p ortunity.
The VDC warning lig ht d oes not turn on when the ig n ition key is
turned to the ON p osition. The VDC warning lig ht d oes not turn off either when the eng ine is
started or when the vehic le reac hes a sp eed of ap p r oximately 8 mp h
(12 km/h). The VDC warning lig ht turns on while the vehic le is b eing d riven.
When a malfunc tion has oc c urred in the VDC elec tric al system,
only the VDC warning lig ht will turn on. In suc h an event, the ABS will
still b e op erating normally.

7-30
The VDC warning lig ht will also turn on when a p rob lem oc c urs
with the ABS or VDC elec tronic c ontrol systems.
Bec ause the VDC system c ontrols eac h b rake throug h the ABS,
whenever the ABS stop s op erating d ue to a malfunc ti on in that elec tri-
c al system, the VDC will also b ec ome unab le to c ont rol all four
b rakes. Thus VDC system op eration halts and the VDC warning lig ht
turns on. Althoug h b oth the VDC system and the ABS will b e inop er-
ab le in this situation, it will still b e p ossib le t o stop the vehic le using
normal b raking . The VDC system and the ABS d o not a d versely affec t
op eration of the vehic le in any way when they are i nop erab le; how-
ever should suc h a situation oc c ur, d rive with c are and have an autho-
rized SUBARU d ealer c arry out an insp ec tion of thos e systems at the
first availab le op p ortunity. NOTE
When the VDC warning light turns on and off in the following way,
it indicates that the VDC system is operating normally. Although turning on after the engine has been started, the
warning light quickly turns off and stays off. The warning light turns on after the engine is started and does
not turn off until the vehicle reaches a speed of 8 mph (12 km/h). The warning light turns on when the vehicle is being driven; it
then turns off and stays off.

Driving tips8-35
–
CONTINUED –
In c ase the trailer hitc h c onnec tor or hitc h b all s
hould b reak or
b ec ome d isc onnec ted , the trailer c ould g et loose an d c reate a traffic
safety hazard .
For safety, always c onnec t the towing vehic le and t railer with trailer
safety c hains. Pass the c hains c rossing eac h other und er the trailer
tong ue to p revent the trailer from d rop p ing onto th e g round in c ase
the trailer tong ue should d isc onnec t from the hitc h b all. Allow suffi-
c ient slac k in the c hains taking tig ht-turn situati ons into ac c ount; how-
ever, b e c areful not to let them d rag on the g round .
For more information ab out the safety c hain c onnec t ion, refer to the
instruc tions for your hitc h and trailer. n Side mirrors
After hitc hing a trailer to your vehic le, c hec k tha t the stand ard sid e
mirrors p rovid e a g ood rearward field of view witho ut sig nific ant b lind
sp ots. If sig nific ant b lind sp ots oc c ur with the ve hic le’s stand ard sid e
mirrors, use towing mirrors that c onform with Fed er al, state/p rovinc e
and /or other ap p lic ab le reg ulations.
HB0085
n Trailer lights CAUTION
Direct splicing or other improper connection of trailer lights may
damage your vehicle ’s electrical system and cause a malfunction
of your vehicle ’s lighting system.