2001 MAZDA MODEL PROTÉGÉ lock

ln Cas€ ofan Emergency
ffiffi
AcluuoN
Always replace a fuse with one of the
same rating. Otherwise you may
damage the electric system.
.{. lnspect it and replace ifit blown.
5. Push in anew fuse of the same rating,
and make sure it fits tightly. If it
doesn't, have an Authorized Mazda
Dealer insiall it.
If you have no spare fuses, borrow one of
the same rating from a circuit not
essential to vehicle operation. such as the
RADIO c;cuit.
If the headlights or other electrical
componenls don work and lhe iuses in
the cabin are OK. inspect rhe fuse block
under the hood.Ifafuse is blown, il must
be replaced. Follow th€se steps:
1. Tum off the ignition switch and all
2. To remove the fuse btock cover,
unhook it a:rd lift up on tbe side with
dle tab.
6-7

ID Case of an Emergency
€
W
3. Ifa fuse is blown, replace it with a
new one of the srune rating.
When replacing the 100A fuse:
l. Turn off the ignilion switch.
2. Renove the negative baatery terminal.
3. Remove nuts A and B.
zl. Lift fte fuse block and remove the C
bolts-
5. Replace the fuse with a new one of the
same mting.
6. Install in the reverse order of removal.
6.8

In Case of an Emergency
I Fuse Panel DescriDtion
tr88
E80
HBE
HEE
HEE
F'H
EE
E
V Fuse block (Engin€ compartment)
DESCRIPTIONFUSDRA1.INGPROTECIED COMPONDNT
HEATER
2(ABS)For pmrection of vanons ci(uirs*
lIC KEYlor pole.lio of veious cimiB
5(CLOw)
6
COOLINC30A
BTNInlerior lights, Power dooi lock+
9Addrtronrl rool,ng lan for r'r rondirion.r'
INJORFIP
(r'JC)
(sTsrc)
HORN
TAIL
(HEADC U)Foi piote.rion of vfjos c;cuits
(FOC)For protecion of vdious cncuns
'sune nodek. 6-9

In Cas€ ofan Emerg€ncy
V To rcmove thejack
Turn the wing bolt counterclockwise.
V To secure the jack
Perform the remoyal proc€dure in
V To remove the spare tire
Tum the tire hold-down bolt
counterclockwise wift dre lug wrench.
6-15

In Case of an Emergency
I . Park on a level surface off the
right of,way and firmly set theparking brake.
2. Pul avehicle with an automatic
transaxle in pa.k (P), a manual
transaxle in reverse (R), and turn off
3. Tum on the hazard warning flasher
4. Have everyone getoutofthe vehicle
and away from the vebicle and traffic.
5. Remove lhejack,jack handle,lug
lvrench, and spare rire.
6. Block the wheel diagonally opposite
the flat tire. When blocking a front
wheel, place the block in fronr of rhe
tire. When blocking a rear wheel,
place the block behind the tire.
7. Pry off the wheel cover* with the
beveled end of the lug wrench.
NOTE
Force the end of the wrench firmly
between wheel and cover, or removal
will be difficult.
Ac.rurroN
Wlen installing the wheel covet
align the norch wiih the tire valve.
/..uJ
/n\
vl-
D
Qla
*so...od.h. 6-17

In Case of aD Emergency
8. Loosen $e lug nuts by turning them
counterclockwise one tum each. but
don't remove any until ihe tire has
been raised off the groud.
9. Place tbe jack under the jacking
position closest io tbe tire being
cbanged.
Awtnvme
I nc orrc ct.l ackin g P osition :
Attenptilg tojack the rehicle in
positions other than those
nconne ded inthk Iu ual is
dansenus. The rehicle couu slip off
thejack and senoustr injure or even
kill someone. Use onlr the front and
rcarjacking positioN recomme ded
A waRlrnsc
Inuapcr,latk
Using a jack that isn't desiened foryo r Mazda codd be dengercus. The
rehick coua snp olf the jack a d
seiouslr inj rc someone. Use o lt
thejack ptovided dth rou Mozda.
6-18

ln Case of an Em€rgency
A wLR.nrnyc
Pla.ing Objects Under the .Iack:
J.ckins the vehicte iith an object
u derthejack it dangerous. Thejack coutd sup a d soneone coud be
senousl! injured br the jack or the
fathns vehicte. Nert place objects
''-^,/A)
@
10. Insenthejack handle into thejack
and turn ir clockwise until the tirejust clears the ground, less than 25
rnm (l in). Betore removins the lug
nuts, make sure your Mazda is fimly
in position and thal it cannot dip or
11. Remove the lug nuts by turning rhem
counterclockwise; then remoYe the
12. Mount ihe spare tire.
13. Install the lug nurs with the beveled
edge inward; tighten them by hand.
14. Tum the jack handle
counterclockwise and lower the
vehicle. Use the lug wrench to
iighten lhe nuis in the order shown.
If you're unsure of how lighl the nuN
should be, have them inspected at a
service station. The specified torque
is 9010 120 N.m (9.0 to 12.0 kgf.rn.
65 ro 87 ft.lbo.
6-19

ln Cas€ ofsn Emergency
,6
(@).:)F ri'e (rame
I Locking Lug Nuts*
Ifyour vehicle has optional antitheft
wheel lug nuas, one on each wheel will
lock and you must use a special key to
unlock them. This key is attached to the
lug wrench and is stored with the spare
lire. Regisler ihem with the lock
nanufaclurer by filling out lhe card
provided in rbe glove box and mailing it
in the accompanying envelope. If you
lose your key, consult an Authorized
Mazda Dealer or use tle lock
manufacturer's order form, which is widr
lhe registration card.
d--Gffi
15. Store the damaged tire, using the
convenlional tire hold-down bolt
supplied in (he tool bag 1() hold ir in
place. Tum the tir€ clarnp upside
down liom ahe temporary spare tire
position. Repair the damaged tire and
replace ihe spare with it as soon as
possible.
V Tb rcmove an antith€ft lug nut
L Get the key for the locking lug nut.
2. Place it on top of the nut, and be sure
to hold the key square to it. If you hold
the key at an angle, you may damage
both key and nut. Don't us€ apower
3. Place the lug wrench on top ofthe key
and apply pressure. Tum the wrench
counterclockwise.
NOTE
To prevent $ejack,jack handle, and
tool bag from rattling, store them
properly.
.soD€ modeh. 6-21