2001 SUBARU IMPREZA key

1-8
Keyless entry system (if equipped)
CAUTION
Do not expose the transmitter to severe shocks, such as those
experienced as a result of dropping or throwing. Do not take the transmitter apart except when replacing the
battery. Do not get the transmitter wet. If it gets wet, wipe it dry with a
cloth immediately. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept anyinterference received, including interference that may causeundesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user ’s authority to
operate the equipment.
The keyless entry system has the following func tion s.
Loc king and unloc king the d oors (and rear g ate on t he wag on and
OUTBACK SPORT) without a key Arming and d isarming the sec urity system (if your v ehic le is eq uip p ed
with an op tional sec urity system). See the next sec tion “Sec urity system
(if eq uip p ed ) ” for d etailed information.
The rec eiver insid e your vehic le ’s keyless entry system and the remote
c ontrol transmitters are d esig ned tog ether to have an averag e op erating
rang e of 25 to 50 feet (8 to 15 meters) d uring id ea l c ond itions. Althoug h
at times you may exp erienc e rang e g reater than that , there may b e oc c a-
sions when rang e is less than normal. Atmosp heric c ond itions or interfer-
enc e from other RF-emitting d evic es c an effec tively red uc e transmitter
rang e.

Doors and locks1-9
–
CONTINUED –

System operation
Keyless entry func tions d o not op erate when vehic le ig nition is “ON ”.
HS1000BB
n Locking the doors
Press the “LOCK ” b utton to loc k all d oors (and the rear g ate on the
wag on and OUTBACK SPORT). The p arking lig hts will f lash one time.
n Unlocking the doors
To unloc k the d river ’s d oor only, p ress and release the “UNLOCK ” b ut-
ton.
To unloc k all d oors (and the rear g ate on the wag on and OUTBACK
SPORT), p ress and hold the “UNLOCK ” b utton.
The p arking lig hts will flash one time.
The vehic le ’s interior (c ourtesy) lig ht will illuminate for 60 sec ond s or
until vehic le is started .
NOTE
1. Parking lights will flash when the vehicle ’s battery is discon-
nected and reconnected.
To stop lights from flashing, either: Press remote transmitter “UNLOCK” button once.
Turn the ignition switch to the “ON” position and press pro-
gramming button for one second (see location below).
2. The vehicle ’s interior (courtesy) light and door open warning
light (DOOR AJAR indicator) will illuminate for 60 seconds when
the ignition is turned off, or until the doors are locked with the

1-10remote transmitter.
3. The instrument panel lights will flash when the parking lightsflash.
4. Your SUBARU Keyless Entry System is equipped with tworemote transmitters.
Programming button location
HS1001BB
The Programming Button is located under the driver ’s side dash
beneath the diagnostic connector. Adding or deleting remote transmitters
Up to four (4) transmitters c an b e p rog rammed to yo ur keyless entry
system. NOTE
Make sure no one else is operating another keyless entry or security system within range of your vehicle when you are pro-gramming remote transmitters. Another transmitter code couldbe inadvertently “learned” by your system, allowing someone
unauthorized access to your vehicle. n To program an additional transmitter
1. Op en the d river ’s d oor.
2. Turn the vehic le ig nition to the “ON ” p osition.
3. Press and hold the Prog ramming b utton in. After ap p roximately 15 sec ond s, the d oor loc ks will c yc le 3 times.

Doors and locks1-11
–
CONTINUED –
This ind ic ates that the system is in the Transmitte
r Prog ramming
Mod e. Do not release the Programming button.
4. Press the “LOCK ” b utton on the new transmitter. The d oor loc ks will
c yc le onc e.
5. Rep eat step 4 for any ad d itional transmitters.
6. Exit the Transmitter Prog ram Mod e b y releasing th e Prog ramming
b utton and turning the vehic le ig nition off. Test a ll remote transmitters
to ensure that they work p rop erly. n To delete a lost or stolen transmitter
1. Follow step 1 to 3 as d esc rib ed ab ove.
2. Re-p rog ram the remaining transmitters as d esc rib e d in step 4.
If there is only one remaining transmitter, p erform step 4 four
times .
If there are two remaining transmitters, p erform st ep 4 twice for
eac h transmitter. System maintenance
Your keyless entry system d oes not req uire any sp ec ific maintenanc e
exc ep t for oc c asionally c hang ing the transmitter b a ttery. The 12-volt
b attery in the remote transmitter should last ap p ro ximately one year,
d ep end ing on usag e. When the b attery b eg ins to weak en, you will
notic e a d ec rease in rang e, or the d istanc e from yo ur vehic le that the
remote transmitter will op erate. n To change the remote transmitter battery CAUTION
Do not let dust, oil or water get on or in the transmitter when
replacing the battery.

