2001 SUBARU IMPREZA trunk

Starting and operating7-47
–
CONTINUED –
Loading your vehicle
WARNING
Never allow passengers to ride on the folded rear seatback in
the trunk or in the cargo area. Doing so may result in serious in-
jury. Never stack luggage or other cargo higher than the top of the
seatback because it could tumble forward and injure passengersin the event of a sudden stop or accident. Keep luggage or cargo
low, as close to the floor as possible. When you carry something inside the vehicle, secure it when-
ever you can to prevent it from being thrown around inside the
vehicle during sudden stops, sharp turns or in an accident. Do not pile heavy loads on the roof. These loads raise the
vehicle’ s center of gravity and make it more prone to tip over.
Secure skis and other lengthy items properly to prevent them
from shooting forward and causing serious injury during a sud-den stop. Never exceed the maximum load limit. If you do, some parts on
your vehicle can break, or it can change the way your vehicle
handles. This could result in loss of control and cause personal
injury. Also, overloading can shorten the life of your vehicle. Do not place anything on the rear shelf behind the rear seat-
back (for sedan and coupe) or the extended luggage cover (for
wagon and OUTBACK SPORT). Such items could tumble forward
in the event of a sudden stop or a collision. This could cause
serious injury.
CAUTION
Do not carry spray cans, containers with flammable or corrosiveliquids or any other dangerous items inside the vehicle.
NOTE
For better fuel economy, do not carry unneeded cargo.

In case of emergency8-13
–
CONTINUED –

Tire changing tools Spare tire
OM-H0175
HG0034
The sp are tire is stored und er the floor of the tru nk or the c arg o area.
To remove the sp are tire, first remove the sp are ti re c over, turn the at-
tac hing b olt c ounterc loc kwise, then take the sp are tire out.
Jack and jack handle
HG0193
HG0107OM-H0176
The jac k is stored on the left sid e of the trunk or c arg o area.
To take out the jac k, first p ull the tab on the tri m c over d own to op en
the c over, turn the jac ksc rew c ounterc loc kwise to l oosen it, then re-
move the jac k.
The jac k hand le is stored und er the sp are tire c ove r.

Appearance care9-5
–
CONTINUED –
d ealer to p erform this kind of maintenanc e and trea
tment if you need
assistanc e.
Rep air c hip s and sc ratc hes in the p aint as soon as you find them.
Chec k the interior of the vehic le for water and d ir t ac c umulation und er
the floor mats b ec ause that c ould c ause c orrosion. Oc c asionally
c hec k und er the mats to make sure the area is d ry.
Keep your g arag e d ry. Do not p ark your vehic le in a d amp , p oorly
ventilated g arag e. In suc h a g arag e, c orrosion c an b e c aused b y
d amp ness. If you wash the vehic le in the g arag e or p ut the vehic le
into the g arag e when wet or c overed with snow, that c an c ause
d amp ness.
If your vehic le is op erated in c old weather and /or in areas where road
salts and other c orrosive materials are used , the d oor hing es and
loc ks, trunk lid loc k, and hood latc h should b e ins p ec ted and lub ri-
c ated p eriod ic ally.
Cleaning aluminum wheels Promp tly wip e the aluminum wheels c lean of any kind of g rime or
ag ent. If d irt is left on too long , it may b e d iffi c ult to c lean off.
Do not use soap c ontaining g rit to c lean the wheels . Be sure to use a
neutral c leaning ag ent, and later rinse thoroug hly with water. Do not
c lean the wheels with a stiff b rush or exp ose them to a hig h-sp eed wash-
ing d evic e. Clean the vehic le (inc lud ing the aluminum wheels) w ith water as soon
as p ossib le when it has b een sp lashed with sea wate r, exp osed to sea
b reezes, or d riven on road s treated with salt or ot her ag ents.

Maintenance and service10-53
–
CONTINUED –

Rear combination lights Sedan and Coupe
OM-H0446
HG0241
1. Remove the sp are tire c over.
2. Remove the c lip from the rear trunk trim with a r eg ular sc rew d river.
3. Remove the nut sec uring the rear trunk trim.
OM-H0447
4. Op en the rear p ortion of the sid e trunk trim p ane l.
5. Remove the b ulb hold er from the rear c omb ination lig ht assemb ly
b y turning it c ounterc loc kwise.
6. Remove the b ulb from the soc ket b y p ushing it and turning c oun-
terc loc kwise. Install a new b ulb .
7. Set the b ulb hold er into the rear c omb ination lig ht assemb ly and
turn it c loc kwise until it loc ks.
8. Sec ure the rear trunk trim p anel with the nut and the c lip s.