Page 390 of 453
Maintenance and service11-17
–
CONTINUED –
HBB004FB
HBB007BB
4. Slowly p our the c oolant and fill to the rad iator filler nec k and to the
reserve tank ’s “FULL ” level mark. Do not p our the c oolant too q uic kly,
as this may lead to insuffic ient air b leed ing and t rap p ed air in the sys-
tem.
Coolant c ap ac ity: 2.5 liter mod els MT. 7.2 US q t (6.8 liters, 6.0 Imp q t)
AT. 7.1 US q t (6.7 liters, 5.9 Imp q t)
3.0 liter mod els 8.1 US q t (7.7 liters, 6.7 Imp q t)
HG0115
Rubber gaskets
5. Put the rad iator c ap b ac k on and tig hten firmly. At this time, make
sure that the rub b er g asket in the rad iator c ap is c orrec tly in p lac e.
6. Start and run the eng ine for more than five minut es at 2,000 to
3,000 rp m.
Page 392 of 453
Maintenance and service11-19
–
CONTINUED –
n
2.5 liter models
HBA003BB
HBA002BB
BoltAir cleaner element
1. Remove the b olt sec uring the rear air c leaner ele ment c ase.
2. Unsnap the three c lamp s hold ing the rear air c lea ner element
c ase.
3. Sep arate the rear air c leaner element c ase from t he front air c lean-
er element c ase and remove the air c leaner element.
4. Clean the insid e of the front and rear air c leane r element c ases
with a d amp c loth and install a new air c leaner ele ment.
5. Insert the four p rojec tions on the rear air c lean er element c ase into
the slits on the front air c leaner element c ase and snap the three
c lamp s on the rear air c leaner element c ase and the n tig hten the b olt.
n 3.0 liter models
HBB056BA
1. Unsnap the two c lamp s hold ing the air c leaner c as e c over.
Page 394 of 453
Maintenance and service11-21
–
CONTINUED –
HBA004BA
It may b e d iffic ult to rep lac e the sp ark p lug s. It is rec ommend ed that you
have the sp ark p lug s rep lac ed b y your SUBARU d ealer .
The sp ark p lug s should b e rep lac ed ac c ord ing to the maintenanc e
sc hed ule in the “Warranty and Maintenanc e Booklet ”.
Recommended spark plugs
2.5 liter mod els: RC10YC4 (Champ ion)
RC8YC4 (Champ ion)
BKR6E-11 (NGK)
K20PR-U11 (NIPPON DENSO)
3.0 liter mod els: PLFR6A-11 (NGK)
Page 396 of 453
Maintenance and service11-23
–
CONTINUED –
sc hed ule in the
“Warranty and Maintenanc e Booklet ”. Consult your
SUBARU d ealer for rep lac ement.
If a b elt is loose, c rac ked , or worn, c ontac t your SUBARU d ealer.
Manual transmission oil Checking the oil level
Chec k the oil level monthly.
1. Park the vehic le on a level surfac e and stop the eng ine.
OM-H0210
Upper level Lower level
HBB004DB
2. Pull out the d ip stic k, wip e it c lean, and insert it ag ain.
3. Pull out the d ip stic k ag ain and c hec k the oil lev el on it. If it is b elow
the lower level, ad d oil throug h the d ip stic k hole to b ring the level up
to the up p er level. Recommended grade and viscosity
Eac h oil manufac turer has its own b ase oils and ad d itives. Never use
d ifferent b rand s tog ether.
Oil grade: API classification GL-5
Page 398 of 453
Maintenance and service11-25
–
CONTINUED –
HBA008BB
Upper level
Lower level Upper level
Lower level
HOT range
COLD range
HBB004CB
4. Pull out the d ip stic k and c hec k the fluid level o n the g aug e. If it is
b elow the lower level on the “HOT ” rang e, ad d the rec ommend ed au-
tomatic transmission fluid up to the up p er level. n Checking the fluid level when the fluid is cold
When the fluid level has to b e c hec ked without time to warm up the
automatic transmission, c hec k to see that the fluid level is b etween
the lower level and up p er level on the “COLD ” rang e. If it is b elow that
rang e, ad d fluid up to the up p er level. Be c areful not to overfill.
Recommended fluid
“ Dexron II ” or “Dexron III ” Type Automatic Transmission Fluid
Page 400 of 453