Page 8 of 123
10YOUR AT A GLANCE
FRONT SEATS1 - Forwards/backwards
adjustment
Lift the control and slide the seat forwards or backwards.
2 - Access to rear seats Place your fingers in one ofthe handles and pushforwards to fold down the seatback and move the seatforwards. On repositioning,the seat returns to its originalposition.
3 - Head restraint Height adjustment:
- to lift the head restraint,push it upwards;
- to lower it, press the lug and slide downwards.
The setting is correct whenthe upper edge of the headrestraint is level with the topof the head.
To remove the head restraint, press the lug.
4 - Seat back angle adjustment Push the control towards the
rear.
5 - Driver's seat height adjustment
Pull the control upwards. Remove your weight from the seat to raise, or press on the
seat to lower.
62
Page 54 of 123

YOUR 206 CC IN DETAIL55
Ventilation 1 . Windscreen demisting or de-icing vents.
2 . Front window demisting or de-icing vents.
3 . Side vents.
4 . Centre vents.
5 . Air outlet to front footwells.
6 . Air outlet to rear footwells*.
Advice on operation
Ð Place the air flow control at a sufficient level to ensure correct renewal of air in the passenger compartment. The "OFF"
position cuts off all the air circulation in the passenger compartment. Note : only use the ''OFF''position occasionally (risk of condensation).
Ð Select the air distribution most suited to your requirements and the climatic conditions.
Ð Gradually adjust the temperature setting for your comfort.
Ð Position the outside air control to the left: the "Outside air" position.
Ð For perfectly even air distribution, take care not to obstruct the exterior air intake grille on the bonnet, the vents and the air ducts under the front seats. Check that the pollen filter is in good condition.
* According to specification.
Page 61 of 123
YOUR 206 CC IN DETAIL
62
The front seats
Page 62 of 123

YOUR 206 CC IN DETAIL63
1 - Forwards/backwards adjustment
Lift the lever and slide the seat forwards or backwards.
2 - Access to the rear seats Place your fingers in one of the twohandles and push towards the frontto fold down the seat backt andmove the seat forwards. When putback, the seat returns to its initialposition.It is impossible to access the rearseats if the front seat is in areclining position.
No person nor object mustprevent the seat from returningto its initial position. Returning tothis position is necessary for it tobe locked.
3 - Adjusting the height of the head restraint
To raise the head restraint, push it upwards.
The setting is correct when theupper edge of the head restraintis level with the top of the head.
The head restraint has a frame withnotches which prevents the headrestraint from dropping down (safetydevice in case of impact).
To lower the head restraint you must simultaneously:- press the knob on the left-hand side at its base,
- press downwards. The angle of the head restraint can also be adjusted.
To remove the head restraint, press the tab.
4 - Adjusting the seat back angle Push one of the two controls
towards the rear.
5 - Driver's seat height adjustment Pull the handle upwards. Remove your weight from the seat to raise, or press on the seat to
lower.
Never drive with the head restraints removed. Theseshould be correctly fittedand adjusted.
Page 63 of 123

YOUR 206 CC IN DETAIL
64
''Isofix'' mountings
Available on the front passenger seat, the Isofix mountings allow for fitting of aspecial child seat
, sold by PEUGEOT
dealers. The locks incorporated in the child seat fit onto the Isofix mountings and ensuresafe, reliable and fast assembly
.
In the front, the child seat must be fit-
ted in the "rear facing" position for chil-dren weighing less than 29lbs (13 kg):front seat as far forward as possibleso that the body of the child seat is incontact with or as close as possible to
the instrument panel. This positionthus limits movement of the child seatin the event of an accident. In exceptional cases, the child seat may be fitted in the 'forwards facing'position if the rear seats are alreadyoccupied by other children. In thiscase, use the Isofix mountings, thestrap and the seat belt and adjust the front passenger seat to the "mid-travel" position. In both cases it is imperative to disarm the passenger air bag. The special approved child seat is the
Isofix KIDDY seat. It can be used "rearfacing" from birth to 29 lbs (13 kg)and "forwards facing" from 20 to 40 lbs(9 to 18 kg). This seat can also be used on seats not fitted with Isofix mountings: buck-ling of the three-point seat belt is then
compulsory. Follow the instructions for fitting the child seat given in the instruc-tion booklet.
Page 64 of 123

YOUR 206 CC IN DETAIL65
CHILD SEATS Child safety was one of PEUGEOT's main concerns when designing your vehicle; however the safety of your children also depends on you.
For maximum safety, please observe the following precautions:
- All children under the age of 10 are required to travel in approved restraining devices*, suited to their weight, in the seats
fit-
ted with seat belts.
- front passenger seat*: children under the age of 10 must not be transported in the "forwards facing" position, unless the rear seats are already occupied by other children. In this case adjust the front passenger seat to the mid-position. The "rear fac -
ing" position is permitted when the air bag is disarmed.
After carrying out numerous tests, PEUGEOT recommends the following systems: Up to 18 months (to 29 lbs or 13 kg) "Ršmer Babysure": is installed with its back to the engine and secured with a three-point seat belt, on either the front or rea r
seat. In the front the passenger seat must be adjusted to the "mid-position".
From 9 months to 3 or 4 years (20 to 40 lbs or 9 to 18 kg) "Ršmer Prince": is fitted to the rear seat with a three-point seat belt.For the safety of your children, the seat and the restraining cushion must never be separated.
From 3 to 6 years (33 to 55 lbs or 15 to 25 kg) "Ršmer Vario": is fitted to the rear seat with a three-point seat belt.
1
2
3
Page 65 of 123

YOUR 206 CC IN DETAIL
66
From 3 to 10 years (33 to 80 lbs or 15 to 36 kg)
''Recaro Start': is fitted to the rear seat with a three-point seat belt. The seat height, width and length must be adjusted depending on the age andbuild of your child. "Klippan Optima": is fitted to the rear seat with a three-point seat belt. From the age of 6 years (approximately 49 lbs or 22 kgs), only the booster seatis used.
Make sure you fasten the three-point seat belts or the child seat straps so that theslack in relation to the child's body is kept to a minimum, even for short journeys.
* According to current legal requirements.Never leave a child or an animal in a vehicle expo-sed to the sun, with thewindows closed.
Never leave the keys within reach
of children inside the car. Strap children into their child seats even on short journeys. Observe the precautions concer- ning the passenger air bag. Observe strictly the recommenda- tions for fitting and fastening thechild seat straps as detailed in theinstructions.4
5
Page 66 of 123

YOUR 206 CC IN DETAIL67
Seat belts
To lock the seat belts Pull the strap, then insert the buckle into the stalk.Pre-tensioning and force-limitingfront seat belts Safety in the event of a frontal impact has been improved by the introductionof pre-tensioning and force-limitingfront seat belts. Depending on theseriousness of the impact, the pre-ten-sioning system instantly tightens theseat belts firmly against the body ofthe occupant. The pre-tensioning seat belts are armed when the ignition is on. The force-limiting device reduces the pressure of the seat belt against theoccupant's body in the event of anaccident. Rear seat belts The rear seats are fitted with two three-point inertia reel seatbelts.
To be effective, a seat belt must be tightened asclose to the body as pos-sible.
Depending on the nature and theseriousness of the impact, the pre-tensioners may be triggeredbefore and independently of trig-gering of the air bags. In all cases, the air bag warning light on the instrument panelcomes on. Following a collision, have the sys- tem checked by a PEUGEOT
dealer. The system has been designed to be fully operational for ten years. Have it replaced after this period.