2001 SUBARU IMPREZA key

Starting and operating7-11
–
CONTINUED –
Ignition switch
WARNING
Never turn the ignition switch to “LOCK” while the vehicle is be-
ing driven or towed because that will lock the steering wheel, pre- venting steering control. And when the engine is turned off, it
takes a much greater effort than usual to steer.
The ig nition switc h has four p ositions: LOCK, ACC, ON and START.
HS0122
LOCK
The key c an only b e inserted or removed in this p os ition. The ig nition
switc h will loc k the steering wheel when you remove the key.
If turning the key is d iffic ult, turn the steering wheel slig htly to the rig ht
and left as you turn the key.

7-12n
Automatic transmission vehicles
HG0101
HS0123
The key c an b e turned from “ACC ” to “LOCK ” only when the selec tor
lever is in the “P ” p osition.
n Manual transmission vehicles
OM-H0144
1
2
The key c an b e turned from “ACC ” to “LOCK ” only when the key is
p ushed in while turning it. ACC
In this p osition the elec tric al ac c essories (rad io, ac c essory soc ket,
etc .) c an b e used . ON
This is the normal op erating p osition after the eng ine is started .

Starting and operating7-13
–
CONTINUED –

START CAUTION
Do not turn the ignition switch to the “START” position while the
engine is running.
The eng ine is started in this p osition. The starter c ranks the eng ine to
start it. When the key is released (after the eng in e has started ), the
key automatic ally returns to the “ON ” p osition.
Key reminder chime
The remind er c hime sound s when the d river ’s d oor op ens and the key is
in the “LOCK ” or “ACC ” p ositions. The c hime stop s when the key is re-
moved from the ig nition switc h.
Key interlock release (AT vehicles only)
If the key c an not b e turned to the “LOCK ” p osition even when the selec -
tor lever is in the “P ” p osition:
HS0127
HS0126
Vehicle front
Release lever
1. Take out the sc rewd river from the tool b ag .
2. Remove three sc rews sec uring the und erc over of th e steering c ol-
umn.
3. Remove the und erc over of the steering c olumn.
4. Turn the ig nition key while p ressing the key inte rloc k release lever.
Take your vehic le to the nearest SUBARU d ealer imme d iately to have the
key interloc k system rep aired .

7-14Starting the engine
CAUTION
Do not operate the starter motor continuously for more than ten
seconds. If the engine fails to start after operating the starter forfive to ten seconds, wait for ten seconds or more before tryingagain.
Manual transmission vehicles
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Press the c lutc h p ed al to the floor and shift the shift lever into neu-
tral. Hold the c lutc h p ed al to the floor while star ting the eng ine. The
starter motor will only op erate when the c lutc h p ed al is p ressed fully
to the floor.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (c hap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without d ep ressing
the ac c elerator p ed al. Release the key immed iately after the eng ine
has started .
If the eng ine d oes not start within ten sec ond s, wa it a while and then
turn the ig nition switc h to the “START ” p osition ag ain while d ep ressing
the ac c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one off after the
eng ine has started . The fuel injec tion system autom atic ally lowers the
id le sp eed as the eng ine warms up . Automatic transmission vehicles CAUTION
If you restart the engine while the vehicle is moving, shift the se- lector lever into the “N” position. Do not attempt to place the se-
lector lever of a moving vehicle into the “P” position.

Starting and operating7-15
–
CONTINUED –
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Shift the selec tor lever to the
“P ” or “N ” p osition (p referab ly “P ”
p osition).
The starter will only op erate when the selec t lever is at the “P ” or “N ”
p osition.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (c hap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without depress-
ing the accelerator pedal . Release the key immed iately after the en-
g ine has started .
If the eng ine d oes not start within ten sec ond s, wa it a while and then
turn the ig nition switc h to the “START ” p osition ag ain while d ep ressing
the ac c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one out after
the eng ine has started . The fuel injec tion system a utomatic ally lowers
the id le sp eed as the eng ine warms up .
While the eng ine is warming up , make sure that the selec tor lever is at
the “P ” or “N ” p osition and that the p arking b rake is ap p lied .
During cold weather below – 4F ( – 20 C)
If the eng ine is d iffic ult to start using the norma l method (without d e-
p ressing the ac c elerator p ed al), turn the ig nition switc h to the
“ START ” p osition while slig htly d ep ressing the ac c elerator p ed al.
Flooded engine
If the eng ine d oes not start, it may b e flood ed (ex c essive fuel in the
eng ine).
In c ase of a flood ed eng ine, turn the starter motor for five sec ond s
with the ac c elerator p ed al fully d ep ressed . Rep eat this two or three
times until the eng ine starts. Release the ig nition switc h and ac c elera-
tor p ed al as soon as the eng ine starts.

10-4
Always use the proper tools and make certain that they are
well maintained. Never get under the vehicle supported only by jack. Always
use a safety stands to support the vehicle. Never keep the engine running in a poorly ventilated area,
such as a garage or other closed areas. Do not smoke or allow open flames around the fuel or battery.
This will cause a fire. Wear adequate eye protection to guard against getting oil or
other fluids in your eyes. If something does get in your eyes,
thoroughly wash it out with clean water. Because the fuel system is under pressure, replacement of the
fuel filter should be performed only by your SUBARU dealer. The SRS airbag has no user-serviceable parts. Tampering with
or disconnecting the system ’s wiring could result in accidental
inflation of the airbag or could make the system inoperative,
which may result in serious injury. The wiring harnesses of theSRS airbag system are covered with yellow insulation and the
connectors of the system are yellow, for easy identification. Donot use electrical test equipment on any circuit related to the SRSairbag system. For required servicing of the SRS airbag, see your
nearest SUBARU dealer. Before checking or servicing in the engine compart- ment
Always stop the engine and set the parking brake firmly to pre-
vent the vehicle from moving. Always let the engine cool down. Engine parts become very
hot when the engine is running and remain hot for some time af-ter the engine is stopped. Do not spill engine oil, engine coolant, brake fluid or any other
fluid on hot engine components. This may cause a fire. Always remove the key from the ignition switch. When the
ignition switch is in the “ON” position, the cooling fan may oper-
ate suddenly even when the engine is stopped.