2001 Peugeot Partner VU ABS

Rear fog lamp See ÒSIGNALLINGÓ.ABS system See ÒBRAKESÓ.Diesel engine preheating warning lamp
See ÒSTARTING THE ENGINEÓ.
Left direction indicators See ÒSIGNALLINGÓ.
Right direction indicatorsSee ÒSIGNALLINGÓ.
34I-15WARNING LAMPS *
All the direction indicator lights flash at the same time when the hazard warning signal is operated.
Dipped beam See ÒSIGNALLINGÓ. Main beamSee ÒSIGNALLINGÓ.
* According to specification or country

These warning lights are tested with the key in the ignition on position : M
64III-1STEERING LOCK-IGNITION-STARTER
¥ S : Steering lock
To release the steering lock, turn the steering wheel slightly, without forcing it, at the
same time as turning the key.
¥ A : Accessories Allows operation of some electrical accessories (radio, electric windows, map rea-
ders, etc.). The battery charge light comes on. ¥ M : Ignition
The following warning lamps * should illuminate : ABS, preheating (Diesel), battery
charge, STOP, oil pressure, handbrake and brake fluid level, engine autodiagnosis,airbags, door closing. If any of these warning lamps do not illuminate, there is a malfunction. ¥ D : Starter Release the key as soon as the engine has started. Never operate the key with the
engine running (see ÒSTARTING THE ENGINEÓ).
* According to model or country

ABS system*
This system increases safety by preventing the wheels from locking in the event of harsh braking or in conditions of poor grip. It enables the driver to maintain control of the steering.
The operating capacity of all the essential electrical elements of the ABS system is controlled by an electronic moni-
toring system both before and during driving. The ABS light comes on when the ignition is switched on, and should
go out after approximately two seconds. If the light does not go out, this indicates that the ABS is disconnected due
to a fault. Likewise, if the light comes on while driving, this indicates that the ABS is not operating. In both cases,
the normal braking system remains effective, as on a vehicle without ABS. However, to avoid the occurrence of other
faults with unknown consequences, the ABS should be inspected as soon as possible by an approved dealer.
It is still necessary to drive carefully on slippery surfaces (loose stones, snow, ice, etc.)..
67III-3BRAKES
Handbrake
The handbrake is operated by pulling the lever upwards. The greater the slope you are on, the greater the force that should be applied in pulling the
lever.
To ease the action of the handbrake lever, it is recommended that you press the brake pedal at the same time. As a precaution, 1st gear should be engaged in all cases. On steep slopes, you should also turn the wheels towards the kerb.
To release the handbrake, pressthe button while pulling the lever up, then
lower the lever to the fully down position.The warning light comes on if the handbrake is on or not fully released, with the ignition on.
* According to model or country.

70 A
60 A
50 A
40 A
20 A
30 A
25 A
20 A
15 A
10 A
5 A
FuseAmperageSupply type Functions protected
F5 20 A Battery +BSI
F6 30 A Battery +Free
F7 20 A Battery +Additional heating burner
F14 SHUNTBattery +Injection double relay
F18 10 A Front right hand main beam
F19 10 AFront left hand main beam
F20 10 A
Ignition onABS ECU
F21 5 A Battery + Additional heating relay
F22 20/30 A Battery +Diesel heating relay
F23 15 A Ignition onDiesel heater
F24 5 A Ignition onFree
F25 15 A Ignition onFuel pump
F26 SHUNTBattery +Double injection relay
F27 30 A Battery + Free
F28 5/10 A Ignition onThrottle housing heater (petrol)/
Injection pump (diesel)
F29 30 A Battery + Free
F30 10 A Battery +Front left hand fog lamp
F31 10 A Battery +Front right hand fog lamp
F32 5/10 AIgnition onInjection ECU
F33 15 A Ignition on Reverse lamps Ð Coolant level
Preheater unit Ð Cooling fan unit
F34 5 A Ignition on Exhaust sensor
Engine compartment fuses
Unclip the cover. The unnumbered fuses are spares. After repairs, reposition the cover
very carefully.
93
VI-1TABLE OF FUSES
(According to specification or country)
FUSE COLOUR CHART
Maxi-fuses Fuses

100
Number plate lamp Unscrew the translucent cover to gain access to the bulb. Additional brake lamp* (Third brake lamp) Remove the cover by pressing on the tab (round section) at the endof the lamp (in the direction of thearrows).
Pull the cover towards the rear.Remove the bulb holder by squee- zing the two tabs. Pull out the faulty bulb and change it.
To refit, proceed in the reverse
order. * Option depending on version.VI-4CHANGING BULBS

118VII-4
APPROVED RECOMMENDED
LUBRICANTS
The oils which appear in the sketch opposite are suitable for most pur-poses. The sketch opposite states the opti- mum range of viscosity depending onthe temperatures at which the oils areto be used. It is also possible to usesynthetic oils of Ôsuperior qualityÕ. In the absence of semi-synthetic or
synthetic oils, oils of API SH/SJ qual-ity (for petrol engines), or CD/CF (fordiesel engines) may be used by fol-
lowing the ÔArduous ConditionsÕ main-tenance schedule which specifiesshorter intervals. Do not hesitate to ask for advice from a Peugeot dealer to maintain drivingpleasure and to minimise the mainte-nance cost of your vehicle. For coun-tries outside Europe, please contact a
local PEUGEOT dealer.
PROCOR TM 108 /
Coolant GLYSANTIN G33 or REVKOGEL 2000
ESSENTIAL Protection to minus 35¡C
ESSENTIAL ESSENTIAL
Manual gearbox ESSO GEAR OIL BV TOTAL TRANSMISSION BV
75W-80 PR 9736.41 75W-80
Power steering ESSO ATF D - PR 9730.94 TOTAL FLUIDE AT42
Other approved products
Brake fluid PEUGEOT DOT4