2001 SUBARU LEGACY ESP

Keys and doors2-5
–
CONTINUED –
d oor.
To loc k the
rear door from the outsid e without the key, rotate the loc k
lever rearward and then c lose the d oor.
Always make sure that all d oors and the rear g ate ( station wag on) are
loc ked b efore leaving your vehic le.
NOTE
Make sure that you do not leave the key inside the vehicle before
locking the doors from the outside without the key. Locking and unlocking from the inside
WARNING
Keep all doors locked when you drive, especially when small chil- dren are in your vehicle.
Along with the proper use of seat belts and child restraints, lock-ing the doors reduces the chance of being thrown out of the ve-hicle in an accident.It also helps prevent passengers from falling out if a door is acci-
dentally opened, and intruders from unexpectedly opening doorsand entering your vehicle.
HB2001BB
To loc k the d oor from the insid e, rotate the loc k l ever rearward . To un-
loc k the d oor from the insid e, rotate the loc k leve r forward .
The red mark on the loc k lever ap p ears when the d oo r is unloc ked .

Keys and doors2-7
–
CONTINUED –
Keyless entry system (if equipped)
CAUTION
Do not expose the transmitter to severe shocks, such as those
experienced as a result of dropping or throwing. Do not take the transmitter apart except when replacing the
battery. Do not get the transmitter wet. If it gets wet, wipe it dry with a
cloth immediately. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the followingtwo conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received,including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user ’s authority to
operate the equipment.
Two transmitters are p rovid ed for your vehic le.
The keyless entry system has the following func tion s.
Loc king and unloc king the d oors (and rear g ate on t he station wag on)
without a key Sound ing a p anic alarm
Arming and d isarming the sec urity system (if your v ehic le is eq uip p ed
with an op tional sec urity system). See the next sec tion “Sec urity system
(if eq uip p ed ) ” for d etailed information.
The op erab le d istanc e of the keyless entry system i s ap p roximately 30
feet (10 meters). However, this d istanc e will vary d ep end ing on environ-
mental c ond itions. Rang e may b e red uc ed near sourc e s of RF interfer-
enc e suc h as p ower p lants and rad io/television b roa d c asting towers.
The keyless entry system d oes not op erate when the key is inserted in
the ig nition switc h.

3-10We rec ommend that you d rive mod erately until the p o
inter of the temp er-
ature g aug e reac hes near the mid d le of the rang e. E ng ine op eration is
op timum with the eng ine c oolant at this temp erature rang e and hig h rev-
ving op eration when eng ine is not warmed up enoug h should b e
avoid ed .
Warning and indicator lights
Several of the warning and ind ic ator lig hts c ome on momentarily and
then g o out when the ig nition switc h is initially t urned to the “ON ” p osi-
tion. This p ermits c hec king the op eration of the b u lb s.
Ap p ly the p arking b rake and turn the ig nition switc h to the “ON ” p osition.
The following lig hts c ome on:
Seatb elt warning lig ht
SRS airb ag system warning lig ht
CHECK ENGINE warning lig ht / Malfunc tion ind ic ator lamp
Charg e warning lig ht
Oil p ressure warning lig ht
AT OIL temp erature warning lig ht (AT vehic les)
ABS warning lig ht
VDC warning lig ht (if eq uip p ed )
VDC op eration ind ic ator lig ht (if eq uip p ed )
VDC OFF ind ic ator lig ht (if eq uip p ed )
Brake system warning lig ht
If any lig hts fail to c ome on, it ind ic ates a b urne d -out b ulb or a malfunc -
tion of the c orresp ond ing system.
Consult your authorized SUBARU d ealer for rep air. Seatbelt warning light and chime
When the ig nition switc h is turned to the “ON ” p osition, the seatb elt
warning lig ht will c ome on and the remind er c hime w ill sound for ab out
six sec ond s to remind the d river to fasten the seat b elt.
The seatb elt warning lig ht remains on for ab out six sec ond s and turns off
automatic ally after six sec ond s.

Climate control4-7
–
CONTINUED –
4. Set the fan sp eed c ontrol d ial to the hig hest sp e
ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Heating and defrosting
HB5012AA
To d irec t warm air toward the floor and the wind shi eld :
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.

