2001 Peugeot Partner VU tyre pressure

Refitting
1 - Fit the wheel onto the hub, making sure that it is correctly positioned.
2 - Screw in one of the wheel bolts without fully tightening it. Clip the wheel embellisher onto the bolt, then tightenthe three other bolts.
3 - Lower the jack and remove it.4 - Fully tighten the wheel bolts using the wheelbrace.5 - Refit the repaired wheel as soon as possible6 - Reset the tyre pressure of the repaired wheel (see ÒTYRESÓ) and have the balance checked. Replacing the spare wheel in the carrier Place the chock back in the wheel.
Slide the spare wheel back into its carrier.Lift the carrier and position the hook so that it is aligned with the tightening nut.Retighten the nut from inside the vehicle.Store the wheelbrace, and then the jack. Note The wheel bolts are specific to each wheel type. When a wheel is changed, check with an approved dealer that the
bolts are suitable for the new wheel (See ÒUSING THE SPARE WHEELÓ).
104 VI-5CHANGING A WHEEL

Towbar The installation of a towbar should be carried out by an approved dealer who will know the towing capacity of your
vehicle and have the necessary information on the fitting of such a safety related item. The dealer will also be aware
of any modifications to the vehicleÕs cooling system needed to cater for any arduous towing conditions.
Towing (boat, caravan, etc.)
¥ Before setting off :- check the tyre pressures of both the vehicle and the towed load and check the signalling lamps on the towed load.
- practise manoeuvring, especially reversing.
- regularly grease the towball hitch, remove it when not required.
¥ Spread the load inside the caravan and keep within the weight limits.
¥ Always drive at a moderate speed, Change down to a lower gear in good time before going uphill and downhill. Be aware of the effect of side winds.
¥ Towing increases fuel consumption.
¥ Braking distances are increased. Use the brakes gently and progressively. Avoid harsh braking.
¥ When parking on a slope: as well as following the instructions for operation of the handbrake, make sure that the towbar is properly locked and use wheel chocks if necessary.
106VI-7SAFETY ADVICE
Keep within the towing limits of your vehicle.
In the case of a towing vehicle exceeding its maximum rear axle weight or Gross Vehicle Weight, its speed limit is 60 mph (100 Km/h).
Towing weights: see ÒGENERALÓ.

108Pressure stated in barsTYRES *VI-8
Tyres 1.1i 1.4i
150C - 170C 170C - 190C
TUBELESS FRONT REAR SPARE FRONT REAR SPARE
MICHELIN 165/70 R14 81T MXT CU : 475 Kg2,4 2,6 2,8
MICHELIN 165/70 R14 89R XC4S
PIRELLI L6 165/70 R14 C 89R CU : 600 Kg 2,5 3,2 3,4 2,5 3,2 3,4
CU : 800 Kg 2,5 3,7 3,9
MICHELIN 175/65 R14 90T AGILIS 51 CU : 600 Kg 2,5 2,9 3,1 2,5 2,9 3,1
CU : 800 Kg 2,7 3,3 3,5
* Any other tyres are forbidden. Advice and Recommendations
For your safety, it is essential that the tyres are in good condition.
Ensure that the tyre pressures, including the spare, are maintained at the recommended pressures. They should be
checked regularly, once a month for example, and before every long journey. The pressures should only be checkedwhen the tyres are coldas pressure increases as the tyre temperature increases with driving.
Never reduce the pressure of a warm tyre.
Snow chains must only be fitted to the front wheels
* According to model or country.

109
Pressure stated in bars
VI-8TYRES *
* Any other tyres are forbidden.
* According to model or country.
Make sure that the tyres are always
in good condition and that the tyre pressures are always set correctly. Tyres 1.9 D 2.0 HDi
MICHELIN TUBELESS FRONT REAR SPARE FRONT REAR SPARE 165/70 R14 85R XC4S CU : 600 Kg 2,9 3,2 3,4
CU : 800 Kg 3 3,7 3,9
175/65 R14 AGILIS 51 CU : 600 Kg 2,5 2,9 3,1 2,5 2,9 3,1
CU : 800 Kg 2,7 3,3 3,5 2,7 3,3 3,5