1-14The sec urity system c an b e p rog rammed to op erate wi
th one to four
remote transmitters. Eac h transmitter is p owered b y an internal 12-volt
alkaline b attery. n The status indicator/Valet button
HS1004BB
The Status Ind ic ator is a hig h intensity warning li g ht, loc ated on the
d ash to the left of the steering wheel. The Status Ind ic ator d isp lays a
visual ind ic ation of the sec urity system ’s status while c reating a p ow-
erful theft d eterrent. LED status Off: System is d isarmed .
Double-Flash: System is in valet mod e.
Steady Flash: System is armed .
Fast Flash: System has b een trig g ered .
On: System is in p re-arm state (and will arm when all d oors are
c losed ). n The valet button (built into the status indicator)
The Valet Button is used to eng ag e Valet Mode (see “Valet mod e ”
Sec tion). In Valet Mod e, the sec urity system will n ot arm, throug h the
siren will c hirp and keyless entry features will fu nc tion when the sec u-
rity system is d isarmed .

Doors and locks1-15
–
CONTINUED –
n
The emergency override/programming button
HS1001BC
The Emerg enc y Overrid e/Prog ramming b utton is used t o d isarm the
alarm system in c ase of a lost or b roken transmitte r. It is also used in
c onjunc tion with the transmitter and vehic le ig niti on to p rog ram ad d i-
tional transmitters. The Emergency Override Button is located under the driver ’s side
dash beneath the diagnostic connector. Security system operation
IMPORTANT Security System and Keyless Entry Features Do Not Operate
when the Vehicle Ignition is on.

1-18n
Personal protection alarm (Panic)
HS1000BC
Pressing b oth b uttons tog ether on the remote transm itter ac tivates the
Panic feature, sound ing the siren and flashing the p arking lig hts.
Panic is d esig ned to b ring attention to the vehic le and surround ing
area. Press either b utton on the transmitter to tur n off the Panic alarm.
n Disarming the security system in the event of a lost or broken transmitter
HS1001CB
If your remote transmitter fails to op erate, the sy stem c an b e d is-
armed using the Emerg enc y Overrid e/Prog ramming b utt on. Follow
the p roc ed ure b elow:
1. Enter the vehic le. The alarm will sound when the d oor is op ened .
2. Insert the ig nition key and turn to the “ON ” p osition.

Doors and locks1-19
–
CONTINUED –
3. Press the Emerg enc y Overrid e/Prog ramming b utton.
The system
will d isarm. n Valet mode
HS1004CB
Valet Mod e p revents the sec urity system from arming , yet allows all
keyless entry and c onvenienc e features to func tion normally.
The valet b utton is b uilt into the status ind ic ator , loc ated on the d ash
to the left of the steering wheel.
To eng ag e Valet Mod e: With the system d isarmed and the vehic le ig nition o ff, p ress the
Status Ind ic ator/Valet Button. The status ind ic ator will b eg in to emit a q uic k d ou b le-flash p attern.
This ind ic ates that the system is in Valet Mod e. To exit Valet Mod e, p ress the Status Ind ic ator/Vale t Button ag ain.
The status ind ic ator will turn off, ind ic ating the system is in normal
op erating mod e. n Trip identification
If the siren c hirp s four times when you d isarm your sec urity system,
this ind ic ates that the system was trig g ered in you r ab senc e. Before
turning the ig nition on, p erform the following op er ation to d etermine
the p rotec ted zone that trig g ered the system. Op en the vehic le d oor and p ress the Emerg enc y Overr id e/Pro-
g ramming b utton.