4-8
Heating
HB5013AA
To d irec t warm air toward the floor:
1. Set the air inlet selec tion b utton to the “OFF ” p osition
2 Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Bi-level heating
HB5014AA
This setting allows you to d irec t air of d ifferent temp eratures from the

Climate control4-13
–
CONTINUED –
“
ECON
” ind ic ator lig ht. In the ECON mod e, the c omp ressor runs to
b e thrifty with energ y c onsump tion. Interior wind ow s tend to fog in this
energ y-saving op eration. It is therefore rec ommend e d that the AUTO
mod e b e used only in hig h humid ity c ond itions. Manual mode operation:
When the Automatic Climate Control system is op erat ing in the AUTO
mod e, p ressing the “
”, “”, “MODE ”, “A/C ” or
“
” switc h shifts the op eration into the “MANUAL ” mod e and the
ind ic ator lig ht “AUTO ” on the c ontrol p anel will g o out.
When the “
”, “”, “MODE ”, “A/C ” or “”
switc h is p ressed , the c orresp ond ing func tion c an b e c ontrolled ind e-
p end ently, while automatic c ontrol of the other fun c tions are main-
tained .
To c hang e the system b ac k to the AUTO mod e, p ress t he “AUTO ”
switc h. n OFF switch
The Automatic Climate Control system turns off (the air c ond itioner
c omp ressor and fan turn off) when the “OFF ” switc h is p ressed .
When the “OFF ” switc h is p ressed , the outsid e air introd uc tion mo d e
( “
” p osition) is automatic ally selec ted .
NOTE Setting the light switch to the “p ” or “ a ” position causes the
illuminating icons on the display panel to dim. When traveling with the lights on in gloomy daylight or in twilight, press the OFFswitch for 1 second or longer if you feel it is too hard to identify
the icons clearly. The brightness comes back to normal. n OUT.TEMP switch
To c hec k the outsid e air temp erature, p ush the “OUT.TEMP ” switc h.
The outsid e air temp erature will b e d isp layed for f ive sec ond s, and
then the d isp lay automatic ally c hang es b ac k to the insid e air temp er-
ature.
The d isp lay c hang es over from the insid e air temp er ature to the out-
sid e air temp erature as its normal ind ic ation if yo u keep the switc h
p ressed for more than 2 sec ond s.

Climate control4-15
–
CONTINUED –
With the fan sp eed c ontrol switc h in the AUTO p osit
ion, the fan sp eed
c hang es automatic ally c orresp ond ing to various c ond itions: air tem-
p erature insid e and outsid e of the p asseng er c omp ar tment, intensity
of the sunlig ht, etc .
Use this switc h to selec t d esired fan sp eed . Fan sp eed inc reases with
eac h p ress of the switc h and returns to the AUTO p o sition.
n A/C — Air conditioner switch
NOTE The air conditioner compressor does not operate when the out- side air temperature is below 32 F (0 C).
If the wind shield starts to fog when the air c ond it ioner is op erated in
the AUTO mod e, p ush the air c ond itioner switc h “A/C ” to d efog and
d ehumid ify.
When this switc h is p ushed , the air c ond itioner c om p ressor turns on
and the ind ic ator lig ht “A/C ” on the c ontrol p anel c omes on. After
eliminating the fog g ing from the wind shield , set th e air c ond itioner
b ac k in the AUTO mod e b y p ushing the “AUTO ” switc h.
n MODE — Air flow control switch
(Ventilation) : Air flows throug h the instrument p an el outlets.
(Bi-level) : Air flows throug h the instrument p anel outlets
and the foot outlets.
(Heat) : Air flows throug h the foot outlets and some throug h the wind shield d efroster outlets.
(Heat-d ef) : Air flows throug h the wind shield d efros ter out-
lets and foot outlet.

Audio5-43
–
CONTINUED –

Scan tuning (SCAN)
Turn the tuning d ial inner tuner to c hang e the rad i o to the SCAN
mod e. In this mod e, the rad io sc ans throug h the rad io b and until a
station is found . The rad io will stop at the statio n for five sec ond s
while d isp laying the freq uenc y, after whic h sc annin g will c ontinue until
the entire b and has b een sc anned .
Turn the tuning d ial ’s inner tuner ag ain to c anc el the SCAN mod e and
to stop on any d isp layed freq uenc y.
Sc an tuning may not func tion p rop erly if the statio n rec ep tion is weak-
ened b y d istanc e from the station or p roximity to t all b uild ing s and
hills. Preset tuning
Press any one of the p reset b uttons to selec t the c orresp ond ing , p re-
viously-reg istered rad io station. The LED at the to p of that b utton will
turn on. n Manual preset
Use the tuning d ial to selec t the rad io station whi c h you wish to
reg ister. Choose the p reset b utton to whic h you wish to assig n that station
and p ress it c ontinuously for a p eriod of more than 2 sec ond s. When
the rad io station has b een suc c essfully reg istered , the d isp lay will
flash the c orresp ond ing rad io freq uenc y on and off onc e.
NOTE Each preset button can be used to store both an FM station
and an AM station. If the power supply is interrupted by disconnection of the bat-
tery, memory presets will be cleared and will be required to be re-input. Weather band button (WB)
Push the “WB ” b utton when the rad io is off to turn on the rad io in the
weather b and .
Press the “WB ” b utton when the rad io is on to selec t the weather
b and .