2001 Peugeot Partner VU ignition

A
All lights switched off
37I-16SIGNALLING *
LIGHTING CONTROLS (Ring A)
Turn ring Ain the direction of the arrow.
Side lights
Your instrument panel lights.
Turn ring Ain the direction of the arrow.
Dipped beam / main beam
Pull the stalk fully towards you to switch between dipped beam/main beam. Lights on buzzer
It operates when a front door is opened with the ignition off, to indicate that the headlamps are still on. It stops when the door is closed, the headlamps
are switched off or if the ignition is switched on.
Timed illumination of the headlamps
Immediately after switching off ignition, pull the control stalk towards you : the headlamps will come on and then go out automatically after a minute.This will help you, for example, to find your way out of a poorly lit car-park. * According to specification.

AB
22
Manual windows
Turn the handle to raise or lower the windows. Electric windows* The switches
Aand Bon the fascia
are used to raise and lower the dri- ver's and passenger's windows(with ignition switched on and for 1
minute after ignition is switched off). One-touch control Press switch Ato raise or lower
the driver's window to the desired
position. To fully raise or lower the
driver's window, press the switchmore firmly and then release it. Ensure that children are clear of the windows before opening orclosing them. Side windows
To open the side windows, pull the
lever and push the window.
To close, pull then push the lever. CAUTION As a (child) safety measure, remove the ignition key whenleaving the vehicle, even for ashort period.I-11WINDOWS
* According to specification.

Fuel supply cut-off switch This switch is located under the bonnet on the right hand side
To restore the fuel supply after a cut-off, press the top of the switch as shown in the diagram.
87V- 4FUEL CUT-OFF SYSTEM*
If your vehicle is fitted with a device which cuts off the fuel supply, this provides additional safety in the majority or frontal or rear impacts.* According to specification or country.
Before switching the ignition on again,
make sure that there is no fuel leakage or smell of fuel.

These warning lights are tested with the key in the ignition on position : M
64III-1STEERING LOCK-IGNITION-STARTER
¥ S : Steering lock
To release the steering lock, turn the steering wheel slightly, without forcing it, at the
same time as turning the key.
¥ A : Accessories Allows operation of some electrical accessories (radio, electric windows, map rea-
ders, etc.). The battery charge light comes on. ¥ M : Ignition
The following warning lamps * should illuminate : ABS, preheating (Diesel), battery
charge, STOP, oil pressure, handbrake and brake fluid level, engine autodiagnosis,airbags, door closing. If any of these warning lamps do not illuminate, there is a malfunction. ¥ D : Starter Release the key as soon as the engine has started. Never operate the key with the
engine running (see ÒSTARTING THE ENGINEÓ).
* According to model or country

Steering lock SWith the key removed and the steering lock engaged, the steering is loc- ked; the lock will engage in a number of positions of the steering wheel.The key can only be removed in the Sposition.
A The steering lock is released (by turning the key to position A, turning the
steering wheel slightly, if necessary).
M Driving position.
D Starting position.
For starting and stopping the engine, see ÒSTARTING THE ENGINEÓ.
65III-1STEERING LOCK-IGNITION-STARTER
WARNING
Never remove the ignition key before the vehicle has come to a complete stop. Never attempt to move the
vehicle without the engine running. If the engine is not running, the vehicleÕs steering and braking systemswill not be power-assisted (there is a risk of the steering lock engaging and the safety features not opera-ting). After parking, remove the ignition key and turn the steering wheel until the steering column locking peg engages.

Check that the gear lever is in neutral.
PETROL ENGINEStarting with the engine cold. Do not press the accelerator pedal. Operate the starter until the engine starts (not more than ten seconds).In very low temperatures, press the clutch pedal when operating the starter to ease starting of the engine. Release
the clutch pedal slowly.
DIESEL ENGINEStarting with engine cold
Turn the ignition key to position M(ignition, preheater) and wait until the preheater warning light goes out. Then
operate the starter until the engine starts. In very low temperatures, press the clutch pedal when operating the starter to ease starting of the engine. Release
the clutch pedal slowly. Note : Do not press the accelerator pedal during starting.
Starting with engine hot
Operate the starter. If the engine fails to start at the first attempt, repeat using the preheater. In all cases, if the engine stops or fails to start at the first attempt, wait a few seconds before operating the starter again. Note : The preheater warning lamp does not come on when the engine is hot.
Recommendation : It is not necessary to warm up the engine before starting off. Wait for the warning lamp to go out and then drive
off slowly, accelerating gently until the engine warms up.
66III-2STARTING THE ENGINE
CAUTION
Do not run the engine in an enclosed or poorly ventilated space.

ABS system*
This system increases safety by preventing the wheels from locking in the event of harsh braking or in conditions of poor grip. It enables the driver to maintain control of the steering.
The operating capacity of all the essential electrical elements of the ABS system is controlled by an electronic moni-
toring system both before and during driving. The ABS light comes on when the ignition is switched on, and should
go out after approximately two seconds. If the light does not go out, this indicates that the ABS is disconnected due
to a fault. Likewise, if the light comes on while driving, this indicates that the ABS is not operating. In both cases,
the normal braking system remains effective, as on a vehicle without ABS. However, to avoid the occurrence of other
faults with unknown consequences, the ABS should be inspected as soon as possible by an approved dealer.
It is still necessary to drive carefully on slippery surfaces (loose stones, snow, ice, etc.)..
67III-3BRAKES
Handbrake
The handbrake is operated by pulling the lever upwards. The greater the slope you are on, the greater the force that should be applied in pulling the
lever.
To ease the action of the handbrake lever, it is recommended that you press the brake pedal at the same time. As a precaution, 1st gear should be engaged in all cases. On steep slopes, you should also turn the wheels towards the kerb.
To release the handbrake, pressthe button while pulling the lever up, then
lower the lever to the fully down position.The warning light comes on if the handbrake is on or not fully released, with the ignition on.
* According to model or country.

1
3
2
1
2
3
Reading lamps * These are on the roof console.
To switch them on, turn them to the left or the right.
The ÔoffÕ position is in the centre. Front courtesy light The light switch has three positions :1Off
2 Lighting controlled by the ope- ning of one of the front doors, by
removing the ignition key, or byunlocking using the plip.
3 Light permanently on Rear courtesy light The switch has three positions :1
Off
2 Lighting controlled by the ope- ning of one of the front doors, by
removing the ignition key, or byunlocking using the plip.
3 Light permanently on
The front and rear courtesy lightscan switch on when one of thevehicle doors is opened. Upper glovebox * When open, the cover serves as a tray with two cup holders and twopen holders. For safety reasons, remember to keep the glovebox closed whendriving.
75IV-3COMFORT *
* According to specification.